Effects of inner sleeves on the inner frictional resistance of open-ended piles driven into sand

In open-ended piles, inner friction is developed between inner pile shaf and the inner soil. Inner frictional resistance depends largely on the degree of soil plugging, which is influenced by many factors including pile diameter, relative density and end conditions of piles. In this paper, effects of inner sleeves on inner frictional resistance are discussed. The experiments were conducted on a medium-dense sandy ground using laboratory-scale piles. It was observed that the piles penetrated under partially-plugged or unplugged state. The results suggest that inner fiictional resistance, Qin increases with sleeve height, l linearly and requires 2D （D is pile outer diameter） of l to produce a large as 50% of Qt by Qin （Qt is total resistance）. The results also indicate that bearing capacity increases with wall thickness at the pile tip, which can be attributed to the increase in annular area. The results also indicate that soil plug height is independent of sleeve height. The results also reveal that the penetration of straight piles is closer to unplugged state than the sleeved piles. The results of incremental filling ratio and plug length ratio also indicate that the degree of soil plugging is affected by the sleeve height.

Degradation Behaviour Analysis of SMA Aggregate and Skeleton

Based on laboratory tests and field materials evaluation, the inner frictional resistance of SMA skeleton was investigated and then the degradation behaviour of SMA skeleton was characterized for recycling purpose. Inner frictional resistance test was designed to investigate the skeleton characteristics of SMA aggregate mixture. The experimental results indicate that SMA skeleton has much stronger inner frictional resistance than AC skeleton, and coarse aggregates provide main contributions to the inner frictional resistance of SMA skeleton. Crushing test and superpave gyratory compactor （SGC） test were designed to reveal the degradation behaviour of SMA skeleton. To verify the laboratory characterization, field materials were also evaluated. The results indicate that the degradation of SMA skeleton is not random but has fixed internal trend, especially the 4.75mm aggregate plays a key role in the graded aggregates. Based on the testing results, it can be concluded that long-term repeated loading can cause degradation of SMA skeleton. However, the gradation does not keep deteriorating under repeated loading. When the inner frictional resistance is small enough, outside pressure will cause flow deformation of skeleton instead of degradation. Thus, well-designed SMA aggregate mixture is valuable for recycling after long-term in service. And it is important to restore the skeleton, especially the coarse aggregate part.