Influences of water treatment agents on oil-water interfacial properties of oilfield produced water

The emulsion stability of oilfield produced water is related to the oil-water interfacial film strength and the zeta potential of the oil droplets. We investigated the effects of water treatment agents （corrosion inhibitor SL-2, scale inhibitor HEDP, germicide 1227, and flocculant polyaluminium chloride PAC） on the stability of oilfield produced water. The influence of these treatment agents on oil-water interfacial properties and the mechanism of these agents acting on the oilfield produced water were studied by measuring the interfacial shear viscosity, interfacial tension and zeta electric potential. The results indicated that the scale inhibitor HEDP could increase the oil-water interfacial film strength, and it could also increase the absolute value of the zeta potential of oil droplets. HEDP played an important role in the stability of the emulsion. Polyaluminum chloride （PAC） reduced the stability of the emulsion by considerably decreasing the absolute value of the zeta potential of oil droplets. Corrosion inhibitor SL-2 and germicide 1227 could decrease the oil-water interfacial tension, whereas they had little influence on oil-water interfacial shear viscosity and oil-water interfacial electricity properties.

Determination of interfacial adhesive properties for polymeric film by blister test

The interfacial adhesive properties ofpolypropylene/stainless steel were studied by the blister test. The polypropylene film with a squared free-standing window was pressured by oil from one side of film. The corresponding deformation field was observed by a digital speckle correlation method. The experimental results show that the squared film deforms and debonds from stainless steel with the increase of pressure. The debonding of the squared film in initiates from the center of edge and extends to the comer, and then the deformation of film evolves from square to circle shape. The interfacial adhesive energy of polypropylene/stainless steel is （22.60±1.55） J/m2, which is in agreement with that measured by film with a circular window.

Structure and Dynamics of Ethanol Adsorbed on a Mica Surface

The structural and dynamic properties of nanoscale ethanol film on a mica surface are investigated via molecular dynamics simulations. We observe a dense, almost fiat ethanol bilayer formed in the vicinity of the mica surface, with the hydrophobic alkyl groups pointing outward from the surface. Remarkably, such ethanol bilayer is laterally well-ordered with patterned adsorption sites. Each ethanol molecule in the first layer donates one hydrogen bond to the surface basal oxygen atoms and accepts one hydrogen bond from that in the second layer. The ethanol molecules within the bilayer exhibit constrained lateral mobility and delayed dynamics as compared with bulk ethanol, whereas those on top of the bilayer have bulk-like characteristics.

Solid-Liquid State Bonding of Si3N4 Ceramics with Ceramic-Modified Brazing Alloy

Solid-liquid state bonding of Si3N4 ceramics with TiN-modified Ag-Cu-Ti brazing alloy was used'- to enhance joint strength. The effects of the TiN particles on the microstructures, interfacial reactions, and room-temperature properties of the joints were investigated. The results show that the TiN particles are gen- erally well dispersed in the Ag-Cu eutectic base and the interface between them is both clean and com-pact. Changes in the TiN volume fractions from 0 to 20% exert no noticeable effect on the interfacial reac-tion between Ag-Cu-Ti and the substrates. Other bonding parameters being constant, the TiN volume frac-tion in the filler material plays a key role in the joint properties. For TiN volume fractions below 20%, the joints are reinforced, especially joints with 5% and 20% TiN. The average shearing strength of joints with 5% TiN is 200.8 MPa, 30% higher than that of joints with no TiN (154.1 MPa). However, for TiN volumes frac- tions above 20%, the joint strengths decrease.