Laser shaping and optical power limiting of pulsed Laguerre–Gaussian laser beams of high-order radial modes in fullerene C60

We study the strong nonlinear optical dynamics of nanosecond pulsed Laguerre–Gaussian laser beams of high-order radial modes with zero orbital angular momentum propagating in the fullerene C60molecular medium. It is found that the spatiotemporal profile of the incident pulsed Laguerre–Gaussian laser beam is strongly reshaped during its propagation in the C60molecular medium. The centrosymmetric temporal profile of the incident pulse gradually evolves into a noncentrosymmetric meniscus shape, and the on-axis pulse duration is clearly depressed. Furthermore, the field intensity is distinctly attenuated due to the field-intensity-dependent reverse saturable absorption, and clear optical power limiting behavior is observed for different orders of the input pulsed Laguerre–Gaussian laser beams before the takeover of the saturation effect;the lower the order of the Laguerre–Gaussian beam, the lower the energy transmittance.

Optical power limiting of ultrashort hyper-Gaussian pulses in cascade three-level system

Propagation of strong femtosecond hyper-Gaussian pulses in a cascade three-level molecular system is studied by solving numerically the Maxwell–Bloch equations by the iterative predictor-corrector finite-difference time-domain method.Optical power limiting behavior induced by strong nonlinear two-photon absorption is observed for different orders of the femtosecond hyper-Gaussian pulses. Pulses of a higher order temporal profile are found to have a wider power range of optical limiting but a larger output saturation intensity. Both the output saturation value and the damage threshold of optical power limiting decrease with pulse duration increasing. The decrease of the pulse area along the pulse propagation is much slower than that obtained from the two-photon area theorem due to invalidity of the slowly varying amplitude approximation and the monochromatic field hypothesis.

Thiophene-fluorene derivatives with high three-photon absorption activities and their application to optical power limiting

The three-photon absorption （3PA） properties of two thiophene-fluorene derivatives （abbreviated as MOTFTBr and ATFTBr） have been determined by using a Q-switched Nd：YAG laser pumped with 38ps pulses at 1064nm in DMF. The measured 3PA cross-sections are 152×10^-78cm^6s^2 and 139× 10^-78cm^6s^2, respectively. The optimized structures were obtained by AM1 calculations and the results indicate that these two molecules show nonplanar structures, and attaching different donors has different effects on the molecular structure. The charge density distributions during the excitation were also systematically studied by using AM1 method. In addition, an obvious optical power limiting effect induced by 3PA has been demonstrated for both derivatives.

A Multi-mode Electronic Load Sensing Control Scheme with Power Limitation and Pressure Cut-off for Mobile Machinery

In mobile machinery,hydro-mechanical pumps are increasingly replaced by electronically controlled pumps to improve the automation level,but diversified control functions(e.g.,power limitation and pressure cut-off)are integrated into the electronic controller only from the pump level,leading to the potential instability of the overall system.To solve this problem,a multi-mode electrohydraulic load sensing(MELS)control scheme is proposed especially considering the switching stability from the system level,which includes four working modes of flow control,load sensing,power limitation,and pressure control.Depending on the actual working requirements,the switching rules for the different modes and the switching direction(i.e.,the modes can be switched bilaterally or unilaterally)are defined.The priority of different modes is also defined,from high to low:pressure control,power limitation,load sensing,and flow control.When multiple switching rules are satisfied at the same time,the system switches to the control mode with the highest priority.In addition,the switching stability between flow control and pressure control modes is analyzed,and the controller parameters that guarantee the switching stability are obtained.A comparative study is carried out based on a test rig with a 2-ton hydraulic excavator.The results show that the MELS controller can achieve the control functions of proper flow supplement,power limitation,and pressure cut-off,which has good stability performance when switching between different control modes.This research proposes the MELS control method that realizes the stability of multi-mode switching of the hydraulic system of mobile machinery under different working conditions.

Flexible Power Regulation and Limitation of Voltage Source Inverters under Unbalanced Grid Faults

This paper develops a flexible power regulation and limitation strategy of voltage source inverters(VSIs)under unbalanced grid faults.When the classical power theory is used under unbalanced grid faults,the power oscillations and current distortions are inevitable.In the proposed strategy,the extended power theory is introduced to compute the power feedbacks together with the classical power theory.Based on the combination of the classical and extended power theory,the proposed strategy can achieve the sinusoidal current provision and the flexible regulation between three common targets,i.e.,constant active power,balanced current,and constant reactive power.Meanwhile,the proposed strategy is associated with a power limiter,which is capable to keep the currents under the pre-defined threshold and to compute the maximum apparent power for better utilization of the inverter capacity.With this power limiter,the rated inverter capacity is fully used for both the active and reactive power provisions under unbalanced grid faults.Using the proposed power regulation and limitation,the VSI can avoid overcurrent tripping and flexibly regulate its power under unbalanced grid faults.All the conclusions are verified by the real-time hardware-in-loop tests.

海上运输的脱碳:土耳其船队的案例研究

Climate change and global warming are among the most severe threats to the global ecosystem,caused by greenhouse gas emissions.Therefore,all industries that cause environmental emissions should collaborate in the struggle against climate change.In this context,the International Maritime Organization(IMO)approved the initial greenhouse gas strategy at the MEPC 72 session in April 2018 to achieve targets for 2050.With this strategy,the IMO aims to create and improve new regulations that can enhance energy efficiency to achieve their short-term,midterm,and long-term goals.In this study,one of the novel terms,energy efficiency existing ship index(EEXI)values,has been calculated for the Turkish fleet to guide the maritime sector.The Turkish fleet in the study refers to the Turkish-owned vessels both sailing with a national or international flag.In accordance with this regulation,the number of Turkish fleets that were identified as either above or below the IMO reference lines has been determined.Additionally,EEXI values have been recalculated using the engine power limitation(EPL)method for ships that exceed the required limits,and the success rate of this method has been estimated.As a result,the application of EPL increased the number of ships below the Phase 2 reference line from 15.6%to 53.1%.To the best of our knowledge,this research,which has been carried out on all Turkish-owned ships,is the first study intended to serve as a guide for other ship owners in the global maritime industry regarding energy efficiency management.

Stability Study of a 23 MVA Turbine Generator

Power system stability is a very important issue in power system engineering because a decrease in the stability margins can cause unacceptable operating conditions, which leads to frequent failures. In this paper, SKM POWER TOOLS PTW-32 Version 4.5.2.0 was used to study different Stability recovery tests after a medium voltage short circuit fault on a turbine generator in the power system. The analysis focused on the generator electrical and mechanical powers stability recovery test, generator speed stability recovery test, excitation voltage stability recovery test, bus voltage and bus frequency stability recovery test. In our study, when the introduced fault was cleared after 0.5 s, it reveals that the recovery rate of electrical power was much faster than that of mechanical power. Also, the results reveal that it took about 10 seconds for the turbine speed to stabilize while it took fewer seconds for the frequency to stabilize.

A Pragmatic Method to Determine Transient Stability Constrained with Interface Real Power Flow Limits via Power System Scenario Similarity

In practical power systems,operators generally keep interface flowing under the transient stability constrained with interface real power flow limits(TS-IRPFL)to guarantee transient stability of the system.Many methods of computing TS-IRPFL have been proposed.However,in practice,the method widely used to determine TS-IRPFL is based on selection and analysis of typical scenarios as well as scenario matching.First,typical scenarios are selected and analyzed to obtain accurate limits,then the scenario to be analyzed is matched with a certain typical scenario,whose limit is adopted as the forecast limit.In this paper,following the steps described above,a pragmatic method to determine TS-IRPFL is proposed.The proposed method utilizes data-driven tools to improve the steps of scenario selection and matching.First of all,we formulate a clear model of power system scenario similarity.Based on the similarity model,we develop a typical scenario selector by clustering and a scenario matcher by nearest neighbor algorithm.The proposed method is pragmatic because it does not change the existing procedure.Moreover,it is much more reasonable than the traditional method.Test results verify the validity of the method.

A micro-power LDO with piecewise voltage foldback current limit protection

To achieve a constant current limit,low power consumption and high driving capability,a micro-power LDO with a piecewise voltage-foldback current-limit circuit is presented.The current-limit threshold is dynamically adjusted to achieve a maximum driving capability and lower quiescent current of only 300 nA.To increase the loop stability of the proposed LDO,a high impedance transconductance buffer under a micro quiescent current is designed for splitting the pole that exists at the gate of the pass transistor to the dominant pole,and a zero is designed for the purpose of the second pole phase compensation.The proposed LDO is fabricated in a BiCMOS process. The measurement results show that the short-circuit current of the LDO is 190 mA,the constant limit current under a high drop-out voltage is 440 mA,and the maximum load current under a low drop-out voltage is up to 800 mA. In addition,the quiescent current of the LDO is only 7μA,the load regulation is about 0.56%on full scale,the line regulation is about 0.012%/V,the PSRR at 120 Hz is 58 dB and the drop-out voltage is only 70 mV when the load current is 250 mA.

Design methodology of permanent magnet generators for fixed-pitch tidal turbines with overspeed power limitation strategy

This paper deals with a design methodology of permanent magnets(PM)generators used for fixed-pitch tidal turbines in a marine renewable energy context.In the case of underwater turbines,fixed-pitch tidal turbines could be very attractive and interesting to reduce maintenance operation by avoiding using such a complex electromechanical system for blade-pitching.In this technological case,one of the main control challenges is to ensure power limitation at high tidal current velocities.This control mode can be achieved using the generator flux-weakening.In this context,this paper proposes an original and systemic design methodology to optimize the generator design taking into account the tidal turbine power limitation for high tidal currents velocities.

Energy Method in Stretch Reducing Process of Steel Tube

According to the theories for stretch reducing process and steel tube plastic deformation, the energy method was used to mesh the rolled deformation zone of the steel tube into the upper limit elements, and an admissible velocity field was constructed to deduce a series of formulas of the inner virtual power consumption of deformed bodies. The roiling force during the stretch reducing process could be obtained by optimizing the upper limit power, which could provide guidelines for a proper choice of the stretch reducing process and devices for steel tube companies, as well as new products and devices.

A Novel Design of Hybrid Energy Storage System for Electric Vehicles

In order to provide long distance endurance and ensure the minimization of a cost function for electric vehicles,a new hybrid energy storage system for electric vehicle is designed in this paper.For the hybrid energy storage system,the paper proposes an optimal control algorithm designed using a Li-ion battery power dynamic limitation rule-based control based on the SOC of the super-capacitor.At the same time,the magnetic integration technology adding a second-order Bessel low-pass filter is introduced to DC-DC converters of electric vehicles.As a result,the size of battery is reduced,and the power quality of the hybrid energy storage system is optimized.Finally,the effectiveness of the proposed method is validated by simulation and experiment.

Concept and design of super junction devices

The super junction（SJ） has been recognized as the ＂milestone＂ of the power MOSFET, which is the most important innovation concept of the voltage-sustaining layer（VSL）. The basic structure of the SJ is a typical junction-type VSL（J-VSL） with the periodic N and P regions. However, the conventional VSL is a typical resistance-type VSL（R-VSL） with only an N or P region. It is a qualitative change of the VSL from the R-VSL to the JVSL, introducing the bulk depletion to increase the doping concentration and optimize the bulk electric field of the SJ. This paper firstly summarizes the development of the SJ, and then the optimization theory of the SJ is discussed for both the vertical and the lateral devices, including the non-full depletion mode, the minimum specific on-resistance optimization method and the equivalent substrate model. The SJ concept breaks the conventional＂silicon limit＂ relationship of R_（on）∝V_B^（2.5）, showing a quasi-linear relationship of R_（on）∝V_B^（1.03）.

Three-photon absorption in a push-pull type chromophore containing tricyanofuran acceptor

Three-photon absorption（3PA） of a push-pull chromophore,2-（3-cyano-（3-（4-（dimethylamino）styryl）-5,5-dimethylcyclohex- 2-enylidene）methyl）-5,5-dimethylfuran-2-ylidene） malononitrile（CFM） including TCF group was measured by the nonlinear transmission method using a femto-second Ti：Sapphire oscillator-amplifier laser system.Its three-photon absorption cross-sections at 1300 ran were 36.8×10^-79 cm^6 s^2 in the solution of DMF and 12.3×10^-79 cm^6 s^2 in the solution of CH_2Cl_2,respectively.The large values were got by experiments in this paper,which is a new exploration for these kinds of materials.The molecule has the potential application foreground of 3PA areas and optical power limiting.