This paper presents a series of monotonically combined lateral loading tests to investigate the bearing capacity of the MSCs （modified suction caissons） in the saturated marine fine sand. The lateral loads were appl...This paper presents a series of monotonically combined lateral loading tests to investigate the bearing capacity of the MSCs （modified suction caissons） in the saturated marine fine sand. The lateral loads were applied under load- and displacement-controlled methods at the loading eccentricity ratios of 1.5, 2.0 and 2.5. Results show that, in the displacement-controlled test, the deflection-softening behavior of load-deflection curves for MSCs was observed, and the softening degree of the load-deflection response increased with the increasing external skirt length or the decreasing loading eccentricity. It was also found that the rotation center of the MSC at failure determined by the load-controlled method is slightly lower than that by the displacement-controlled method. The calculated MSC capacity based on the rotation center position in serviceability limit state is relatively conservative, compared with the calculated capacity based on the rotation center position in the ultimate limit state. In the limit state, the passive earth pressures opposite the loading direction under load- and displacement-controlled methods decrease by 46% and 74% corresponding to peak values, respectively; however, the passive earth pressures in the loading direction at failure only decrease by approximately 3% and 7%, compared with their peak values.展开更多
On the basis of capacity flow model, a new model is developed for a load-sharing k-out-of-n： G system consisting of different components, to describe the increase of the same component＇s failure rates under differen...On the basis of capacity flow model, a new model is developed for a load-sharing k-out-of-n： G system consisting of different components, to describe the increase of the same component＇s failure rates under different loads. All components have exponential life distributions and are nonrepairable in the system. Reliability of load- sharing 2-out- of-3： G system is calculated and some special cases for the system are discussed. The calculation and discussions show that the model is right and practical.展开更多
基金supported by the National Natural Science Foundation of China(Grant Nos.51379118 and 51639002)SDUST Scientific Found(Grant No.2015KYTD104)
文摘This paper presents a series of monotonically combined lateral loading tests to investigate the bearing capacity of the MSCs （modified suction caissons） in the saturated marine fine sand. The lateral loads were applied under load- and displacement-controlled methods at the loading eccentricity ratios of 1.5, 2.0 and 2.5. Results show that, in the displacement-controlled test, the deflection-softening behavior of load-deflection curves for MSCs was observed, and the softening degree of the load-deflection response increased with the increasing external skirt length or the decreasing loading eccentricity. It was also found that the rotation center of the MSC at failure determined by the load-controlled method is slightly lower than that by the displacement-controlled method. The calculated MSC capacity based on the rotation center position in serviceability limit state is relatively conservative, compared with the calculated capacity based on the rotation center position in the ultimate limit state. In the limit state, the passive earth pressures opposite the loading direction under load- and displacement-controlled methods decrease by 46% and 74% corresponding to peak values, respectively; however, the passive earth pressures in the loading direction at failure only decrease by approximately 3% and 7%, compared with their peak values.
基金the Natural Science Foundation of the Education Department of Sichuan Province([2006]A067)the Talent Introduction Foundation of Sichuan Normal University.
文摘On the basis of capacity flow model, a new model is developed for a load-sharing k-out-of-n： G system consisting of different components, to describe the increase of the same component＇s failure rates under different loads. All components have exponential life distributions and are nonrepairable in the system. Reliability of load- sharing 2-out- of-3： G system is calculated and some special cases for the system are discussed. The calculation and discussions show that the model is right and practical.
