Localized nature of damage in structures requires local measurements for structural health monitoring. The local measurement means to measure the local, usually higher modes of the vibration in a structure. Three fund...Localized nature of damage in structures requires local measurements for structural health monitoring. The local measurement means to measure the local, usually higher modes of the vibration in a structure. Three fundamental issues about the local measurement for structural health monitoring including (1) the necessity of making local measurement, (2) the difficulty of making local measurement and (3) how to make local measurement are addressed in this paper. The results from both the analysis and the tests show that the local measurement can successfully monitor the structural health status as long as the local modes are excited. Unfortunately, the results also illustrate that it is difficult to excite local modes in a structure. Therefore, in order to carry structural health monitoring into effect, we must (1) ensure that the local modes are excited, and (2) deploy enough sensors in a structure so that the local modes can be monitored.展开更多
As the radio communications technology widely used,wireless location technology plays a more important role in maintaining the order of the air waves.However concretely effective symbol calibration method with regard ...As the radio communications technology widely used,wireless location technology plays a more important role in maintaining the order of the air waves.However concretely effective symbol calibration method with regard to Chinese DTMB signal of different frame mode is quite under research due to the multiple structure of DTMB signal.In this paper,we propose a Time Difference of Arrival(TDOA)-based passive location scheme using least square principle.Utilizing the large number of anchor nodes in wireless monitoring network,a novel algorithm is formulated to solve the None-LineOf-Sight problem.The derived Cramer Rao Lower Bound of the localization method guides to the accuracy of the position outcome with regards to the calibration precision.In contrast with traditional multi-terminal location schemes,our location scheme can reduce calculation complexity and location costs abruptly.A twostep NLOS identification algorithm is proposed.Computer simulation is employed to verify the well performance of the calibration method of3-4 dB superiority than normal method and also the whole localization scheme for less than 50 meters through channel of SNR lower than dB.Simulation also shows that our algorithm can effectively identify NLOS path and improve positioning accuracy.展开更多
There are multiple operating modes in the real industrial process, and the collected data follow the complex multimodal distribution, so most traditional process monitoring methods are no longer applicable because the...There are multiple operating modes in the real industrial process, and the collected data follow the complex multimodal distribution, so most traditional process monitoring methods are no longer applicable because their presumptions are that sampled-data should obey the single Gaussian distribution or non-Gaussian distribution. In order to solve these problems, a novel weighted local standardization(WLS) strategy is proposed to standardize the multimodal data, which can eliminate the multi-mode characteristics of the collected data, and normalize them into unimodal data distribution. After detailed analysis of the raised data preprocessing strategy, a new algorithm using WLS strategy with support vector data description(SVDD) is put forward to apply for multi-mode monitoring process. Unlike the strategy of building multiple local models, the developed method only contains a model without the prior knowledge of multi-mode process. To demonstrate the proposed method's validity, it is applied to a numerical example and a Tennessee Eastman(TE) process. Finally, the simulation results show that the WLS strategy is very effective to standardize multimodal data, and the WLS-SVDD monitoring method has great advantages over the traditional SVDD and PCA combined with a local standardization strategy(LNS-PCA) in multi-mode process monitoring.展开更多
Wireless Sensor Networks for Rainfall Monitoring (RM-WSNs) is a sensor network for the large-scale regional and moving rainfall monitoring,which could be controlled deployment. Delivery delay and cross-cluster calcula...Wireless Sensor Networks for Rainfall Monitoring (RM-WSNs) is a sensor network for the large-scale regional and moving rainfall monitoring,which could be controlled deployment. Delivery delay and cross-cluster calculation leads to information inaccuracy by the existing dynamic collabo-rative self-organization algorithm in WSNs. In this letter,a Local Dynamic Cluster Self-organization algorithm (LDCS) is proposed for the large-scale regional and moving target monitoring in RM-WSNs. The algorithm utilizes the resource-rich node in WSNs as the cluster head,which processes target information obtained by sensor nodes in cluster. The cluster head shifts with the target moving in chance and re-groups a new cluster. The target information acquisition is limited in the dynamic cluster,which can reduce information across-clusters transfer delay and improve the real-time of information acquisition. The simulation results show that,LDCS can not only relieve the problem of "too frequent leader switches" in IDSQ,also make full use of the history monitoring information of target and con-tinuous monitoring of sensor nodes that failed in DCS.展开更多
文摘Localized nature of damage in structures requires local measurements for structural health monitoring. The local measurement means to measure the local, usually higher modes of the vibration in a structure. Three fundamental issues about the local measurement for structural health monitoring including (1) the necessity of making local measurement, (2) the difficulty of making local measurement and (3) how to make local measurement are addressed in this paper. The results from both the analysis and the tests show that the local measurement can successfully monitor the structural health status as long as the local modes are excited. Unfortunately, the results also illustrate that it is difficult to excite local modes in a structure. Therefore, in order to carry structural health monitoring into effect, we must (1) ensure that the local modes are excited, and (2) deploy enough sensors in a structure so that the local modes can be monitored.
基金supported by National BeiDou Special ProjectNational Science & Technology planning project of China(Grant No. 2014BAK12B04)
文摘As the radio communications technology widely used,wireless location technology plays a more important role in maintaining the order of the air waves.However concretely effective symbol calibration method with regard to Chinese DTMB signal of different frame mode is quite under research due to the multiple structure of DTMB signal.In this paper,we propose a Time Difference of Arrival(TDOA)-based passive location scheme using least square principle.Utilizing the large number of anchor nodes in wireless monitoring network,a novel algorithm is formulated to solve the None-LineOf-Sight problem.The derived Cramer Rao Lower Bound of the localization method guides to the accuracy of the position outcome with regards to the calibration precision.In contrast with traditional multi-terminal location schemes,our location scheme can reduce calculation complexity and location costs abruptly.A twostep NLOS identification algorithm is proposed.Computer simulation is employed to verify the well performance of the calibration method of3-4 dB superiority than normal method and also the whole localization scheme for less than 50 meters through channel of SNR lower than dB.Simulation also shows that our algorithm can effectively identify NLOS path and improve positioning accuracy.
基金Project(61374140)supported by the National Natural Science Foundation of China
文摘There are multiple operating modes in the real industrial process, and the collected data follow the complex multimodal distribution, so most traditional process monitoring methods are no longer applicable because their presumptions are that sampled-data should obey the single Gaussian distribution or non-Gaussian distribution. In order to solve these problems, a novel weighted local standardization(WLS) strategy is proposed to standardize the multimodal data, which can eliminate the multi-mode characteristics of the collected data, and normalize them into unimodal data distribution. After detailed analysis of the raised data preprocessing strategy, a new algorithm using WLS strategy with support vector data description(SVDD) is put forward to apply for multi-mode monitoring process. Unlike the strategy of building multiple local models, the developed method only contains a model without the prior knowledge of multi-mode process. To demonstrate the proposed method's validity, it is applied to a numerical example and a Tennessee Eastman(TE) process. Finally, the simulation results show that the WLS strategy is very effective to standardize multimodal data, and the WLS-SVDD monitoring method has great advantages over the traditional SVDD and PCA combined with a local standardization strategy(LNS-PCA) in multi-mode process monitoring.
基金Supported by the Key Projection of Science and Technology Research of Ministry of Education of China (107057)the Science & Technology Fund for Students of Hohai University (K200803)
文摘Wireless Sensor Networks for Rainfall Monitoring (RM-WSNs) is a sensor network for the large-scale regional and moving rainfall monitoring,which could be controlled deployment. Delivery delay and cross-cluster calculation leads to information inaccuracy by the existing dynamic collabo-rative self-organization algorithm in WSNs. In this letter,a Local Dynamic Cluster Self-organization algorithm (LDCS) is proposed for the large-scale regional and moving target monitoring in RM-WSNs. The algorithm utilizes the resource-rich node in WSNs as the cluster head,which processes target information obtained by sensor nodes in cluster. The cluster head shifts with the target moving in chance and re-groups a new cluster. The target information acquisition is limited in the dynamic cluster,which can reduce information across-clusters transfer delay and improve the real-time of information acquisition. The simulation results show that,LDCS can not only relieve the problem of "too frequent leader switches" in IDSQ,also make full use of the history monitoring information of target and con-tinuous monitoring of sensor nodes that failed in DCS.
