Bunch-length measurement at a bunch-by-bunch rate based on time–frequency-domain joint analysis techniques and its application

This paper presents a new technique for measuring the bunch length of a high-energy electron beam at a bunch-by-bunch rate in storage rings.This technique uses the time–frequency-domain joint analysis of the bunch signal to obtain bunch-by-bunch and turn-by-turn longitudinal parameters,such as bunch length and synchronous phase.The bunch signal is obtained using a button electrode with a bandwidth of several gigahertz.The data acquisition device was a high-speed digital oscilloscope with a sampling rate of more than 10 GS/s,and the single-shot sampling data buffer covered thousands of turns.The bunch-length and synchronous phase information were extracted via offline calculations using Python scripts.The calibration coefficient of the system was determined using a commercial streak camera.Moreover,this technique was tested on two different storage rings and successfully captured various longitudinal transient processes during the harmonic cavity debugging process at the Shanghai Synchrotron Radiation Facility(SSRF),and longitudinal instabilities were observed during the single-bunch accumulation process at Hefei Light Source(HLS).For Gaussian-distribution bunches,the uncertainty of the bunch phase obtained using this technique was better than 0.2 ps,and the bunch-length uncertainty was better than 1 ps.The dynamic range exceeded 10 ms.This technology is a powerful and versatile beam diagnostic tool that can be conveniently deployed in high-energy electron storage rings.

Numerical and Experimental Investigation of the Aero-Hydrodynamic Effect on the Behavior of a High-Speed Catamaran in Calm Water

In this paper,the effect of water and air fluids on the behavior of a planing catamaran in calm water was studied separately in calm water by using experimental and numerical methods.Experiments were conducted in a towing tank over the Froude number range of 0.49–2.9 with two degrees of freedom.The model vessel displacement of 5.3 kg was implemented in experimental tests.Craft behavior was evaluated at the displacements of 5.3,4.6,and 4 kg by using the numerical method.The numerical simulation results for the hull’s resistance force were validated with similar experimental data.The fluid volume model was applied to simulate two-phase flow.The SST k-ωturbulence model was used to investigate the effect of turbulence on the catamaran.The results showed that in the planing mode,the contribution of air to pressure resistance increased by 55%,40%,and 60%at the mentioned displacements,whereas the contribution of air to friction resistance was less than 15%on average.The contribution of the air to the total lift force at the abovementioned displacements exceeded 70%,60%,and 50%in the planing mode but was less than 10%in the displacement mode.At the displacements of 5.3 and 4 kg,the area under the effect of maximum pressure moved around the center of gravity and caused porpoising longitudinal instability at the Froude numbers of 2.9 and 2.4,respectively.However,at the displacement of 4.6 kg,this effect did not occur,and the vessel maintained its stability.

Research and development of the longitudinal feedback system digital signal processing electronics in BEPCII

Background The current strategy to achieve high luminosity for high energy physics experiments is to store huge currents distributed in many bunches in circular machines such as BEPCII,so the longitudinal coupled bunch instabilities of the beam are inevitable.Purpose Therefore,a longitudinal feedback system is needed to suppress longitudinal oscillation.Otherwise,the beam energy spread will increase;the luminosity and the beam lifetime will decrease under a certain beam current.Methods For filter design of the feedback system,the time domain least square fitting(TDLSF)method is compared to the selective wave filter method;digital signal processing electronics based on commercial board have been developed and tested on BEPCII.Results The final result shows that the self-developed longitudinal feedback system can suppress the longitudinal beam oscillation at 750 mA beam current and meet the requirements of BEPCII;the restrain depth to the sidebands reaches to 40.8 dB.