A Sensitivity Mapping Technique for Tensile Force and Case Depth Characterization Based on Magnetic Minor Hysteresis Loops

In the nondestructive testing and evaluation area,magnetic major hysteresis loop measurement technology are widely applied for ferromagnetic material evaluation.However the characterization ability of major hysteresis loop measurement technology greatly varies as the evaluated target properties.To solve this limitation,magnetic minor hysteresis loops,which reflect the responses of ferromagnetic material magnetization in a systematic way,is recommend.Inspired by plenty of information carried by the minor loops,the sensitivity mapping technique was developed to achieve the highest sensitivity of minor-loop parameters to the nondestructively evaluated targets.In this study,for the first time,the sensitivity mapping technique is used to measure the tensile force in a steel strand and evaluate the effective case depth in induction-hardened steel rods.The method and procedures for the sensitivity mapping technique are given before experimental detection.The obtained experimental results indicate that the linear correlation between the induced voltage(or the magnetic induction intensity)and the tensile force(or effective case depth)exists at most of the locations in the cluster of minor loops.The obtained sensitivity maps can be used to optimize the applied magnetic field(or excitation current)and the analyzed locations at the minor loops for achieving the highest sensitivity.For the purpose of tensile force measurement,it is suggested that the strand should be firstly magnetized to the near-saturation state and then restored to the remanent state.In this way,the highest sensitivity is obtained as about 15.26 mV/kN.As for the induction-hardened steel rods,the highest sensitivity of magnetic induction intensity to the effective case depth occurs under low magnetic field conditions and the absolute value of the highest sensitivity is about 0.1110 T/mm.This indicates that if the highest sensitivity is required in the case depth evaluation,the induction-hardened steel rods are only required to be weakly magnetized.The proposed sensitivity mapping technique shows the good performance in the high-sensitivity evaluation of tensile force and case depth in ferromagnetic materials and its application scope can be extended to other nondestructive detection fields.

Magnetic Properties and Kinetics Parameters of Electroless Magnetic Loss CoFeB Films

Electroless CoFeB films with good soft magnetic properties were fabricated on polyester plastic substrate from sodium tartarate as a complexing agent.The plating rate of electroless CoFeB films is a function of concentration of sodium tetrahydroborate,pH of the plating bath,plating temperature and the metallic ratio.The estimated regression coefficient b0-b3 confidence interval,residual error r and confidence interval rint were confirmed by a computer program.The optimal composition of the plating bath was obtained and the dynamic electromagnetic parameters of films were measured in the 2-10 GHz range.At 2 GHz,the μ＇,μ″ of the electroless CoFeB films were 304 and 76.6,respectively,as the concentration of reducer is 1 g/L.Magnetic hysteresis loop of the deposited CoFeB films show a remanence close to the saturation magnetization and coercivity of about 55.7-127.4 A/m.The loops along the hard axis display low anisotropic field Hk of 2 388-3 582 A/m.

Research on Magnetomechanical Coupling Effect of Q235 Steel Member Specimens

In this study,magnetomechanical coupling tests were performed on Q235 solid round steel model specimens in NIM-200HF magnetomechanical coupling equipment.Hysteresis loops were obtained in different magnetic fields and stresses.Magnetization curves were also achieved at different stresses.Influence of the applied stresses on the hysteresis loops was investigated.The stress sensitive region and linear stress sensitive region of magnetic induction were determined for the model specimen according to the experimental data.The dependence relation of magnetic induction versus applied stresses was established,and the optimum magnetic field was determined in the stress sensitive range of magnetic induction,which builds a basis for nondestructive testing(NDT) of stress with the total magnetic flux for steel structure.Based on modified Jiles-Atherton's model of magnetic hysteresis,the hysteresis loop for Q235 steel 4-mm diameter model specimen was numerically simulated,which was well consistent with the experimental results.