The energy of a radio wave is reduced through the dispersion, the refraction and the absorption because the medium transferring the vibration of a radio wave is the seawater. In the end the reduced energy of a radio w...The energy of a radio wave is reduced through the dispersion, the refraction and the absorption because the medium transferring the vibration of a radio wave is the seawater. In the end the reduced energy of a radio wave causes the reduced transmitting length for communication, the long postponed communication and the frequent error. The subsea communication for the marine environment monitoring which must overcome the weak points of the RF wave and the most practical method for the marine sensor network realization is to use the acoustic wave method, but the energy consumption rate of the acoustic wave communication method is about 100 times greater than the one of the RF wave method. So, the power supply of the sensor node in the marine sensor network system is the most important interest field. In this study, the sample which consists of an acrylic elastomer(VHB4905 film from 3M), conductible carbon grease(from MG chemical) and electric wire for the basic study of an energy harvesting strategy and technique using EAP actuator was fabricated, and the conductible carbon grease was used for an electrode. The characteristics of the fabricated sample were analyzed through the experiment. We also mixed carbon grease with aluminum powder for conductibility improvement, and the effect of the mixed electrode was confirmed through the conductivity measurement.展开更多
Nowadays for power generation, environment is a major consideration. The heart of power generation is power station. At present there are almost above 40(Both Government & Rental) power station in Bangladesh. Amon...Nowadays for power generation, environment is a major consideration. The heart of power generation is power station. At present there are almost above 40(Both Government & Rental) power station in Bangladesh. Among these 80% of power station is gas based. Rest of the 20% is coal, liquid and furnace oil based. Bangladesh has only one Hydraulic power station. These gas and coal based power stations are giving adverse effect in Bangladesh. The main emissions from coal combustion at thermal power plants are carbon dioxide (CO), nitrogen oxides (NO), sulfur oxides (SO), chlorofluorocarbons (CFCs), and air- borne inorganic particles such as fly ash, soot, and other trace gas species. Carbon dioxide, methane, and chlorofluorocarbons are greenhouse gases. These emissions are considered to be responsible for heating up the atmosphere, producing a harmful global environment. It is known to all that hydro power station is a clean source of energy, but it has also some ecological and environmental effect. Dhaka is one of the top polluted city in the world. So for power generation if the environmental effect is not considered then Bangladesh will be in great trouble. The purpose of this paper is to discuss the present and future possible environmental effect of power generation in Bangladesh.展开更多
In light of China s Ninth Five-year Plan (1996-2000) for Electric Power Industry & the Long Term Targets by the Year 2010, the paper considers the strategy for developing China’s thermal power in the 21st century...In light of China s Ninth Five-year Plan (1996-2000) for Electric Power Industry & the Long Term Targets by the Year 2010, the paper considers the strategy for developing China’s thermal power in the 21st century shall be the efficiency and cleaning technology of coal use. Especially important is the structure of power sources and configuration of technology process, and secondly the implementation of energy saving and environmental protection ideology in the various stages of thermal power construction and design work.展开更多
The WRNM(wide range neutron monitoring)is a newly developed neutron monitoring channel which was initially conceived as a means to meet Regulatory Guide 1.97 requirements for post-accident neutron monitoring.The scope...The WRNM(wide range neutron monitoring)is a newly developed neutron monitoring channel which was initially conceived as a means to meet Regulatory Guide 1.97 requirements for post-accident neutron monitoring.The scope was expanded to include the startup monitoring function with the aim of replacing both the source and IRMs(intermediate range monitors)in BWRs(boiling water reactors).The WRNMs,consisting of a newly designed fixed incore regenerative sensor and new electronics,which include both counting and MSV(mean square voltage)channels,have been tested in several reactors and its capabilities have been confirmed.The channel will cover the neutron flux range from 103 nv to 1.5×103 nv;it has greater than 1 decade overlap between the counting and MSV channels.Because of the regenerative fissile coating the sensor,even though fixed incore,has a life of approximately 6.0 full power years in a 51 kW/L BWR and similar situation has been proposed for newly designed small modular reactor such as BWRX-300 of General Electric Hitachi reactor.展开更多
文摘The energy of a radio wave is reduced through the dispersion, the refraction and the absorption because the medium transferring the vibration of a radio wave is the seawater. In the end the reduced energy of a radio wave causes the reduced transmitting length for communication, the long postponed communication and the frequent error. The subsea communication for the marine environment monitoring which must overcome the weak points of the RF wave and the most practical method for the marine sensor network realization is to use the acoustic wave method, but the energy consumption rate of the acoustic wave communication method is about 100 times greater than the one of the RF wave method. So, the power supply of the sensor node in the marine sensor network system is the most important interest field. In this study, the sample which consists of an acrylic elastomer(VHB4905 film from 3M), conductible carbon grease(from MG chemical) and electric wire for the basic study of an energy harvesting strategy and technique using EAP actuator was fabricated, and the conductible carbon grease was used for an electrode. The characteristics of the fabricated sample were analyzed through the experiment. We also mixed carbon grease with aluminum powder for conductibility improvement, and the effect of the mixed electrode was confirmed through the conductivity measurement.
文摘Nowadays for power generation, environment is a major consideration. The heart of power generation is power station. At present there are almost above 40(Both Government & Rental) power station in Bangladesh. Among these 80% of power station is gas based. Rest of the 20% is coal, liquid and furnace oil based. Bangladesh has only one Hydraulic power station. These gas and coal based power stations are giving adverse effect in Bangladesh. The main emissions from coal combustion at thermal power plants are carbon dioxide (CO), nitrogen oxides (NO), sulfur oxides (SO), chlorofluorocarbons (CFCs), and air- borne inorganic particles such as fly ash, soot, and other trace gas species. Carbon dioxide, methane, and chlorofluorocarbons are greenhouse gases. These emissions are considered to be responsible for heating up the atmosphere, producing a harmful global environment. It is known to all that hydro power station is a clean source of energy, but it has also some ecological and environmental effect. Dhaka is one of the top polluted city in the world. So for power generation if the environmental effect is not considered then Bangladesh will be in great trouble. The purpose of this paper is to discuss the present and future possible environmental effect of power generation in Bangladesh.
文摘In light of China s Ninth Five-year Plan (1996-2000) for Electric Power Industry & the Long Term Targets by the Year 2010, the paper considers the strategy for developing China’s thermal power in the 21st century shall be the efficiency and cleaning technology of coal use. Especially important is the structure of power sources and configuration of technology process, and secondly the implementation of energy saving and environmental protection ideology in the various stages of thermal power construction and design work.
文摘The WRNM(wide range neutron monitoring)is a newly developed neutron monitoring channel which was initially conceived as a means to meet Regulatory Guide 1.97 requirements for post-accident neutron monitoring.The scope was expanded to include the startup monitoring function with the aim of replacing both the source and IRMs(intermediate range monitors)in BWRs(boiling water reactors).The WRNMs,consisting of a newly designed fixed incore regenerative sensor and new electronics,which include both counting and MSV(mean square voltage)channels,have been tested in several reactors and its capabilities have been confirmed.The channel will cover the neutron flux range from 103 nv to 1.5×103 nv;it has greater than 1 decade overlap between the counting and MSV channels.Because of the regenerative fissile coating the sensor,even though fixed incore,has a life of approximately 6.0 full power years in a 51 kW/L BWR and similar situation has been proposed for newly designed small modular reactor such as BWRX-300 of General Electric Hitachi reactor.
