Distribution networks face an increasing penetration of solar PV （photovoltaic） and small WTG （wind turbine generator） as well as other forms of micro-generation. To this scenario, one must add the dissemination o...Distribution networks face an increasing penetration of solar PV （photovoltaic） and small WTG （wind turbine generator） as well as other forms of micro-generation. To this scenario, one must add the dissemination of non-linear loads such as EV （electric vehicles）. There is something in common between those loads and sources： the extensive use of power electronic converters with commutated switches. These devices may be a source of medium-to-high frequency harmonic distortion and their impact on the local distribution grid must be carefully assessed in order to evaluate their negative impacts on the network, on the existing conventional loads and also on other active devices. In this paper, methodologies to characterize effects such as： harmonics, network unbalances, damaging power line resonance conditions, and over/under voltages are described and applied to a real local grid configuration.展开更多
A novel roof tile thermoelectric generator(RT-TEG)was used to harvest electrical energy from a solar heat source.The RT-TEG was fabricated and simulated by flat and curved thermoelectric modules consisting of p-n junc...A novel roof tile thermoelectric generator(RT-TEG)was used to harvest electrical energy from a solar heat source.The RT-TEG was fabricated and simulated by flat and curved thermoelectric modules consisting of p-n junctions of p-Sb_(2)Te_(3) and n-Bi_(2)Te_(3),with an Al_(2)O_(3) substrate at the top and bottom for heat absorption and heat rejection.The RT-TEG was installed in a roof tile to act as a generator.The electrical voltage and power values of the curved thermoelectric modules were higher than those of the flat thermoelectric module by 0.44 V and 80 mW,at a temperature difference(ΔT)of 100 K.In field tests,the RT-TEG produced a maximum electrical voltage of 33.70 mV and an electrical power of 46.24μW atΔT~7 K under a load resistance of 1Ωunder good sunshine at 13.00 hours.The energy conversion efficiency of RT-TEG was found to be 2.24×10^(−4).展开更多
文摘Distribution networks face an increasing penetration of solar PV （photovoltaic） and small WTG （wind turbine generator） as well as other forms of micro-generation. To this scenario, one must add the dissemination of non-linear loads such as EV （electric vehicles）. There is something in common between those loads and sources： the extensive use of power electronic converters with commutated switches. These devices may be a source of medium-to-high frequency harmonic distortion and their impact on the local distribution grid must be carefully assessed in order to evaluate their negative impacts on the network, on the existing conventional loads and also on other active devices. In this paper, methodologies to characterize effects such as： harmonics, network unbalances, damaging power line resonance conditions, and over/under voltages are described and applied to a real local grid configuration.
基金supported by the Thailand Research Fund(TRF)Research Career Development Grant:(RSA6180070).
文摘A novel roof tile thermoelectric generator(RT-TEG)was used to harvest electrical energy from a solar heat source.The RT-TEG was fabricated and simulated by flat and curved thermoelectric modules consisting of p-n junctions of p-Sb_(2)Te_(3) and n-Bi_(2)Te_(3),with an Al_(2)O_(3) substrate at the top and bottom for heat absorption and heat rejection.The RT-TEG was installed in a roof tile to act as a generator.The electrical voltage and power values of the curved thermoelectric modules were higher than those of the flat thermoelectric module by 0.44 V and 80 mW,at a temperature difference(ΔT)of 100 K.In field tests,the RT-TEG produced a maximum electrical voltage of 33.70 mV and an electrical power of 46.24μW atΔT~7 K under a load resistance of 1Ωunder good sunshine at 13.00 hours.The energy conversion efficiency of RT-TEG was found to be 2.24×10^(−4).
