The study of a new n/p tunnel recombination junction and its application in a-Si:H/μc-Si:H tandem solar cells

This paper reports that a double N layer （a-Si：H/μc-Si：H） is used to substitute the single microcrystalline silicon n layer （n-μc-Si：H） in n/p tunnel recombination junction between subcells in a-Si：H/μc-Si：H tandem solar cells. The electrical transport and optical properties of these tunnel recombination junctions are investigated by current voltage measurement and transmission measurement. The new n/p tunnel recombination junction shows a better ohmic contact. In addition, the n/p interface is exposed to the air to examine the effect of oxidation on the tunnel recombination junction performance. The open circuit voltage and FF of a-Si：H/μc-Si：H tandem solar cell are all improved and the current leakage of the subcells can be effectively prevented efficiently when the new n/p junction is implemented as tunnel recombination junction.

An analytical model to explore open-circuit voltage of a-Si:H/c-Si heterojunction solar cells

The effect of the parameters on the open-circuit voltage, V_(OC) of a-Si:H/c-Si heterojunction solar cells was explored by an analytical model. The analytical results show that V_(OC) increases linearly with the logarithm of illumination intensity under usual illumination. There are two critical values of the interface state density(D_(it)) for the open-circuit voltage(V_(OC)), D_(it)^(crit,1) and D_(it)crit,2(a few 1010 cm^(-2)·e V^(-1)). V_(OC) decreases remarkably when D_(it) is higher than D_(it)^(crit,1). To achieve high V_(OC), the interface states should reduce down to a few 1010 cm^(-2)·e V^(-1). Due to the difference between the effective density of states in the conduction and valence band edges of c-Si, the open-circuit voltage of a-Si:H/c-Si heterojunction cells fabricated on n-type c-Si wafers is about 22 mV higher than that fabricated on p-type c-Si wafers at the same case. V_(OC) decreases with decreasing the a-Si:H doping concentration at low doping level since the electric field over the c-Si depletion region is reduced at low doping level. Therefore, the a-Si:H layer should be doped higher than a critical value of 5×10^(18) cm^(-3) to achieve high V_(OC).

Simulation of a-Si:H/c-Si heterojunction solar cells: From planar junction to local junction

In order to obtain higher conversion efficiency and to reduce production cost for hydrogenated amorphous silicon/crystalline silicon(a-Si:H/c-Si) based heterojunction solar cells, an a-Si:H/c-Si heterojunction with localized p–n structure(HACL) is designed. A numerical simulation is performed with the ATLAS program. The effect of the a-Si:H layer on the performance of the HIT(heterojunction with intrinsic thin film) solar cell is investigated. The performance improvement mechanism for the HACL cell is explored. The potential performance of the HACL solar cell is compared with those of the HIT and HACD(heterojunction of amorphous silicon and crystalline silicon with diffused junction) solar cells.The simulated results indicate that the a-Si:H layer can bring about much absorption loss. The conversion efficiency and the short-circuit current density of the HACL cell can reach 28.18% and 43.06 m A/cm^2, respectively, and are higher than those of the HIT and HACD solar cells. The great improvement are attributed to(1) decrease of optical absorption loss of a-Si:H and(2) decrease of photocarrier recombination for the HACL cell. The double-side local junction is very suitable for the bifacial solar cells. For an HACL cell with n-type or p-type c-Si base, all n-type or p-type c-Si passivating layers are feasible for convenience of the double-side diffusion process. Moreover, the HACL structure can reduce the consumption of rare materials since the transparent conductive oxide(TCO) can be free in this structure. It is concluded that the HACL solar cell is a promising structure for high efficiency and low cost.

Effect of H treatment on performance of HIT solar cells

Hydrogen is a ubiquitous element in semiconductor processing and particularly in amorphous and microcrystalline silicon where it plays a crucial role in the growth processes as well as in the material properties. Because of its low mass it can easily diffuse through the silicon network and leads to the passivation of dangling bonds but it may also play a role in the stabilization of metastable defects. Thus a lot of work has been devoted to the study of hydrogen diffusion, bonding and structure in disordered semiconductors. The sequence, deposition-exposure to H plasma-deposition was used to fabricate the microcrystalline emitter. A proper atomic H pretreatment of c-Si surface before depositions i layer was expected to clean the surface and passivatates the surface states, as a result improing the device parameters. In this study, H2 pretreatment of c-si surface was used at different time, power and temperature. It is found that a proper H pretreatment improves passivation of c-si surface and improves the device parameters by AFM and testing I-V.

Effects of deposition pressure and plasma power on the growth and properties of boron-doped microcrystalline silicon films

Using diborane as doping gas, p-doped μc-Si：H layers are deposited by using the plasma enhanced chemical vapour deposition （PECVD） technology. The effects of deposition pressure and plasma power on the growth and the properties of μc-Si：H layers are investigated. The results show that the deposition rate, the electrical and the structural properties are all strongly dependent on deposition pressure and plasma power. Boron-doped μc-Si：H films with a dark conductivity as high as 1.42 Ω^-1·cm^-1 and a crystallinity of above 50% are obtained. With this p-layer, μc-Si：H solar cells are fabricated. In addition, the mechanism for the effects of deposition pressure and plasma power on the growth and the properties of boron-doped μc-Si：H layers is discussed.

Simulation and experimental study of a novel bifacial structure of silicon heterojunction solar cell for high efficiency and low cost

A novel structure of Ag gridlSiN_(x)/n+-c-Si/n-c-Si/i-a-Si:H/p^(+)-a-Si:HlTCO/Ag grid was designed to increase the ef-ficiency of bifacial amorphous/crystalline silicon-based solar cells and reduce the rear material consumption and production cost.The simulation results show that the new structure obtains higher efficiency compared with the typical bifa-cial amorphous/crystalline silicon-based solar cell because of an increase in the short-circuit current(J_(sc)),while retaining the advantages of a high open-circuit voltage,low temperature coefficient,and good weak-light performance.Moreover,real cells composed of the novel structure with dimensions of 75 mm×75 mm were fabricated by a special fabrication recipe based on industrial processes.Without parameter optimization,the cell efficiency reached 21.1%with the J_(sc)of 41.7 mA/cm^(2).In addition,the novel structure attained 28.55%potential conversion efficiency under an illumination of AM 1.5 G,100 mW/cm^(2).We conclude that the configuration of the Ag grid/SiN_(x)/n^(+)-c-Si/n-c-Si/i-a-Si:H/p^(+)-a-Si:H/TCO/Ag grid is a promising structure for high efficiency and low cost.

Deposition of p-Type Microcrystalline Silicon Film and Its Application in Microcrystalline Silicon Solar Cells

Highly conductive boron-doped hydrogenated microcrystalline silicon （μc-Si： H） films and solar cells are pre- pared by plasma enhanced chemical vapour deposition （PECVD）. The effects of diborane concentration, thickness and substrate temperature on the growth and properties of B-doped layers and the performance of solar cells with high deposited rate i-layers are investigated. With the optimum p-layer deposition parameters, a higher efficiency of 5.5% is obtained with 0.78nm/s deposited i-layers. In addition, the carriers transport mechanism of p-type μc-Si： H films is discussed.

Analysis of the double-layer a-Si：H emitter with different doping concentrations for α-Si：H/c-Si heterojunction solar cells

Double-layer emitters with different doping concentrations （DLE） have been designed and prepared for amorphous silicon/crystalline silicon （ct-Si：H/c-Si） hetero- junction solar cells. Compared with the traditional single layer emitter, both the experiment and the simulation （AFORS-HET, http：//www.paper.edu.cn/html/releasepaper/2014/04/282/） prove that the double-layer emitter increases the short circuit current of the cells significantly. Based on the quantum efficiency （QE） results and the current-voltage-temperature analysis, the mechanism for the experimental results above has been investigated. The possible reasons for the increased current include the enhancement of the QE in the short wavelength range, the increase of the tunneling probability of the current transport and the decrease of the activation energy of the emitter layers.

RF-PECVD法制备高Ge含量微晶Si-Ge薄膜及太阳电池

采用射频等离子体增强化学气相沉积(RF-PECVD)技术,研究了衬底温度对高Ge含量(≈50%)微晶Si-Ge(μc-SiGe:H)薄膜结构特性和电学特性的影响。结果表明:较低的衬底温度会抑制μc-SiGe:H薄膜(220)晶向的择优生长;而当衬底温度过高时,μc-SiGe:H薄膜的O含量和微结构因子较大。在衬底温度为200℃时,获得了光电特性和结构特性较优的高Ge含量μc-SiGe:H薄膜。将优化好的μc-SiGe:H薄膜应用到电池中,在本征层为600nm的情况下,获得了转换效率为3.31%(Jsc=22.5mA/cm2,Voc=0.32V,FF=0.46)的单结μc-SiGe:H电池,电池在1 100nm处的光谱响应达5.49%。