Ground-based/UAV-LiDAR data fusion for quantitative structure modeling and tree parameter retrieval in subtropical planted forest

Light detection and ranging(LiDAR)has contributed immensely to forest mapping and 3D tree modelling.From the perspective of data acquisition,the integration of LiDAR data from different platforms would enrich forest information at the tree and plot levels.This research develops a general framework to integrate ground-based and UAV-LiDAR(ULS)data to better estimate tree parameters based on quantitative structure modelling(QSM).This is accomplished in three sequential steps.First,the ground-based/ULS LiDAR data were co-registered based on the local density peaks of the clustered canopy.Next,redundancy and noise were removed for the ground-based/ULS LiDAR data fusion.Finally,tree modeling and biophysical parameter retrieval were based on QSM.Experiments were performed for Backpack/Handheld/UAV-based multi-platform mobile LiDAR data of a subtropical forest,including poplar and dawn redwood species.Generally,ground-based/ULS LiDAR data fusion outperforms ground-based LiDAR with respect to tree parameter estimation compared to field data.The fusion-derived tree height,tree volume,and crown volume significantly improved by up to 9.01%,5.28%,and 18.61%,respectively,in terms of rRMSE.By contrast,the diameter at breast height(DBH)is the parameter that has the least benefits from fusion,and rRMSE remains approximately the same,because stems are already well sampled from ground data.Additionally,particularly for dense forests,the fusion-derived tree parameters were improved compared to those derived from ground-based LiDAR.Ground-based LiDAR can potentially be used to estimate tree parameters in low-stand-density forests,whereby the improvement owing to fusion is not significant.

Vertical Distribution Characteristics of PM2.5 Observed by a Mobile Vehicle Lidar in Tianjin, China in 2016

We present mobile vehicle lidar observations in Tianjin, China during the spring, summer, and winter of 2016. Mobile observations were carried out along the city border road of Tianjin to obtain the vertical distribution characteristics of PM2.5. Hygroscopic growth was not considered since relative humidity was less than 60% during the observation experiments. PM2.5 profile was obtained with the linear regression equation between the particle extinction coefficient and PM2.5 mass concentration. In spring, the vertical distribution of PM2.5 exhibited a hierarchical structure. In addition to a layer of particles that gathered near the ground, a portion of particles floated at 0.6–2.5-km height. In summer and winter, the fine particles basically gathered below 1 km near the ground. In spring and summer, the concentration of fine particles in the south was higher than that in the north because of the influence of south wind. In winter, the distribution of fine particles was opposite to that measured during spring and summer. High concentrations of PM2.5 were observed in the rural areas of North Tianjin with a maximum of 350 μg m^–3 on 13 December2016. It is shown that industrial and ship emissions in spring and summer and coal combustion in winter were the major sources of fine particles that polluted Tianjin. The results provide insights into the mechanisms of haze formation and the effects of meteorological conditions during haze–fog pollution episodes in the Tianjin area.