Multiple Access Techniques for 5G

Over the past few decades, wireless communications have advanced tremendously and have become an indispensable part of our lives. Wireless networks have become more and more pervasive in order to guarantee global digital connectivity. Wireless devices have quickly evolved into multimedia smartphones running applications that demand high-speed and high-quality data connections.

ZTE Communications Special Issue on Multiple Access Techniques for 5G

5G mobile cellular networks are required to provide the significant increase in network throughput, cell-edge data rate, massive connectivity, superior spectrum efficiency, high energy efficiency and low latency, compared with the currently deploying long-term evolution （LTE） and LTE-advanced networks. To meet these challenges of 5G networks, innovative technologies on radio air-interface and radio access network （RAN） are important in PHY design. Recently,

ZTE Communications Special Issue on Multiple Access Techniques for 5G

5G mobile cellular networks are required to provide the significant increase in network throughput,cell-edge data rate,massive connectivity,superior spectrum efficiency,currently deploying long-term evolution(LTE)and LTE-advanced networks.To meet these challenges of 5G networks,

A ROBUST FLOW CALCULATION TECHNIQUE WITH MULTIPLE FINITE CONTROL VOLUMES

The control volume method gives the forces which act on the system, but not necessarily the wall pressure of the system. The author has made an attempt to develop a control volume method which makes it possible to obtain the wall pressure of the control volume. The 2-D inviscid incompressible steady duct flow is considered. The conservation equations in integral form are discretized for a control volume. The circulation along the control surface is expressed as a nonlinear function of the vertical velocity component at the inlet and is set equal to zero for the inviscid flow. The equation is solved by the Newton method, and the other aerodynamic properties can be obtained. The calculated results have been compared to the experiment and the agreement has been found fairly satisfactory.

Bias Correction Technique for Estimating Quantiles of Finite Populations under Simple Random Sampling without Replacement

In this paper, the problem of nonparametric estimation of finite population quantile function using multiplicative bias correction technique is considered. A robust estimator of the finite population quantile function based on multiplicative bias correction is derived with the aid of a super population model. Most studies have concentrated on kernel smoothers in the estimation of regression functions. This technique has also been applied to various methods of non-parametric estimation of the finite population quantile already under review. A major problem with the use of nonparametric kernel-based regression over a finite interval, such as the estimation of finite population quantities, is bias at boundary points. By correcting the boundary problems associated with previous model-based estimators, the multiplicative bias corrected estimator produced better results in estimating the finite population quantile function. Furthermore, the asymptotic behavior of the proposed estimators is presented. It is observed that the estimator is asymptotically unbiased and statistically consistent when certain conditions are satisfied. The simulation results show that the suggested estimator is quite well in terms of relative bias, mean squared error, and relative root mean error. As a result, the multiplicative bias corrected estimator is strongly suggested for survey sampling estimation of the finite population quantile function.

GLOBAL EXISTENCE AND EXPONENTIAL STABILITY OF SOLUTIONS TO THE QUASILINEAR THERMO-DIFFUSION EQUATIONS WITH SECOND SOUND

This article is devoted to the study of global existence and exponential stability of solutions to an initial-boundary value problem of the quasilinear thermo-diffusion equations with second sound by means of multiplicative techniques and energy method provided that the initial data are close to the equilibrium and the relaxation kernel is strongly positive definite and decays exponentially.

Stability of multiple fans in mine ventilation networks

In large mines,single fan is usually not enough to ventilate all the working areas.Single mine-fan approach cannot be directly applied to multiple-fan networks because the present of multiple pressures and air quantities associated with each fan in the network.Accordingly,each fan in a multiple-fan system has its own mine characteristic curve,or a subsystem curve.Under some consideration,the conventional concept of a mine characteristic curve of a single-fan system can be directly extended to that of a particular fan within a multiple-fan system.In this paper the mutual effect of the fans on each other and their effect on the stability of the ventilation network were investigated by Hardy Cross algorithm combined with a switching-parameters technique.To show the validity and reliability of this algorithm,the stability of the ventilation system of Abu-Tartur Mine(one of the largest underground mine in Egypt)has been studied.

Correlation of Critical Micelle Concentration of Sodium Alkyl Benzenesulfonates with MolecularDescriptors

The hydrophobic-hydrophilic segment geometries of 36 sodium alkyl benzenesulfonates were fully optimized and calculated by abinitio RHF/6-31G（d）, quantum chemical data such as the charge density, the energy of molecular orbital and the dipole moment were obtained. Based on two topological descriptors and one quantum chemical descriptor, a significant quantitative structure-property relationship （QSPR） model for the critical micelle concentration （Cmc） of sodium alkyl benzenesulfonate surfactants was obtained by using the multiple linear regression technique. The good correlation coefficient of Re （0. 980） and cross-validation correlation coefficient Rcv^2 （0. 974） indicate the excellent capability and stability of the regression equation developed. In addition, linear relationships between logarithm of Cmc and the dipole moment of surfaetant hydrophobic hydrophilic segments for each homologous series have also been established with high correlation coefficient.

Research and Development of New Chinese Materia Medica for Treatment of Refractory Hematopathy by Establishment and Application of Multiple Technique Platforms

Research Objective and Overview It is necessary to find effective Chinese materia medica （CMM） for the treatment of refractory hematopathy as commonly used prednisone, androgen and immune suppression agents of tendemonstrate poor efficacy and serious side effects.

Atmospheric Drying UHMWPE Membranes via Multiple Stage Extractant Exchange Drying Technique

Ultra-high molecular weight polyethylene(UHMWPE)membranes were prepared by 5 wt%UHMWPE/parafn oil gels via thermally induced phase separation method and dried in air without signifcant collapse.The UHMWPE membranes were annealed at 110℃ for increasing the pores size in order to decrease the capillary forces.Furthermore,a new multiple stage extractant exchange drying(MSEED)technique was adopted to decrease the shrinkage of the UHMWPE membranes.Specifcally,the parafn oil was extracted by dichloromethane,then dichloromethane was replaced by ethanol,next ethanol could be exchanged to other liquid which is non-afnity with UHMWPE,for example water.UHMWPE membranes(annealing for 25 min)dried by dichloromethane-ethanol-water-air process have the lowest volume shrinkage of 16.5%and the porosity is as high as 88.29%.Moreover,compared with supercritical CO_(2)(SC-CO_(2))drying,atmospheric drying UHMWPE membranes have a lower pure water permeance,but a higher carbon particles rejection.

Designing Optimal Large Four-Level Experiments:A New TechniqueWithout Recourse to Optimization Softwares

Experimental design is an effective statistical tool that is extensively applied in modern industry,engineering,and science.It is proved that experimental design is a powerful and efficient means to screen the relationships between input factors and their responses,and to distinguish significant and unimportant factor effects.In many practical situations,experimenters are faced with large experiments having four-level factors.Even though there are several techniques provided to design such experiments,the challenge faced by the experimenters is still daunting.The practice has demonstrated that the existing techniques are highly time-consuming optimization procedures,satisfactory outcomes are not guaranteed,and non-mathematicians face a significant challenge in dealing with them.A new technique that can overcome these defects of the existing techniques is presented in this paper.The results demonstrated that the proposed technique outperformed the current techniques in terms of construction simplicity,computational efficiency and achieving satisfactory results capability.For non-mathematician experimenters,the new technique is much easier and simpler than the current techniques,as it allows them to design optimal large experiments without the recourse to optimization softwares.The optimality is discussed from four basic perspectives:maximizing the dissimilarity among experimental runs,maximizing the number of independent factors,minimizing the confounding among factors,and filling the experimental domain uniformly with as few gaps as possible.

Removal of arsenate with hydrous ferric oxide coprecipitation: Effect of humic acid

Insights from the adverse effect of humic acid （HA） on arsenate removal with hydrous ferric oxide （HFO） coprecipitation can further our understanding of the fate of As（V） in water treatment process. The motivation of our study is to explore the competitive adsorption mechanisms of humic acid and As（V） on HFO on the molecular scale. Multiple complementary techniques were used including macroscopic adsorption experiments, surface enhanced Raman scattering （SERS）, extended X-ray absorption fine structure （EXAFS） spectroscopy, flow-cell attenuated total reflectance Fourier transform infrared （ATR-FTIR） measurement, and charge distribution multisite complexation （CD- MUSIC） modeling. The As（V） removal efficiency was reduced from over 95% to about 10% with the increasing HA concentration to 25 times of As（V） mass concentration. The SERS analysis excluded the HA-As（V） complex formation. The EXAFS results indicate that As（V） formed bidentate binuclear surface complexes in the presence of HA as evidenced by an As-Fe distance of 3.26--3.31 ,~. The in situ ATR-FTIR measurements show that As（V） replaces surface hydroxyl groups and forms inner- sphere complex. High concentrations of HA may physically block the surface sites and inhibit the As（V） access. The adsorption of As（V） and HA decreased the point of zero charge of HFO from 7.8 to 5.8 and 6.3, respectively. The CD-MUSIC model described the zeta potential curves and adsorption edges of As（V） and HA reasonably well.

Analytical study of friction coefficients of pomegranate seed as essential parameters in design of post-harvest equipment

Friction coefficients(static friction coefficient(SFC)and dynamic friction coefficient(DFC))of pomegranate seed on different structural surfaces(glass,aluminum,plywood,galvanized steel and rubber)as affected by moisture content(4-21.9%(d.b.))and sliding velocity(1.4-16(cm/s))were investigated.Analysis of variance(ANOVA)was performed to determine the effect of main treatments and their interactions on SFC and DFC.Significance of single or multiple effect of the main treatments with five levels was assessed using Duncan’s multiple range test(DMRT).To predict SFC and DFC,multiple linear regression(MLR)modeling technique was applied for each type of structural surface.The goodness of fit of each MLR model was evaluated using statistical parameters:coefficient of determination,root mean square error and mean relative deviation modulus.Results showed that the minimum and maximum SFC or DFC were in minimum and maximum moisture content on glass and rubber surface,respectively.ANOVA table indicated the significant effect of main treatments and their interactions on SFC and DFC at significance level of 1%(P<0.01).According to DMRT results,SFC linearly increased as moisture content increased and DFC increased also linearly as individual or simultaneous increment of moisture content and sliding velocity occurred,for all experimental conditions.According to the obtained statistical parameters,both SFC and DFC were properly predicted by means of MLR modeling technique.