Performance enhancement of a viscoelastic bistable energy harvester using time-delayed feedback control

This paper focuses on the stochastic analysis of a viscoelastic bistable energy harvesting system under colored noise and harmonic excitation, and adopts the time-delayed feedback control to improve its harvesting efficiency. Firstly, to obtain the dimensionless governing equation of the system, the original bistable system is approximated as a system without viscoelastic term by using the stochastic averaging method of energy envelope, and then is further decoupled to derive an equivalent system. The credibility of the proposed method is validated by contrasting the consistency between the numerical and the analytical results of the equivalent system under different noise conditions. The influence of system parameters on average output power is analyzed, and the control effect of the time-delayed feedback control on system performance is compared. The output performance of the system is improved with the occurrence of stochastic resonance(SR). Therefore, the signal-to-noise ratio expression for measuring SR is derived, and the dependence of its SR behavior on different parameters is explored.

Modeling of temperature-humidity for wood drying based on time-delay neural network

The temperature-humidity models of wood drying were developed based on Time-delay neural network and the identification structures of Time-delay neural network were given. The controlling model and the schedule model, which revealed the relation between controlling signal and temperature-humidity and the relation between wood moisture content and temperature-humidity of wood drying, were separately presented. The models were simulated by using the measured data of the experimental drying kiln. The numerical simulation results showed that the modeling method was feasible, and the models were effective.

Behavioral modeling of RF power amplifiers with time-delay feed-forward neural networks

A novel behavioral model using three-layer time-delay feed-forward neural networks （TDFFNN）is adopted to model radio frequency （RF）power amplifiers exhibiting memory nonlinearities. In order to extract the parameters, the back- propagation algorithm is applied to train the proposed neural networks. The proposed model is verified by the typical odd- order-only memory polynomial model in simulation, and the performance is compared with different numbers of taped delay lines（TDLs） and perceptrons of the hidden layer. For validating the TDFFNN model by experiments, a digital test bench is set up to collect input and output data of power amplifiers at a 60 × 10^6 sample/s sampling rate. The 3.75 MHz 16-QAM signal generated in the vector signal generator（VSG） is chosen as the input signal, when measuring the dynamic AM/AM and AM/PM characteristics of power amplifiers. By comparisons and analyses, the presented model provides a good performance in convergence, accuracy and efficiency, which is approved by simulation results and experimental results in the time domain and frequency domain.

PD-type iterative learning control for nonlinear time-delay system with external disturbance

The PD-type iterative learning control design of a class of affine nonlinear time-delay systems with external disturbances is considered. Sufficient conditions guaranteeing the convergence of the n-norm of the tracking error are derived. It is shown that the system outputs can be guaranteed to converge to desired trajectories in the absence of external disturbances and output measurement noises. And in the presence of state disturbances and measurement noises, the tracking error will be bounded uniformly. A numerical simulation example is presented to validate the effectiveness of the proposed scheme.

Parameter design for a vibration absorber with time-delayed feedback control

Traditional passive vibration absorbers are effective only when their natural frequencies are close to those of the excitations. To solve this problem, a vibration absorber with time-delayed feedback control is proposed to suppress vibration of the primary system under excitation with changing frequency. Firstly, the mechanical model of the delay coupled system is established. Then, the displacement transfer ratio of the system is obtained. The stability of the system is analyzed since delay may result in destabilization. Next, in order to design the control parameters, the vibration absorption performances of the proposed time-delayed vibration absorber are studied. The vibration absorption region is shown. The results show that time-delayed feedback control is able to change the response of the system. The effective vibration absorption frequency band is adjustable by tuning the control gain and time delay. The effective frequency band can be widened when choosing appropriate control parameters. The vibration absorption performances can be greatly improved by the time-delayed absorber. In addition, the optimum control parameters are obtained. Finally, the experimental prototype is constructed. Several tests with different control parameters are taken. The experimental and analytical results match quite well.

Novel Stability Criteria for Linear Time-Delay Systems Using Lyapunov-Krasovskii Functionals With A Cubic Polynomial on Time-Varying Delay

One of challenging issues on stability analysis of time-delay systems is how to obtain a stability criterion from a matrix-valued polynomial on a time-varying delay.The first contribution of this paper is to establish a necessary and sufficient condition on a matrix-valued polynomial inequality over a certain closed interval.The degree of such a matrix-valued polynomial can be an arbitrary finite positive integer.The second contribution of this paper is to introduce a novel LyapunovKrasovskii functional,which includes a cubic polynomial on a time-varying delay,in stability analysis of time-delay systems.Based on the novel Lyapunov-Krasovskii functional and the necessary and sufficient condition on matrix-valued polynomial inequalities,two stability criteria are derived for two cases of the time-varying delay.A well-studied numerical example is given to show that the proposed stability criteria are of less conservativeness than some existing ones.

An Improved Approach to Delay-dependent Robust Stabilization for Uncertain Singular Time-delay Systems

In this paper, delay-dependent stability analysis and robust stabilization for uncertain singular time-delay systems are addressed. By using Jensen integral inequality, an improved delay-dependent criterion of admissibility for singular time-delay systems is proposed in terms of linear matrix inequality （LMI）. Our new proposed criterion is less conservative and the numerical complexity is smaller than the existing ones. Based on this criterion, a state feedback controller is designed to ensure that the uncertain singular time-delay system is admissible. Finally, three numerical examples are employed to illustrate the effectiveness of the proposed method.

An LMI approach to robust H-infinity control for uncertain singular time-delay systems

The problem of robust H-infinity control for a class of uncertain singular time-delay systems is studied in this paper. A new approach is proposed to describe the relationship between slow and fast subsystems of singular time- delay systems, based on which, a sufficient condition is presented for a singular time-delay system to be regular, impulse free and stable with an H-infinity performance. The robust H-infinity control problem is solved and an explicit expression of the desired state-feedback control law is also given. The obtained results are formulated in terms of strict linear matrix inequalities （LMIs） involving no decomposition of system matrices. A numerical example is given to show the effectiveness of the proposed method.

IMC-PID tuning method based on sensitivity specification for process with time-delay

To overcome the deficiencies addressed in the conventional PID control and improve the dynamic performance and robustness of the system, a simple design and parameters tuning approach of internal model control-PID （IMC-PID） controller was proposed for the first order plus time-delay （FOPTD） process and the second order plus time-delay （SOPTD） process. By approximating the time-delay term of the process model with the first-order Taylor series, the expressions for IMC-PID controller parameters were derived, and they had only one adjustable parameter 2 which was directly related to the dynamic performance and robustness of the system. Moreover, an analytical approach of selecting 2 was given based on the maximum sensitivity Ms. Then, the robust tuning of the system could be achieved according to the value of Ms. In addition, the proposed method could be extended to the integrator plus time-delay （IPTD） process and the first order delay integrating （FODI） process. Simulation studies were carried out on various processes with time-delay, and the results show that the proposed method could provide a better dynamic performance of both the set-point tracking and disturbance rejection and robustness against parameters perturbation.

Decentralized robust guaranteed cost control for a class of interconnected singular large-scale systems with time-delay and parameter uncertainty

The decentralized robust guaranteed cost control problem is studied for a class of interconnected singular large-scale systems with time-delay and norm-bounded time-invariant parameter uncertainty under a given quadratic cost performance function. The problem that is addressed in this study is to design a decentralized robust guaranteed cost state feedback controller such that the closed-loop system is not only regular, impulse-free and stable, but also guarantees an adequate level of performance for all admissible uncertainties. A sufficient condition for the existence of the decentralized robust guaranteed cost state feedback controllers is proposed in terms of a linear matrix inequality （LMI） via LMI approach. When this condition is feasible, the desired state feedback decentralized robust guaranteed cost controller gain matrices can be obtained. Finally, an illustrative example is provided to demonstrate the effectiveness of the proposed approach.

Stochastic resonance in a time-delayed bistable system subject to multiplicative and additive noise

This paper investigates the stochastic resonance in a time-delayed bistable system subjected to multiplicative and additive white noise and asymmetric dichotomous noise. Under the adiabatic approximation condition, the expression of the signal-to-noise ratio （SNR） is obtained. It finds that the SNR is a non-monotonic function of the delayed times, of the amplitude of the driving square-wave signal, as well as of the asymmetry of the dichotomous noise. In addition, the SNR varies non-monotonously with the intensities of the multiplicative and additive noise as well as the system parameters. Moreover, the SNR depends non-monotonically on the correlate rate of the dichotomous noise.

Analysis of Absolute Stability for Time-delay Teleoperation Systems

In this paper, a new bilateral control algorithm based on absolute stability theory is put forward, which aims at the time-delay teleoperation system with force feedback from the slave directly. In the new control algorithm, the delay-dependent stability, instead of delay-independent stability, is taken as the aim of control design. It improves the transparency of the system at the price of unnecessary stability. With this algorithm, the time-delay teleoperation systems have good transparency and stability. A simulation system is established to verify the effect of this algorithm.

Active Fault Tolerant Control of a Class of Nonlinear Time-Delay Processes

Based on a nonlinear state predictor (NSP) and a strong tracking filter (STF), a sensor fault tolerant generic model control (FTGMC) approach for a class of nonlinear time-delay processes is proposed. First, the NSP is introduced, and it is used to extend the conventional generic model control (GMC) to nonlinear processes with large input time-delay. Then the STF is adopted to estimate process states and sensor bias, the estimated sensor bias is used to drive a fault detection logic. When a sensor fault is detected, the estimated process states by the STF will be used to construct the process output to form a 'soft sensor', which is then used by the NSP (instead of the real outputs) to provide state predictors. These procedures constitute an active fault tolerant control scheme. Finally, simulation results of a three-tank-system demonstrate the effectiveness of the proposed approach.

On the order of stable compensators for a class of time-delay system

The stabilization using a stable compensator does not introduce additional unstable zeros into the closed-loop transfer function beyond those of the original plant, so it is a desirable compensator, the price is that the compensator’s order will go up. This note considered the order of stable compensators for a class of time-delay systems. First, it is shown that for single-loop plants with at most one real right-half plane zero, a special upper bound for the minimal order of a strongly stabilizing compensator can be obtained in terms of the plant order; Second, it is shown that approximate unstable pole-zero cancellation does not occur, and the distances between distinct unstable zeroes are bounded below by a positive constant, then it is possible to find an upper bound for the minimal order of a strongly stabilizing compensator.

On Delay-independent Stability Criteria for Linear Time-delay Systems

Several LMI representations for delay-independence stability are proposed by applying Projection Lemma and the socalled ＂Small Scalar Method＂. These criteria realize the elimination of the products coupling the system matrices and Lyapunov matrices by introducing some additional matrices. When they are applied to robust stability analysis for polytopic uncertain systems, the vertex-dependent Lyapunov functions are allowed, so less conservative results can be obtained. A numerical example is employed to illustrate the effect of these proposed criteria.

Observer-based robust predictive control of singular systems with time-delay and parameter uncertainties

The problem of observer-based robust predictive control is studied for the singular systems with norm-bounded uncertainties and time-delay, and the design method of robust predictive observer-based controller is proposed. By constructing the Lyapunov function with the error terms, the infinite time domain ＂min-max＂ optimization problems are converted into convex optimization problems solving by the linear matrix inequality （LMI）, and the sufficient conditions for the existence of this control are derived. It is proved that the robust stability of the closed-loop singular systems can be guaranteed by the initial feasible solutions of the optimization problems, and the regular and the impulse-free of the singular systems are also guaranteed. A simulation example illustrates the efficiency of this method.

Robust adaptive control for interval time-delay systems

This paper focuses on the robust adaptive control problems for a class of interval time-delay systems and a class of large-scale interconnected systems. The nonlinear uncertainties of the systems under study are bounded by high- order polynomial functions with unknown gains. Firstly, the adaptive feedback controller which can guarantee the stability of the closed-loop system in the sense of uniform ultimate boundedness is proposed. Then the proposed adaptive idea is extended to robust stabilizing designing method for a class of large-scale interconnected systems. Here, another problem we address is to design a decentralized feedback adaptive controller such that the closed-loop system is stable in the sense of uniform ultimate boundedness for all admissible uncertainties and time-delay. Finally, an illustrative example is given to show the validity of the proposed approach.

Stochastic resonance in a time-delayed mono-stable system with correlated multiplicative and additive white noise

This paper considers the stochastic resonance for a time-delayed mono-stable system, driven by correlated multiplicative and additive white noise. It finds that the output signal-to-noise ratio （SNR） varies non-monotonically with the delayed times. The SNR varies non-monotonically with the increase of the intensities of the multiplicative and additive noise, with the increase of the correlation strength between the two noises, as well as with the system parameter.

Effects of time-delayed vibration absorber on bandwidth of beam for low broadband vibration suppression

The effects of time-delayed vibration absorber(TDVA) on the dynamic characteristics of a flexible beam are investigated. First, the vibration suppression effect of a single TDVA on a continuous beam is studied. The first optimization criterion is given,and the results show that the introduction of time-delayed feedback control(TDFC) is beneficial to improving the vibration suppression at the anti-resonance band. When a single TDVA is used, the anti-resonance is located at a specific frequency by the optimum design of TDFC parameters. Then, in order to obtain low-frequency and broad bands for vibration suppression, multiple TDVAs are uniformly distributed on a continuous beam,and the relationship between the dynamic responses and the TDFC parameters is investigated. The obtained relationship shows that the TDVA has a significant regulatory effect on the vibration behavior of the continuous beam. The effects of the number of TDVAs and the nonlinearity on the bandgap variation are discussed. As the multiple TDVAs are applied, according to the different requirements on the location and bandwidth of the effective vibration suppression band, the optimization criteria for the TDFC parameters are given, which provides guidance for the applications of TDVAs in practical projects such as bridge and aerospace.

Stability analysis and design of time-delay uncertain systems using robust reliability method

A robust reliability method for stability analysis and reliability-based stabilization of time-delay dynamic systems with uncertain but bounded parameters is presented by treating the uncertain parameters as interval variables.The performance function used for robust reliability analysis is defined by a delayindependent stability criterion.The design of robust controllers is carried out by solving a reliability-based optimization problem in which the control cost satisfying design requirements is minimized.This kind of treatment makes it possible to achieve a balance between the reliability and control cost in the design of controller when uncertainties must be taken into account.By the method,a robust reliability measure of the degree of stability of a time-delay uncertain system can be provided,and the maximum robustness bounds of uncertain parameters such that the time-delay system to be stable can be obtained.All the procedures are based on the linear matrix inequality approach and therefore can be carried out conveniently.The effectiveness and feasibility of the proposed method are demonstrated with two practical examples.It is shown by numerical simulations and comparison that it is meaningful to take the robust reliability into account in the control design of uncertain systems.