Linear magnetoresistance and structural distortion in layered SrCu_(4-x)P_(2) single crystals

We report a systematic study on layered metal SrCu_(4-x)P_(2) single crystals via transport, magnetization, thermodynamic measurements and structural characterization. We find that the crystals show large linear magnetoresistance without any sign of saturation with a magnetic field up to 30T. We also observe a phase transition with significant anomalies in resistivity and heat capacity at T_(p)~140 K. Thermal expansion measurement reveals a subtle lattice parameter variation near Tp, i.e.,?L_(c)/L_(c)~0.062%. The structural characterization confines that there is no structure transition below and above T_(p). All these results suggest that the nonmagnetic transition of SrCu_(4-x)P_(2) could be associated with structural distortion.

Some inequalities for the generalized linear distortion function

In this paper, we establish several inequalities for the the generalized linear distortion function λ（a, K） by using the monotonicity and convexity of certain combinations λ（a, K）.

The Existence of Meromorphic Solutions to Non-Linear Delay Differential Equations

In this paper, we study the existence of the transcendental meromorphic solution of the delay differential equations , where a(z) is a rational function, and are polynomials in w(z) with rational coefficients, k is a positive integer. Under the assumption when above equations own transcendental meromorphic solutions with minimal hyper-type, we derive the concrete conditions on the degree of the right side of them. Specially, when w(z)=0 is a root of , its multiplicity is at most k. Some examples are given here to illustrate that our results are accurate.

FAREY SEQUENCE OF NONLINEAR DIFFERENTIAL DYNAMIC SYSTEM IN TWO DIMENSIONS

In this paper , through the discrim ination of Farey sequence in the forced Brusselator withweak coupling , it is proved that there is a topological translation fro m a nonlinear differen tial system ( limit cycle) to the circle m ap .

Characteristics of the Main Journal Bearings of an Engine Based on Non-linear Dynamics

Many simple nonlinear main journal bearing models have been studied theoretically, but the connection to existing engineering system has not been equally investigated. The consideration of the characteristics of engine main journal bearings may provide a prediction of the bearing load and lubrication. Due to the strong non-linear features in bearing lubrication procedure, it is difficult to predict those characteristics. A non-linear dynamic model is described for analyzing the characteristics of engine main journal bearings. Components such as crankshaft, main journals and con rods are found by applying the finite element method. Non-linear spring/dampers are introduced to imitate the constraint and supporting functions provided by the main bearing and oil film. The engine gas pressure is imposed as excitation on the model via the engine piston, con rod, etc. The bearing reaction force is calculated over one engine cycle, and meanwhile, the oil film thickness and pressure distribution are obtained based on Reynolds differential equation. It can be found that the maximum bearing reaction force always occurs when the maximum cylinder pressure arises in the cylinder adjacent to that bearing. The simulated minimum oil film thickness, which is 3 μm, demonstrates the reliability of the main journal bearings. This non-linear dynamic analysis may save computing efforts of engine main bearing design and also is of good precision and close connection to actual engine main journal bearing conditions.

A Non-linear Non-ideal Model of Simulated Moving Bed Chromatography for Chiral Separations

A non-linear non-ideal model,taking into account non-linear competitive isotherms,axial disperison,film mass transfer,intraparticle diffusion,and port periodic switching,was developed to simulate the dynamics of simulated moving bed chromatography(SMBC),The model equations were solved by a new efficient numerical technique of orthogonal collocation on finite elements with periodical movement of conceantration vector,The simulated SMBC performance is in accordance with the experimental results reported in the literature for separation of 1,1''''''''-bi-2-naphtol enantiomers using SMBC,This model is useful for design,operation ,optimization and scale-up of non-linear SMBC for chiral separations with significant non-ideal effects,especially for high solute concentration and small intraparticle diffusion coefficient or large chiral stationary phase particle.

Energy analysis of stability on shallow tunnels based on non-associated flow rule and non-linear failure criterion

On the basis of upper bound theorem, non-associated flow rule and non-linear failure criterion were considered together.The modified shear strength parameters of materials were obtained with the help of the tangent method. Employing the virtual power principle and strength reduction technique, the effects of dilatancy of materials, non-linear failure criterion, pore water pressure,surface loads and buried depth, on the stability of shallow tunnel were studied. In order to validate the effectiveness of the proposed approach, the solutions in the present work agree well with the existing results when the non-associated flow rule is reduced to the associated flow rule and the non-linear failure criterion is degenerated to the linear failure criterion. Compared with dilatancy of materials, the non-linear failure criterion exerts greater impact on the stability of shallow tunnels. The safety factor of shallow tunnels decreases and the failure surface expands outward when the dilatancy coefficient decreases. While the increase of nonlinear coefficient, the pore water pressure coefficient, the surface load and the buried depth results in the small safety factor. Therefore, the dilatancy as well as non-linear failure criterion should be taken into account in the design of shallow tunnel supporting structure. The supporting structure must be reinforced promptly to prevent potential mud from gushing or collapse accident in the areas with abundant pore water, large surface load or buried depth.

NON-LINEAR FORCED VIBRATION OF AXIALLY MOVING VISCOELASTIC BEAMS

The non-linear forced vibration of axially moving viscoelastic beams excited by the vibration of the supporting foundation is investigated. A non-linear partial-differential equation governing the transverse motion is derived from the dynamical, constitutive equations and geometrical relations. By referring to the quasi-static stretch assumption, the partial-differential non-linearity is reduced to an integro-partial-differential one. The method of multiple scales is directly applied to the governing equations with the two types of non-linearity, respectively. The amplitude of near- and exact-resonant steady state is analyzed by use of the solvability condition of eliminating secular terms. Numerical results are presented to show the contributions of foundation vibration amplitude, viscoelastic damping, and nonlinearity to the response amplitude for the first and the second mode.

ON THE HOLOMORPHIC SOLUTION OF NON-LINEAR TOTALLY CHARACTERISTIC EQUATIONS WITH SEVERAL SPACE VARIABLES

In this paper the authors study a class of non-linear singular partial differential equation in complex domain C-t x C-x(n). Under certain assumptions, they prove the existence and uniqueness of holomorphic solution near origin of C-t x C-x(n).

Nonlinear analysis of traffic jams in an anisotropic continuum model

This paper presents our study of the nonlinear stability of a new anisotropic continuum traffic flow model in which the dimensionless parameter or anisotropic factor controls the non-isotropic character and diffusive influence. In order to establish traff^c flow stability criterion or to know the critical parameters that lead, on one hand, to a stable response to perturbations or disturbances or, on the other hand, to an unstable response and therefore to a possible congestion, a nonlinear stability criterion is derived by using a wavefront expansion technique. The stability criterion is illustrated by numerical results using the finite difference method for two different values of anisotropic parameter. It is also been observed that the newly derived stability results are consistent with previously reported results obtained using approximate linearisation methods. Moreover, the stability criterion derived in this paper can provide more refined information from the perspective of the capability to reproduce nonlinear traffic flow behaviors observed in real traffic than previously established methodologies.

UNBALANCE RESPONSE AND TOUCH-RUBBING THRESHOLD SPEED OF ROTOR SUBJECTED TO NONLINEAR MAGNETIC FORCES

Because of the effect of unbalance excitation and nonlinear magnetic force, the large vibration of the rotor supported by active magnetic bearing（AMB） will go beyond the radial gap of the bearing, even causing mechanical touch-rubbing when the system works at an operational speed closer to the critical speed. In order to investigate this problem, the linear model and nonlinear model of the single mass symmetric rigid rotor system supported by AMB are established respectively and the corresponding transfer functions of close-loop system are given. To pass through the numerical calculation by using MATLAB/Simulink, the effect of both the unbalance response and threshold speed of touch-rubbing of the system subjected to nonlinear magnetic forces and nonlinear output current of power amplifier are studied. Furthermore, threshold speed of touch-rubbing of the rotor-bearing system is defined and the results of numerical simulation are presented. Finally, based on above studies, two methods of increasing the touch-rubbing threshold speed are discussed.

Classical and nonclassical symmetry classifications of nonlinear wave equation with dissipation

A complete classical symmetry classification and a nonclassical symmetry classification of a class of nonlinear wave equations are given with three arbitrary parameter functions. The obtained results show that such nonlinear wave equations admit richer classical and nonclassical symmetries, leading to the conservation laws and the reduction of the wave equations. Some exact solutions of the considered wave equations for particular cases are derived.

Non-linear Chemical Process Modelling and Application in Epichlorhydrine Production Plant Using Wavelet Networks

A type of wavelet neural network, in which the scale function is adopted only,is proposed in this paper for non-linear dynamic process modelling.Its network size is decreased significantly and the weight coefficients can be estimated by a linear algorithm.The wavelet neural network holds some advantages supeiior to other types of neural networks.First, its network structure is easy to specify based on its theoretical analysis and intuition.Secondly, network training does not rely on stochastic gradient type techniques and avoidd the problem of poor convergence or undesirable local minima.The excellent statistic properties of the weight parameter estimations can be proven here.Both theoretical analysis and simulation study show that the identification method is robust and reliable. Furthermore,a hybrid network structure incorporating first-principle knowledge and wavelet network is developed to solve a commonly existing problem in chemical production processes.Applications of the hybrid network to a practical production process demonstrates that model generalisation capability is significantly improved.

Heavy metals adsorption by banana peels micro-powder: Equilibrium modeling by non-linear models

In this study the copper and lead adsorption efficiency onto banana peels powder was investigated. The agroindustrial waste recovery represents one of the Circular Economy pillars. In the view of the synthesis of an environmentally friendly adsorbent material, the powder was used without any preliminary chemical or thermal activation, but only after simple washing, drying and grinding. The bio-adsorbent was characterized by the FTIR technique and tested in batch mode on synthetic aqueous solutions containing Pb and Cu in the range 10–90 mg·L^(-1). A selection of two(Langmuir, Freundlich) and three(Sips, Redlich–Peterson, Koble–Corrigan) parameter isotherm models was chosen to fit adsorption equilibrium data by non-linear regression procedure. The best fit isotherm model was selected relying on the error function with the lowest average percentage error(APE) value, among those characterized by the highest R^2 values. As expected, the three-parameter models are found to better represent both metals bio-adsorption, with APE and R^2 values always lower and higher, respectively, than the corresponding values obtained for the two-parameter models.

Particle swarm optimization based RVM classifier for non-linear circuit fault diagnosis

A relevance vector machine (RVM) based fault diagnosis method was presented for non-linear circuits. In order to simplify RVM classifier, parameters selection based on particle swarm optimization (PSO) and preprocessing technique based on the kurtosis and entropy of signals were used. Firstly, sinusoidal inputs with different frequencies were applied to the circuit under test (CUT). Then, the resulting frequency responses were sampled to generate features. The frequency response was sampled to compute its kurtosis and entropy, which can show the information capacity of signal. By analyzing the output signals, the proposed method can detect and identify faulty components in circuits. The results indicate that the fault classes can be classified correctly for at least 99% of the test data in example circuit. And the proposed method can diagnose hard and soft faults.

Blind channel identication of nonlinear folding mixing model

Signals from multi-sensor systems are often mixtures of （statistically） independent sources by unknown mixing method. Blind source separation（BSS） and independent component analysis（ICA） are the methods to identify/recover the channels and the sources. BSS/ICA of nonlinear mixing models are difficult problems. For instance, the post-nonlinear model has been studied by several authors. It is noticed that in most cases, the proposed models are always with an invertible mixing. According to this fact there is an interesting question, how about the situation of the non-invertible non-linear mixing in BSS or ICA？ A new simple non-linear mixing model is proposed with a kind of non-invertible mixing, the folding mixing, and method to identify its channel, blindly.

Dynamic Response Analysis of Bird Strike on Aircraft Windshield Based on Damage-modified Nonlinear Viscoelastic Constitutive Relation

Damage-modified nonlinear viscoelastic constitutive equation and failure criterion are introduced and the three-dimensional incremental forms are deduced based on the updated Lagrangian approach. A simple tensile test model and a split Hopkinson pressure bar model are built to verify the accuracy of the subroutine implemented within the non-linear finite element program LS-DYNA. A numerical model of bird strike on windshield is established to study the responses of windshield under three different bird velocities at three sites. The bird is represented by a cylinder with a hemisphere at each end and the contact-impact coupling algorithm is used in this study. It is found that the implemented subroutine can properly describe the mechanical behavior of polymethyl methaerylate under low and high strain rates and large deformation, and can be used validly.

The SPH approach to the process of container filling based on non-linear constitutive models

In this work, the transient free surface of con- tainer filling with non-linear constitutive equation＇s fluids is numerically investigated by the smoothed particle hydrody- namics （SPH） method. Specifically, the filling process of a square container is considered for non-linear polymer fluids based on the Cross model. The validity of the presented SPH is first verified by solving the Newtonian fluid and Oldroyd- B fluid jet. Various phenomena in the filling process are shown, including the jet buckling, jet thinning, splashing or spluttering, steady filling. Moreover, a new phenomenon of vortex whirling is more evidently observed for the Cross model fluid compared with the Newtonian fluid case.

Numerical Simulation of Non-Linear Wave Propagation in Waters of Mildly Varying Topography with Complicated Boundary

In this paper, the characteristics of different forms of mild slope equations for non-linear wave are analyzed, and new non-linear theoretic models for wave propagation are presented, with non-linear terms added to the mild slope equations for non-stationary linear waves and dissipative effects considered. Numerical simulation models are developed of non-linear wave propagation for waters of mildly varying topography with complicated boundary, and the effects are studied of different non-linear corrections on calculation results of extended mild slope equations. Systematical numerical simulation tests show that the present models can effectively reflect non-linear effects.

Comparative efficiency analysis of different nonlinear modelling strategies to simulate the biaxial response of RC columns

The performance of different nonlinear modelling strategies to simulate the response of RC columns subjected to axial load combined with cyclic biaxial horizontal loading is compared. The models studied are classified into two categories according to the nonlinearity distribution assumed in the elements： lumped-plasticity and distributed inelasticity. For this study, results of tests on 24 columns subjected to cyclic uniaxial and biaxial lateral displacements were numerically reproduced. The analyses show that the global envelope response is satisfactorily represented with the three modelling strategies, but significant differences were found in the strength degradation for higher drift demands and energy dissipation.