Experimental Study on Wear Performance and Oil Film Characteristics of Surface Textured Cylinder Liner in Marine Diesel Engine

It is of a vital importance to reduce the frictional losses in marine diesel engines. Advanced surface textures have provided an e ective solution to friction performance of rubbing pairs due to the rapid development of surface engineering techniques. However,the mechanisms through which textured patterns and texturing methods prove beneficial remains unclear. To address this issue,the tribological system of the cylinder liner?piston ring(CLPR) is investigated in this work. Two types of surface textures(Micro concave,Micro V?groove) are processed on the cylinder specimen using di erent processing methods. Comparative study on the friction coe cients,worn surface texture features and oil film characteristics are performed. The results demonstrate that the processing method of surface texture a ect the performance of the CLPR pairs under the specific testing conditions. In addition the micro V?groove processed by CNCPM is more favorable for improving the wear performances at the low load,while the micro?con?cave processed by CE is more favorable for improving the wear performances at the high load. These findings are in helping to understand the e ect of surface texture on wear performance of CLPR.

Geochemical Characteristics and Migration Pathways of Ordovician Carbonate Oil Reservoirs in the Tuoputai Area,Tarim Basin,Northwestern China

Exploration potential is huge and the oil resources are rich in the Ordovician reservoirs of the Tarim Basin.However,the mechanism of hydrocarbon accumulation is complex and not yet fully understood.In the Tuoputai area,the hydrocarbon migration pathways and characteristics of deep hydrocarbon accumulation are revealed through analyses of the physical data of rich oil and gas,the geochemical parameters of oil,and fluid inclusions.The results show that the Ordovician oils in the Tuoputai area have the same geochemical characteristics as the mixed oil from the Lower Cambrian source rock and the Middle–Upper Ordovician source rock.The Ordovician reservoirs have been charged three times:in the late Caledonian,late Hercynian,and Himalayan stages.Oil charging occurred in the Hercynian stage,in particular,as it is the main filling period of hydrocarbon.The north-northeast(NNE)-trending TP12 CX major fault,active in in these times and is dominant migration channel of hydrocarbon,but there is segmentation affected by the difference of activities.Oil maturity is higher in the south than in the north and is abnormally high near the major fault.Parameters related to migration indicate that oil migrated northeastward along the NNE-trending TP12 CX major fault and adjusted laterally along the secondary faults and weathering crust,forming the present characteristics of oil and gas distribution.

Research on oil film characteristics of piston pair in swash plate axial piston pump

The research on the oil film characteristic of piston pair is beneficial to the design and optimization of friction pair,which can improve the performance of piston pump.The fluid pressure of piston cavity is accurately obtained by AMEsim simulation.Oil film thickness field model of piston pair under the slanting state of piston is established,and the distribution law is numerically analyzed under different speed and pressure by Matlab.The experiment model pump for oil film characteristic of piston pair is designed to measure oil film thickness under the pressure of 18 MPa.The experiment results show that oil film thickness varies greatly under high pressure,and oil film thickness fluctuates sharply under low speed.The minimum oil film thickness increases with spindle speed increasing and oil film characteristic of piston pair based on the numerical analysis method is verified.This method lays a foundation for studying the friction performance of piston pair in the axial piston pump.

Experimental study of C-band microwave scattering characteristics during the emulsification process of oil spills

In this study,oil spill experiments were performed in a water tank to determine changes in the surface scattering characteristics during the emulsification of oil spills.A C-band fully-polarimetric microwave scatterometer and a vector network analyzer were used to observe films of the following oils:crude oil with an asphalt content below3%that is prone to emulsification(type A),fresh crude oil extracted from an oilfield(type B),and industrial crude oil that was dehydrated and purified(type C).The difference in the backscatter results between the emulsified oil film and the calm water surface under C-band microwaves and the influence of the emulsification of the oil film on the backscatter were analyzed in detail.The results demonstrate that under a low-wind and no-waves condition(the maximum wave height was below than 3 mm),the emulsification of crude oil could modulated the backscatter through changes in the surface roughness and the dielectric constant,where the surface roughness had the dominant effect.The surface backscatters of the type B oil were greater than that of the type C oil in both the emulsified and non-emulsified states.In the non-emulsified state,the average differences in the backscatter between the type B and C oils were 2.19 dB,2.63 dB,and 2.21 dB for the polarization modes of VV,HH,and HV/VH,respectively.Smaller corresponding average differences of 0.98 dB,1.49 dB,and 1.5 dB were found for the emulsified state with a 20%moisture constant for the oil film.The results demonstrated that the surface roughness of the different oil films could vary due to the differences in the oil compositions and the oil film properties,which in turn affect the backscatter of the oil film surface.

Control Factors and Diversities of Phase State of Oil and Gas Pools in the Kuqa Petroleum System

Based on the analysis of the hydrocarbon geochemical characteristics in the Kuqa petroleum system of the Tarim Basin, this study discusses the causes and controlling factors of the phase diversities and their differences in geochemical features. According to the characteristics and differences in oil and gas phase, the petroleum system can be divided into five categories： oil reservoir, wet gas reservoir, condensate gas-rich reservoir, condensate gas-poor reservoir and dry gas reservoir. The causes for the diversities in oil and gas phases include diversities of the sources of parent material, maturity of natural gas and the process of hydrocarbon accumulation of different hydrocarbon phases. On the whole, the Jurassic and Triassic terrestrial source rocks are the main sources for the hydrocarbon in the Kuqa Depression. The small differences in parent material may cause diversities in oil and gas amount, but the impact is small. The differences in oil and gas phase are mainly affected by maturity and the accumulation process, which closely relates with each other. Oil and gas at different thermal evolution stage can be captured in different accumulation process.

Restoration of Eroded Thickness of the Neogene Strata in the Western Qaidam Basin and Its Significance for Oil and Gas Occurrence

During the Pleistocene, the western Qaidam Basin has largely experienced strong structural reconstruction and strong erosion. First, the eroded thickness of Neogene strata was restored approximately by the stratigraphic profile comparison method and plane trend surface restoring method; then, accurate calculation of erosion was recovered using vitrinite reflectance, and the erosion that was restored by the trend surface restoring method was corrected; finally, a distribution map of cumulative erosion was produced. This study marks an important achievement in that one of the most important parameters of basin tectonic evolution, sedimentary evolution, and oil and gas accumulation history has been obtained, and that a basic geological problem has been solved in the Qaidam Basin. The areas with high erosion and low erosion are shown in the map and a close relation between the distribution of oil and gas fields and erosion was recognized. Large and medium oil and gas fields are mainly distributed in areas with medium and low erosion. It is difficult to form large-scale oil and gas accumulation in areas in which erosion is more than 2000 m. The mechanism of the relation between oil and gas distribution and erosion is explained. This study will be of use in predicting the distribution of oil and gas.