Penetration of the Stiffener Web to Deck Plate Weld in Orthotropic Plated Bridge Decks

This paper reports the results of experimental research the longitudinal stiffeners in an orthotropic plated bridge deck on concerning the connection between the deck plate and the web of a microscopic scale. An important number of test specimens of a weld are studied with the help of a video microscope, to detect the efficiency of the root of the weld. The second part of the paper is concerned with parametric analysis of the lack of weld penetration by using accurate finite element modelling. The results demonstrate that the weld quality often required can not always be assured, which surely has important consequence on the stresses in the weld and the fatigue resistance.

Fatigue Crack Propagation Analysis of Orthotropic Steel Bridge with Crack Tip Elastoplastic Consideration

Due to the complex structure and dense weld of the orthotropic steel bridge deck(OSBD),fatigue cracks are prone to occur in the typical welding details.Welding residual stress(WRS)will cause a plastic zone at the crack tip.In this paper,an elastoplastic constitutive model based on the Chaboche kinematic hardening model was introduced,and the extended finite element method(XFEM)was used to study the influence of material elastoplasticity and crack tip plastic zone on the law of fatigue crack propagation.By judging the stress state of the residual stress field at the crack tip and selecting different crack propagation rate models to investigate the crack propagation law when plastic deformation was considered,the propagation path and propagation rate of fatigue crack of the OSBD were obtained.The results show that,whether the residual stress field is considered or not,the plastic deformation at the crack tip will not cause the obvious closure of the fatigue crack at the U-rib toe during the crack propagation process,but will significantly affect the crack propagation path.When material plasticity is considered,the propagation angle of fatigue crack at the U-rib toe basically remains unchanged along the short-axis direction of the initial crack,but is going up along the long-axis direction,and the crack tip plastic zone inhibits the propagation of the crack tip on one side.Compared with linear elastic materials,the crack propagation law considering material plasticity is more consistent with that in actual bridge engineering.In terms of the propagation rate,if the residual stress field is not considered,the fatigue crack propagation rate at U-rib toe with plasticity considered is slightly higher than that without plasticity considered,because plastic deformation will affect the amplitude of energy release rate.When considering the WRS field,the fatigue crack propagation rate at U-rib toe is increased due to the combined actions of plastic deformation and stress ratio R.

Fatigue Performance Evaluation for Welded Details in Orthotropic Steel Deck Bridges Using Multi-Scale Finite Element Method

In order to study the fatigue properties of rib-to-deck welded connection and rib-to-rib welded connection in orthotropic steel bridge decks,a multi-scale finite element model was set up to analyze the stress distribution characteristics and the load test was conducted on the Taizhou Yangtze River Bridge.Comparing the vehicle test results with the muli-scale finite element model results to verify the accuracy of the finite element simulation for the stress response of two welded details.The results indicated that The stress at the rib-to-deck welded connection and the rib-to-rib welded connection are the bending stress and the membrane stress,respectively;the stress response of the two welded connection has strong local characteristics;the lateral stress influence line of the two welded connection is relatively short and the length of the lateral stress influence line is greatly affected by the longitudinal ribs;increasing the thickness of the roof and longitudinal ribs can reduce the stress response and improve the stress performance of the heavy lanes.For the two welded details,the fatigue damage increment of the ordinary lane is greater than the heavy lane.The thickened roof and longitudinal ribs at the position of the heavy lane still cannot balance the fatigue damage caused by the heavy truck.Therefore,it is necessary to strictly control the fatigue effect of overloaded vehicles on steel box girders.