Behind-plate overpressure effect of steel-encased reactive material projectile impacting thin aluminum plate

Ballistic impact and sealed chamber tests were performed on the steel-encased reactive material projectile(SERMP)to understand its behind-plate overpressure effect when impacting the thin aluminum plates.The reactive material encased with a 1.5 mm thick 30CrMnSiNi2A steel shell was launched onto the initially sealed test chamber with a 3 mm thick 2024-T3 thin aluminum cover plate.Moreover,the overpressure signals in the test chamber were recorded by pressure sensors.The experimental results indicate an unusual behind-plate overpressure effect:as the density of the projectile increases from 6.43 g/cm^(3) to 7.58 g/cm^(3) by increasing the content of tungsten powder,although its total chemical energy decreases,it produces a higher behind-target overpressure at a lower impact velocity.A theoretical model is proposed to predict the reaction length of reactive material inside the projectile based on one-dimensional shock wave theory to understand this unexpected result.In addition,the deviation between the actual energy release and the theoretical calculation results,also the variation of overpressure rise time are analyzed and discussed.As the analyses show,when the SERMP successfully penetrates the cover plate,an increasing density of the reactive material inside the projectile always means that the delaying rarefaction wave effect,an increase of its internal pressure and strain rate levels.These factors lead to the increase of the overpressure limit velocity and reaction extent of the reactive material,while the overpressure rise time decreases.

Survey-Based Analysis of Water Consumption Law in High-Rise Public Buildings and Water-Saving Performance of Pressure-Reducing Measures

Facing the contradiction of water scarcity and water wastage in most cities of China, this study aims at probing into the factors influencing water-use efficiency and assessing water-saving potential by adopting pressure control measures based on field survey conducted in 23 high-rise buildings in Suqian, China and laboratory tests. Results showed that per capita water consumption (PCWC) exceeding water consumption norms is common in these buildings. The hourly water consumption variation law is quite different among different types of buildings. These differences should be considered in designing building water supply systems to lower water and energy consumption. On the basis of correlation analysis, the order of factors influencing the PCWC follows average tap water pressure, percapita building area, and building age, suggesting pressure management in high-rise buildings is a key water-saving measure. Field tests of outflow characteristics under different water pressures indicated that over-pressure outflow (OPO) is a common cause of water wastage in buildings, however, no branch pipe pressure control measures were found in all the surveyed buildings. Laboratory tests showed that branch pipe pressure-reducing measures can lower water consumption and improve the comfortability of use as well. Therefore, in addition to applying high efficiency water-saving devices, we strongly recommend that branch pipe pressure-reducing measures should be strictly implemented in designing new building water supply systems and reconstruction of existing old building water supply systems, thereby, promoting water, energy saving and development of green building.

Phase transitions in bismuth under rapid compression

The structural phase transitions of bismuth under rapid compression has been investigated in a dynamic diamond anvil cell using time-resolved synchrotron x-ray diffraction. As the pressure increases, the transformations from phase I,to phase II, to phase III, and then to phase V have been observed under different compression rates at 300 K. Compared with static compression results, no new phase transition sequence appears under rapid compression at compression rate from 0.20 GPa/s to 183.8 GPa/s. However, during the process across the transition from phase III to phase V, the volume fraction of product phase as a function of pressure can be well fitted by a compression-rate-dependent sigmoidal curve.The resulting parameters indicate that the activation energy related to this phase transition, as well as the onset transition pressure, shows a compression-rate-dependent performance. A strong dependence of over-pressurization on compression rate occurs under rapid compression. A formula for over-pressure has been proposed, which can be used to quantify the over-pressurization.