Preparation and Properties of Anti-oxidation Inorganic Nano-coating for Low Carbon Steel at an Elevated Temperature

A new kind of anti-oxidation inorganic nano-coating for the common low carbon steel was prepared. It included magnesite mineral, metallurgic dust and silicate adhesive as the main raw materials. The nano-coating could be sprayed directly onto the low carbon steel slab even though with hot surface as far as under 1000 ℃ . And at the same time, a compact thin nano-film was formed, and the film would inhibit the oxygen into the interface of the steel body and decrease the loss of weight because of oxidation. The loss was decreased by about 60% or more. The properties and mechanism of oxidation resistance of the coating were discussed through XRD, TG-DTA and SEM. The experimental results show that many reactions would happen among the companents of the coating and then many microspheres with the size of 80- 100nm generated in the system. By using the heat of the steel body, the silicate adhesive would interact with the microspheres, and the other components of the coating would be soft and sintered so that when the coating was sprayed onto the suface of the steel slab , the intact and compact film could be formed and adhesive with the steel body. Besides the special properties of anti- oxidation, the coating could prevent the volatilization of microelement in the steel such as silicate and carbon at a high temperature. So it can improve the quality and output of steel with this new kind of nano-coating.

Influence of Protective Coating at High Temperature on Surface Quality of Stainless Steel

A ceramic matrix coating for minimizing steel loss of stainless steel at high temperatures was prepared by handled air-spraying technique, and the influence of coating on surface quality of stainless steel was mainly investiga ted in laboratory. Experimental results showed that the protective coating reduced the oxidation of stainless steel by more than 91% and minimized high temperature scaling and also enhanced steel surface quality. The scales of coated specimen were removed completely and the scales of uncoated specimen were partly residual on the surface after cool ing process. Mn-rich and Fe-rich zones were found in the oxides. The Cr2 O3 found in scales came from the underlying stainless steel and formed a Cr rich layer along the spalled surface.

Investigation on the broadband electromagnetic wave absorption properties and mechanism of Co3O4- nanosheets/reduced-graphene-oxide composite

A cobaltosic-oxide-nanosheets/reduced-graphene-oxide composite （CoNSs@RGO） was successfully prepared as a light-weight broadband electromagnetic wave absorber. The effects of the sample thickness and amount of composite added to paraffin samples on the absorption properties were thoroughly investigated. Due to the nanosheet-like structure of Co3O4, the surface-to-volume ratio of the wave absorption material was very high, resulting in a large enhancement in the absorption properties. The maximum refection loss of the CoNSs@RGO composite was -45.15 dB for a thickness of 3.6 mm, and the best absorption bandwidth with a reflection loss below -10 dB was 7.14 GHz with a thickness of 2.9 mm. In addition, the peaks of microwave absorption shifted towards the low frequency region with increasing thickness of the absorbing coatings. The mechanism of electromagnetic wave absorption was attributed to impedance matching of CoNSs@RGO as well as the dielectric relaxation and polarization of RGO. Compared to previously reported absorbing materials, CoNSs@RGO showed better performance as a lightweight and highly efficient absorbing material for application in the high frequency band.