This paper gives performance analysis of a three phase Permanent Magnet Synchronous Generator (PMSG) connected to a Vertical Axis Wind Turbine (VAWT). Low speed wind condition (less than 5 m/s) is taken in considerati...This paper gives performance analysis of a three phase Permanent Magnet Synchronous Generator (PMSG) connected to a Vertical Axis Wind Turbine (VAWT). Low speed wind condition (less than 5 m/s) is taken in consideration and the entire simulation is carried in Matlab/Simulink environment. The rated power for the generator is fixed at 1.5 KW and number of pole at 20. It is observed under low wind speed of6 m/s, a turbine having approximately1 mof radius and2.6 mof height develops 150 Nm mechanical torque that can generate power up to 1.5 KW. The generator is designed using modeling tool and is fabricated. The fabricated generator is tested in the laboratory with the simulation result for the error analysis. The range of error is about 5%-27% for the same output power value. The limitations and possible causes for error are presented and discussed.展开更多
为研究环下润滑结构内部油膜迁移及流动特性,针对轴心射流收油环采用VOF (Volume of fluid)方法开展了数值计算,获得了收油环端面油膜动态形成过程,在分析流场特征的基础上,讨论了收油环运转工况及结构参数对内部油膜形态、滑油体积分...为研究环下润滑结构内部油膜迁移及流动特性,针对轴心射流收油环采用VOF (Volume of fluid)方法开展了数值计算,获得了收油环端面油膜动态形成过程,在分析流场特征的基础上,讨论了收油环运转工况及结构参数对内部油膜形态、滑油体积分数、油膜速度和供油孔输油能力的影响规律。结果表明:收油环端面油膜呈圆盘状迁移,边缘破碎形成油滴、油带甩至侧壁面,在供油孔内以“月牙形”分布加速流动,收油环端面油膜厚度随主轴转速增大而减小,随喷嘴流量上升而增加;提高转速降低了供油孔内滑油含量,使孔内油膜加速流动,孔内滑油含量随喷嘴流量的上升而增大,随供油孔径的增加而下降;喷嘴流量与供油孔径的改变对孔内流速影响较小;增加孔径与提高收油环转速可加强供油孔输运能力,8 kr/min下提高喷嘴流量使无量纲输油量Cq平均降低了40.71%,提高孔径使Cq最大提高了57.14%,转速的增加使Cq平均增加25.87%。展开更多
A sensitive method to determine the optic axis azimuth of the birefringence element is presented, which is based on laser feedback. The phase difference between the two intensities in birefringence feedback changes wi...A sensitive method to determine the optic axis azimuth of the birefringence element is presented, which is based on laser feedback. The phase difference between the two intensities in birefringence feedback changes with the angle between the optic axis of the birefringence element and laser original polarization. The phase difference is highly sensitive to the relative position of the optic axis and the laser original polarization. This method is used to highly precisely determine the optic axis azimuth, and is able to distinguish between the fast axis and the slow axis of the birefringence element. Theoretical analysis and experimental results are both demonstrated.展开更多
During the process of directional solidification,laser remelting/solidification in the layer on sintered magnets, die-upsetting of cast magnets,or die-upsetting of nano-composites,the arrangements of the easy-magnetiz...During the process of directional solidification,laser remelting/solidification in the layer on sintered magnets, die-upsetting of cast magnets,or die-upsetting of nano-composites,the arrangements of the easy-magnetization-axes of the hard magnetic phases(Nd2Fe14B,SmCo5 or Sm2Co17 type)in their designed directions have been studied.In Fe-Pt nano-composite magnets,attempts have been taken to promote phase transformation from disordered,soft magnetic A1 to ordered,hard magnetic L10 FePt phase at reduced temperatures.The dependence of the magnetization and reversal magnetization processes on the microstructures,involving the morphology and three critical sizes of particles of the FePt nano-composite magnets,are summarized. With the decrease of the nominal thickness of the anisotropic FePt film epitaxially grown on the single crystal MgO(001)substrate, the reversal magnetization process firstly changes from full domain wall displacement to partial magnetic wall pinning related to the morphology change,where the coercive force increases abruptly.The reversal magnetization process secondly changes from magnetic wall pinning to incoherent magnetization rotation associated with the particles being below the first critical size at which multi-domain particles turn into single domain ones,where the coercive force is still increased.And the reversal magnetization mode thirdly changes from incoherent to coherent rotation referred to the second critical size,where the increase of the coercive force keeps on.However,when the particle size decreases to approach the third critical size where the particles turn into the supperparamagnetic state,the coercive force begins to decrease due to the interplay of the size effect and the incomplete ordering induced by the size effect.Meanwhile,due to the size effect,Curie temperature of the ultra-small FePt particles reduces.展开更多
As a kind of special acoustic field, the helical wavefront of an acoustic vortex（AV） beam is demonstrated to have a pressure zero with phase singularity at the center in the transverse plane. The orbital angular mom...As a kind of special acoustic field, the helical wavefront of an acoustic vortex（AV） beam is demonstrated to have a pressure zero with phase singularity at the center in the transverse plane. The orbital angular momentum of AVs can be applied to the field of particle manipulation, which attracts more and more attention in acoustic researches. In this paper,by using the simplified circular array of point sources, dual coaxial AV beams are excited by the even-and odd-numbered sources with the topological charges of l_E and l_O based on the phase-coded approach, and the composite acoustic field with an on-axis center-AV and multiple off-axis sub-AVs can be generated by the superimposition of the AV beams for｜l_E｜ ≠ ｜l_O｜. The generation of edge phase dislocation is theoretically derived and numerically analyzed for l_E=-l_O. The numbers and the topological charges as well as the locations of the center-AV and sub-AVs are demonstrated, which are proved to be determined by the topological charges of the coaxial AV beams. The proposed approach breaks through the limit of only one on-axis AV with a single topological charge along the beam axis, and also provides the feasibility of off-axis particle trapping with multiple AVs in object manipulation.展开更多
文摘This paper gives performance analysis of a three phase Permanent Magnet Synchronous Generator (PMSG) connected to a Vertical Axis Wind Turbine (VAWT). Low speed wind condition (less than 5 m/s) is taken in consideration and the entire simulation is carried in Matlab/Simulink environment. The rated power for the generator is fixed at 1.5 KW and number of pole at 20. It is observed under low wind speed of6 m/s, a turbine having approximately1 mof radius and2.6 mof height develops 150 Nm mechanical torque that can generate power up to 1.5 KW. The generator is designed using modeling tool and is fabricated. The fabricated generator is tested in the laboratory with the simulation result for the error analysis. The range of error is about 5%-27% for the same output power value. The limitations and possible causes for error are presented and discussed.
文摘为研究环下润滑结构内部油膜迁移及流动特性,针对轴心射流收油环采用VOF (Volume of fluid)方法开展了数值计算,获得了收油环端面油膜动态形成过程,在分析流场特征的基础上,讨论了收油环运转工况及结构参数对内部油膜形态、滑油体积分数、油膜速度和供油孔输油能力的影响规律。结果表明:收油环端面油膜呈圆盘状迁移,边缘破碎形成油滴、油带甩至侧壁面,在供油孔内以“月牙形”分布加速流动,收油环端面油膜厚度随主轴转速增大而减小,随喷嘴流量上升而增加;提高转速降低了供油孔内滑油含量,使孔内油膜加速流动,孔内滑油含量随喷嘴流量的上升而增大,随供油孔径的增加而下降;喷嘴流量与供油孔径的改变对孔内流速影响较小;增加孔径与提高收油环转速可加强供油孔输运能力,8 kr/min下提高喷嘴流量使无量纲输油量Cq平均降低了40.71%,提高孔径使Cq最大提高了57.14%,转速的增加使Cq平均增加25.87%。
基金Project supported by the Natural Science Foundation of Beijing,China(Grant No.3091002)
文摘A sensitive method to determine the optic axis azimuth of the birefringence element is presented, which is based on laser feedback. The phase difference between the two intensities in birefringence feedback changes with the angle between the optic axis of the birefringence element and laser original polarization. The phase difference is highly sensitive to the relative position of the optic axis and the laser original polarization. This method is used to highly precisely determine the optic axis azimuth, and is able to distinguish between the fast axis and the slow axis of the birefringence element. Theoretical analysis and experimental results are both demonstrated.
基金Project(2004CCA04000)supported by the National Basic Research Program of ChinaProject(50744014)supported by the National Natural Science Foundation of China+3 种基金Project(2008C21046)supported by Science and Technology Department of Zhejiang Province,ChinaProject(Y406389)supported by Zhejiang Provincial Natural Science Foundation of ChinaProject(2006B100054)supported by Ningbo Bureau of Science and Technology,ChinaProject supported by K.C.Wong Magna Found in Ningbo University,China
文摘During the process of directional solidification,laser remelting/solidification in the layer on sintered magnets, die-upsetting of cast magnets,or die-upsetting of nano-composites,the arrangements of the easy-magnetization-axes of the hard magnetic phases(Nd2Fe14B,SmCo5 or Sm2Co17 type)in their designed directions have been studied.In Fe-Pt nano-composite magnets,attempts have been taken to promote phase transformation from disordered,soft magnetic A1 to ordered,hard magnetic L10 FePt phase at reduced temperatures.The dependence of the magnetization and reversal magnetization processes on the microstructures,involving the morphology and three critical sizes of particles of the FePt nano-composite magnets,are summarized. With the decrease of the nominal thickness of the anisotropic FePt film epitaxially grown on the single crystal MgO(001)substrate, the reversal magnetization process firstly changes from full domain wall displacement to partial magnetic wall pinning related to the morphology change,where the coercive force increases abruptly.The reversal magnetization process secondly changes from magnetic wall pinning to incoherent magnetization rotation associated with the particles being below the first critical size at which multi-domain particles turn into single domain ones,where the coercive force is still increased.And the reversal magnetization mode thirdly changes from incoherent to coherent rotation referred to the second critical size,where the increase of the coercive force keeps on.However,when the particle size decreases to approach the third critical size where the particles turn into the supperparamagnetic state,the coercive force begins to decrease due to the interplay of the size effect and the incomplete ordering induced by the size effect.Meanwhile,due to the size effect,Curie temperature of the ultra-small FePt particles reduces.
基金Project supported by the National Natural Science Foundation of China(Grant Nos.11474166 and 11604156)the Science and Technology Cooperation Projects of People’s Republic of China–Romania(Grant No.42-23)+2 种基金the Natural Science Foundation of Jiangsu Province,China(Grant No.BK20161013)the Postdoctoral Science Foundation of China(Grant No.2016M591874)the Priority Academic Program Development of Jiangsu Higher Education Institutions,China
文摘As a kind of special acoustic field, the helical wavefront of an acoustic vortex（AV） beam is demonstrated to have a pressure zero with phase singularity at the center in the transverse plane. The orbital angular momentum of AVs can be applied to the field of particle manipulation, which attracts more and more attention in acoustic researches. In this paper,by using the simplified circular array of point sources, dual coaxial AV beams are excited by the even-and odd-numbered sources with the topological charges of l_E and l_O based on the phase-coded approach, and the composite acoustic field with an on-axis center-AV and multiple off-axis sub-AVs can be generated by the superimposition of the AV beams for｜l_E｜ ≠ ｜l_O｜. The generation of edge phase dislocation is theoretically derived and numerically analyzed for l_E=-l_O. The numbers and the topological charges as well as the locations of the center-AV and sub-AVs are demonstrated, which are proved to be determined by the topological charges of the coaxial AV beams. The proposed approach breaks through the limit of only one on-axis AV with a single topological charge along the beam axis, and also provides the feasibility of off-axis particle trapping with multiple AVs in object manipulation.
