Design of a CMOS Adaptive Charge Pump with Dynamic Current Matching

A novel structure for a charge pump circuit is proposed, in which the charge-pump （CP） current can adaptively regulated according to phase-locked loops （PLL） frequency synthesis demand. The current follow technology is used to make perfect current matching characteristics, and the two differential inverters are implanted to increase the speed of charge pump and decrease output spur due to theory of low voltage difference signal. Simulation results, with 1st silicon 0. 25μm 2. 5 V complementary metal-oxide-semiconductor （CMOS） mixed-signal process, show the good current matching characteristics regardless of the charge pump output voltages.

Self-Balanced Charge Pump with Fast Lock Circuit

A self-balanced charge pump （CP） with fast lock circuit to achieve nearly zero phase error is proposed and analyzed. The proposed CP is designed based on the SMIC 0.25μm 1P5M complementary metal oxide semiconductor （CMOS） process with a 2.5 V supply voltage, HSPICE simulation shows that even if the mismatch of phase/frequency detector （PFD） was beyond 10%, the charge pump could still keep nearly zero phase error, Incorporated fast lock circuit can shorten start-up time to below 300 ns.

A 8.75-11.2-GHz,low phase noise fractional-N synthesizer for 802.11a/b/g zero-IF transceiver

An ultra broadband fractional-N frequency synthesizer for 802.11a/b/g zero-IF transceiver application is presented.The mathematical models for the behavior of the synthesizer＇s spur and phase noise are analyzed,and the optimization methodology is proposed.Measurement results exhibits that the frequency synthesizer＇s integrated phase noise is less than 1°（1 kHz to 100 MHz）with a 4.375 GHz carrier（after divide-by-2）,and the reference frequency spur is below-60 dBc operating with a 33 MHz reference clock.The frequency synthesizer is fabricated on a standard 0.13μm RF CMOS process and consumes 39.6 mW from a 1.2 V supply voltage.

Short locking time and low jitter phase-locked loop based on slope charge pump control

A novel structure of a phase-locked loop （PLL） characterized by a short locking time and low jitter is presented, which is realized by generating a linear slope charge pump current dependent on monitoring the output of the phase frequency detector （PFD） to implement adaptive bandwidth control. This improved PLL is created by utilizing a fast start-up circuit and a slope current control on a conventional charge pump PLL. First, the fast start-up circuit is enabled to achieve fast pre-charging to the loop filter. Then, when the output pulse of the PFD is larger than a minimum value, the charge pump current is increased linearly by the slope current control to ensure a shorter locking time and a lower jitter. Additionally, temperature variation is attenuated with the temperature compensation in the charge pump current design. The proposed PLL has been fabricated in a kind of DSP chip based on a 0.35 μm CMOS process. Comparing the characteristics with the classical PLL, the proposed PLL shows that it can reduce the locking time by 60% with a low peak-to-peak jitter of 0.3% at a wide operation temperature range.

A 2.5-Gb/s fully-integrated,low-power clock and recovery circuit in 0.18-μm CMOS

Based on the devised system-level design methodology, a 2.5-Gb/s monolithic bang-bang phase-locked clock and data recovery （CDR） circuit has been designed and fabricated in SMIC＇s 0.18-μm CMOS technology. The Pottbiicker phase frequency detector and a differential 4-stage inductorless ring VCO are adopted, where an additional current source is added to the VCO cell to improve the linearity of the VCO characteristic. The CDR has an active area of 340 × 440μm2, and consumes a power of only about 60 mW from a 1.8 V supply voltage, with an input sensitivity of less than 25 mV, and an output single-ended swing of more than 300 mV. It has a pull-in range of 800 MHz, and a phase noise of-111.54 dBc/Hz at 10 kHz offset. The CDR works reliably at any input data rate between 1.8 Gb/s and 2.6 Gb/s without any need for reference clock, off-chip tuning, or external components.

5-Gb/s 0.18-μm CMOS 2:1 multiplexer with integrated clock extraction

A 5-Gb/s 2 ： 1 MUX （multiplexer） with an on-chip integrated clock extraction circuit which possesses the function of automatic phase alignment （APA）, has been designed and fabricated in SMIC＇s 0.18 μm CMOS technology. The chip area is 670 × 780 μm^2. At a single supply voltage of 1.8 V, the total power consumption is 112 mW with an input sensitivity of less than 50 mV and an output single-ended swing of above 300 mV. The measurement results show that the IC can work reliably at any input data rate between 1.8 and 2.6 Gb/s with no need for external components, reference clock, or phase alignment between data and clock. It can be used in a parallel optic-fiber data interconnecting system.