The novel compensating method directly demodulates the signals without the carrier recovery processes, in which the carrier with original modulation frequency is used as the local coherent carrier. In this way, the ph...The novel compensating method directly demodulates the signals without the carrier recovery processes, in which the carrier with original modulation frequency is used as the local coherent carrier. In this way, the phase offsets due to frequency shift are linear. Based on this premise, the compensation processes are： firstly, the phase offsets between the baseband neighbor-symbols after clock recovery is unbiasedly estimated among the reference symbols; then, the receiving signals symbols are adjusted by the phase estimation value; finally, the phase offsets after adjusting are compensated by the least mean squares （LMS） algorithm. In order to express the compensation processes and ability clearly, the quadrature phase shift keying （QPSK） modulation signals are regarded as examples for Matlab simulation. BER simulations are carried out using the Monte-Carlo method. The learning curves are obtained to study the algorithm＇s convergence ability. The constellation figures are also simulated to observe the compensation results directly.展开更多
The de-coherence phenomena such as Low-SNR radar signal, shadows and layover caused by topography, etc. , causing phase data discontinuity, makes the result of unwrapping phase inaccuracy or even completely wrong. Bas...The de-coherence phenomena such as Low-SNR radar signal, shadows and layover caused by topography, etc. , causing phase data discontinuity, makes the result of unwrapping phase inaccuracy or even completely wrong. Based on the analysis of influencing factors to weight choice, this thesis develops a new method to choose the weights based on the measure of the confidence in the frequency domain. Experiments show that it could overcome the defect of sub-estimate to the slope of least squares method very well, which has a better rationale, stability and performance.展开更多
The decorelation phenomena such as Low-SNR radar signal, shadows and layover caused by topography etc, causes phase data discontinuous and makes the result of unwrapping phase inaccurate or completely wrong. Based on ...The decorelation phenomena such as Low-SNR radar signal, shadows and layover caused by topography etc, causes phase data discontinuous and makes the result of unwrapping phase inaccurate or completely wrong. Based on the analysis of influencing factors to the weight selection, this paper develops a new method to choose the weights based on the measurement of confidence in frequency domain. Results show that it is more precise and robust than other methods, and can make up for the defect of sub-estimate to the slope of least squares method.展开更多
The technique of SNR estimation is one of the key technologies in adaptive frequency hopping system. The methods of channel quality estimation for non-linear continuous phase modulation (CPM) signals have some limitat...The technique of SNR estimation is one of the key technologies in adaptive frequency hopping system. The methods of channel quality estimation for non-linear continuous phase modulation (CPM) signals have some limitations. Therefore, the algorithm of channel quality estimation for CPM signals is worthy of further study. Some similar phase characteristics between sampling CPM and MPSK motivate us to propose a channel estimation algorithm with applications to nonlinear CPM using linear modulation signal processing. A comprehensive analysis of LDPC-CPM schemes using proposed algorithm is presented, and simulation results indicate that the proposed method can not only estimate channel quality well but also make the normalized MSE (NMSE) of SNR estimate close to/less than 0.1 dB at SNR of 4 dB using short block codes. It shows that the algorithm in this paper is effective enough to estimate the signal to noise ratio (SNR). Meanwhile, the algorithm in this paper reduces the complexity of computation compared with other traditional algorithms.展开更多
In this paper, a regression method of estimation has been used to derive the mean estimate of the survey variable using simple random sampling without replacement in the presence of observational errors. Two covariate...In this paper, a regression method of estimation has been used to derive the mean estimate of the survey variable using simple random sampling without replacement in the presence of observational errors. Two covariates were used and a case where the observational errors were in both the survey variable and the covariates was considered. The inclusion of observational errors was due to the fact that data collected through surveys are often not free from errors that occur during observation. These errors can occur due to over-reporting, under-reporting, memory failure by the respondents or use of imprecise tools of data collection. The expression of mean squared error (MSE) based on the obtained estimator has been derived to the first degree of approximation. The results of a simulation study show that the derived modified regression mean estimator under observational errors is more efficient than the mean per unit estimator and some other existing estimators. The proposed estimator can therefore be used in estimating a finite population mean, while considering observational errors that may occur during a study.展开更多
This paper is an extension of Hanif, Hamad and Shahbaz estimator [1] for two-phase sampling. The aim of this paper is to develop a regression type estimator with two auxiliary variables for two-phase sampling when we ...This paper is an extension of Hanif, Hamad and Shahbaz estimator [1] for two-phase sampling. The aim of this paper is to develop a regression type estimator with two auxiliary variables for two-phase sampling when we don’t have any type of information about auxiliary variables at population level. To avoid multi-collinearity, it is assumed that both auxiliary variables have minimum correlation. Mean square error and bias of proposed estimator in two-phase sampling is derived. Mean square error of proposed estimator shows an improvement over other well known estimators under the same case.展开更多
有限状态集模型预测控制具备快速动态响应、无调制模块等优势,已在高性能功率变换器广泛应用。然而该技术高度依赖建模精度,实际应用中受模型匹配度和参数摄动等因素影响,难以运行于最优性能。为此,提出一种基于递归最小二乘(recursive ...有限状态集模型预测控制具备快速动态响应、无调制模块等优势,已在高性能功率变换器广泛应用。然而该技术高度依赖建模精度,实际应用中受模型匹配度和参数摄动等因素影响,难以运行于最优性能。为此,提出一种基于递归最小二乘(recursive least squares,RLS)估算的无参数预测控制方法。以数据驱动建模代替物理参数建模,首先采用外生变量自回归技术建立三相逆变器等效模型,并利用RLS算法进行等效模型参数估算。最后,基于22 kW测试平台对所提方法进行验证与分析。结果表明,所提方法对模型和参数变化具有强鲁棒性,不失为一种通用型鲁棒预测控制方案。展开更多
基金supported by the National Natural Science Foundation of China(60532030)
文摘The novel compensating method directly demodulates the signals without the carrier recovery processes, in which the carrier with original modulation frequency is used as the local coherent carrier. In this way, the phase offsets due to frequency shift are linear. Based on this premise, the compensation processes are： firstly, the phase offsets between the baseband neighbor-symbols after clock recovery is unbiasedly estimated among the reference symbols; then, the receiving signals symbols are adjusted by the phase estimation value; finally, the phase offsets after adjusting are compensated by the least mean squares （LMS） algorithm. In order to express the compensation processes and ability clearly, the quadrature phase shift keying （QPSK） modulation signals are regarded as examples for Matlab simulation. BER simulations are carried out using the Monte-Carlo method. The learning curves are obtained to study the algorithm＇s convergence ability. The constellation figures are also simulated to observe the compensation results directly.
基金supported by the National Natural Science Fundation of China(40874001)Key Laboratory of Surveying and Mapping Technology on Island and Reef,National Administration of Surveying,Mapping and Geoinformation(2010A01)
文摘The de-coherence phenomena such as Low-SNR radar signal, shadows and layover caused by topography, etc. , causing phase data discontinuity, makes the result of unwrapping phase inaccuracy or even completely wrong. Based on the analysis of influencing factors to weight choice, this thesis develops a new method to choose the weights based on the measure of the confidence in the frequency domain. Experiments show that it could overcome the defect of sub-estimate to the slope of least squares method very well, which has a better rationale, stability and performance.
基金supported by the National Natural Science Foundation(40874001)Key Laboratory of Surveying and Mapping Technology on Island and Reef,State Bureau of Surveying and Mapping(2010A01)
文摘The decorelation phenomena such as Low-SNR radar signal, shadows and layover caused by topography etc, causes phase data discontinuous and makes the result of unwrapping phase inaccurate or completely wrong. Based on the analysis of influencing factors to the weight selection, this paper develops a new method to choose the weights based on the measurement of confidence in frequency domain. Results show that it is more precise and robust than other methods, and can make up for the defect of sub-estimate to the slope of least squares method.
文摘The technique of SNR estimation is one of the key technologies in adaptive frequency hopping system. The methods of channel quality estimation for non-linear continuous phase modulation (CPM) signals have some limitations. Therefore, the algorithm of channel quality estimation for CPM signals is worthy of further study. Some similar phase characteristics between sampling CPM and MPSK motivate us to propose a channel estimation algorithm with applications to nonlinear CPM using linear modulation signal processing. A comprehensive analysis of LDPC-CPM schemes using proposed algorithm is presented, and simulation results indicate that the proposed method can not only estimate channel quality well but also make the normalized MSE (NMSE) of SNR estimate close to/less than 0.1 dB at SNR of 4 dB using short block codes. It shows that the algorithm in this paper is effective enough to estimate the signal to noise ratio (SNR). Meanwhile, the algorithm in this paper reduces the complexity of computation compared with other traditional algorithms.
文摘In this paper, a regression method of estimation has been used to derive the mean estimate of the survey variable using simple random sampling without replacement in the presence of observational errors. Two covariates were used and a case where the observational errors were in both the survey variable and the covariates was considered. The inclusion of observational errors was due to the fact that data collected through surveys are often not free from errors that occur during observation. These errors can occur due to over-reporting, under-reporting, memory failure by the respondents or use of imprecise tools of data collection. The expression of mean squared error (MSE) based on the obtained estimator has been derived to the first degree of approximation. The results of a simulation study show that the derived modified regression mean estimator under observational errors is more efficient than the mean per unit estimator and some other existing estimators. The proposed estimator can therefore be used in estimating a finite population mean, while considering observational errors that may occur during a study.
文摘This paper is an extension of Hanif, Hamad and Shahbaz estimator [1] for two-phase sampling. The aim of this paper is to develop a regression type estimator with two auxiliary variables for two-phase sampling when we don’t have any type of information about auxiliary variables at population level. To avoid multi-collinearity, it is assumed that both auxiliary variables have minimum correlation. Mean square error and bias of proposed estimator in two-phase sampling is derived. Mean square error of proposed estimator shows an improvement over other well known estimators under the same case.
文摘有限状态集模型预测控制具备快速动态响应、无调制模块等优势,已在高性能功率变换器广泛应用。然而该技术高度依赖建模精度,实际应用中受模型匹配度和参数摄动等因素影响,难以运行于最优性能。为此,提出一种基于递归最小二乘(recursive least squares,RLS)估算的无参数预测控制方法。以数据驱动建模代替物理参数建模,首先采用外生变量自回归技术建立三相逆变器等效模型,并利用RLS算法进行等效模型参数估算。最后,基于22 kW测试平台对所提方法进行验证与分析。结果表明,所提方法对模型和参数变化具有强鲁棒性,不失为一种通用型鲁棒预测控制方案。
