In this paper, the problem on local scour around a single square pier was studied by using both the numerical and physical models. The numerical model for the study is FSUM based on a finite-difference method to solve...In this paper, the problem on local scour around a single square pier was studied by using both the numerical and physical models. The numerical model for the study is FSUM based on a finite-difference method to solve the Reynolds averaged Navier-Stokes equations (RANS) and the equations for suspended sediment concentration and bed morphology. The computed result was verified through data measured in the experimental flume with a sand bed. In general, the typical features of local scour around the pier were successfully simulated by FSUM, such as stream flow, bow flow, down flow, horseshoe vortex. The comparison between the computation and experiment data shows a quite good fitness. Both numerical model and experiment results show that the maximum scour depth occurs at two front edges of the pier. Although the computed result shows a little bigger scour depth in comparison with the measurement in the physical model, it still confirms the reliability of numerical model in some measure.展开更多
This study aims to analyze seismic damage of reinforced outlet piers of arch dams by the nonlinear finite element （FE） sub-model method. First, the dam-foundation system is modeled and analyzed, in which the effects...This study aims to analyze seismic damage of reinforced outlet piers of arch dams by the nonlinear finite element （FE） sub-model method. First, the dam-foundation system is modeled and analyzed, in which the effects of infinite foundation, contraction joints, and nonlinear concrete are taken into account. The detailed structures of the outlet pier are then simulated with a refined FE model in the sub-model analysis. In this way the damage mechanism of the plain （unreinforced） outlet pier is analyzed, and the effects of two reinforcement measures （i.e., post-tensioned anchor cables and reinforcing bar） on the dynamic damage to the outlet pier are investigated comprehensively. Results show that the plain pier is damaged severely by strong earthquakes while implementation of post-tensioned anchor cables strengthens the pier effectively. In addition, radiation damping strongly alleviates seismic damage to the piers.展开更多
This paper describes some details and procedural steps in the equivalent resistance （E-R） method for simplifying the pier group of the Sutong Bridge, which is located on the tidal reach of the lower Yangtze River, i...This paper describes some details and procedural steps in the equivalent resistance （E-R） method for simplifying the pier group of the Sutong Bridge, which is located on the tidal reach of the lower Yangtze River, in Jiangsu Province. Using a two-dimensional tidal current numerical model, three different models were established： the non-bridge pier model, original bridge pier model, and simplified bridge pier model. The difference in hydrodynamic parameters, including water level, velocity, and diversion ratio, as well as time efficiency between these three models is discussed in detail. The results show that simplifying the pier group using the E-R method influences the water level and velocity near the piers, but has no influence on the diversion ratio of each cross-section of the Xuliujing reach located in the lower Yangtze River. Furthermore, the simplified bridge pier model takes half the calculation time that the original bridge pier model needs. Thus, it is concluded that the E-R method can be use to simplify bridge piers in tidal river section modeling reasonably and efficiently.展开更多
The main purpose of this paper is to analyze the influence of different turbulence flow models on scouring pit of bridge-pier. Flow-3D software is applied in line with the purpose. The key motivation for this study is...The main purpose of this paper is to analyze the influence of different turbulence flow models on scouring pit of bridge-pier. Flow-3D software is applied in line with the purpose. The key motivation for this study is to contribute to the Flow-3D software by means of some modification and adjustment in the sediment scour model and shallow water model. An assessment of turbulence model adopted with the parameters of the Melville experiment to estimate the maximum scour-depth was performed. In the simulation results, the alternate eddy formation and shedding were repeated while the Karman vortex street formed behind the pier for the large eddy simulation LES turbulence model is more realistic in the flow phenomenon. The results of the scour development of large eddy simulation (LES) turbulence model were found to be more satisfied than the Renormalized group (RNG) turbulence model and close to the prior experiment results. The simulated scour results were significantly different with the observed data collected from previous literature in the reason of some unsuitability of meshing method in Flow-3D software.展开更多
文摘In this paper, the problem on local scour around a single square pier was studied by using both the numerical and physical models. The numerical model for the study is FSUM based on a finite-difference method to solve the Reynolds averaged Navier-Stokes equations (RANS) and the equations for suspended sediment concentration and bed morphology. The computed result was verified through data measured in the experimental flume with a sand bed. In general, the typical features of local scour around the pier were successfully simulated by FSUM, such as stream flow, bow flow, down flow, horseshoe vortex. The comparison between the computation and experiment data shows a quite good fitness. Both numerical model and experiment results show that the maximum scour depth occurs at two front edges of the pier. Although the computed result shows a little bigger scour depth in comparison with the measurement in the physical model, it still confirms the reliability of numerical model in some measure.
基金National Natural Science Foundation of China under Grant Nos.51179093 and 91215301Specialized Research Fund for the Doctoral Program of Higher Education under Grant No.20130002110032
文摘This study aims to analyze seismic damage of reinforced outlet piers of arch dams by the nonlinear finite element （FE） sub-model method. First, the dam-foundation system is modeled and analyzed, in which the effects of infinite foundation, contraction joints, and nonlinear concrete are taken into account. The detailed structures of the outlet pier are then simulated with a refined FE model in the sub-model analysis. In this way the damage mechanism of the plain （unreinforced） outlet pier is analyzed, and the effects of two reinforcement measures （i.e., post-tensioned anchor cables and reinforcing bar） on the dynamic damage to the outlet pier are investigated comprehensively. Results show that the plain pier is damaged severely by strong earthquakes while implementation of post-tensioned anchor cables strengthens the pier effectively. In addition, radiation damping strongly alleviates seismic damage to the piers.
基金supported by the Innovation Project of Graduate Education in Jiangsu Province during 2011 (Grant No. CXZZ11_0449)the Research Plan Project of Transportation Science in Jiangsu Province (Grant No. 20100714-30HDKY001-2)
文摘This paper describes some details and procedural steps in the equivalent resistance （E-R） method for simplifying the pier group of the Sutong Bridge, which is located on the tidal reach of the lower Yangtze River, in Jiangsu Province. Using a two-dimensional tidal current numerical model, three different models were established： the non-bridge pier model, original bridge pier model, and simplified bridge pier model. The difference in hydrodynamic parameters, including water level, velocity, and diversion ratio, as well as time efficiency between these three models is discussed in detail. The results show that simplifying the pier group using the E-R method influences the water level and velocity near the piers, but has no influence on the diversion ratio of each cross-section of the Xuliujing reach located in the lower Yangtze River. Furthermore, the simplified bridge pier model takes half the calculation time that the original bridge pier model needs. Thus, it is concluded that the E-R method can be use to simplify bridge piers in tidal river section modeling reasonably and efficiently.
文摘The main purpose of this paper is to analyze the influence of different turbulence flow models on scouring pit of bridge-pier. Flow-3D software is applied in line with the purpose. The key motivation for this study is to contribute to the Flow-3D software by means of some modification and adjustment in the sediment scour model and shallow water model. An assessment of turbulence model adopted with the parameters of the Melville experiment to estimate the maximum scour-depth was performed. In the simulation results, the alternate eddy formation and shedding were repeated while the Karman vortex street formed behind the pier for the large eddy simulation LES turbulence model is more realistic in the flow phenomenon. The results of the scour development of large eddy simulation (LES) turbulence model were found to be more satisfied than the Renormalized group (RNG) turbulence model and close to the prior experiment results. The simulated scour results were significantly different with the observed data collected from previous literature in the reason of some unsuitability of meshing method in Flow-3D software.
