The pressing bonding of steel plate to QTi3.5-3.5 graphite slurry was conducted. Under the conditions of 530 ℃ for the preheat temperature of dies, 45% for the solid fraction of QTi3.5- 3.5 graphite slurry, 50 MPa fo...The pressing bonding of steel plate to QTi3.5-3.5 graphite slurry was conducted. Under the conditions of 530 ℃ for the preheat temperature of dies, 45% for the solid fraction of QTi3.5- 3.5 graphite slurry, 50 MPa for the pressure and 2 min for the pressing time, the relationship between the preheat temperature of steel plate and interfacial mechanical property of bonding plate was studied. The results show that when the preheat temperature of steel plate is lower titan 618 ℃ , the interfacial shear strength of bonding plate increases with the increasing of the preheat temperature of steel plate. When the preheat temperature of steel plate is higher than 618 ℃ , the interfacial shear strength decreases with the increasing of the preheat temperature of steel plate. When the preheat temperature of steel plate is 618 ℃ , the highest interfacial shear strength of bonding plate of 127.8 MPa can be got.展开更多
MEMS gyroscopes are widely used in the underwater vehicles owing to their excellent performance and affordable costs.However,the temperature sensitivity of the sensor seriously affects measurement accuracy.Therefore,i...MEMS gyroscopes are widely used in the underwater vehicles owing to their excellent performance and affordable costs.However,the temperature sensitivity of the sensor seriously affects measurement accuracy.Therefore,it is significantly to accurately identify the temperature compensation model in this paper,the calibration parameters were first extracted by using the fast calibration algorithm based on the Persistent Excitation Signal Criterion,and then,MEMS gyro temperature compensation model was established by utilizing the thin plate spline interpolation method,and the corresponding identification results were compared with the results from the polynomial fitting method.The effectiveness of the proposed algorithm has been validated through the comparative experiment.展开更多
基金Funded by the National Natural Science Foundation of China(No.50274047 and 50304001) Beijing Jiaotong University ScienceFoundation,andthe Ministry of Education Foundation
文摘The pressing bonding of steel plate to QTi3.5-3.5 graphite slurry was conducted. Under the conditions of 530 ℃ for the preheat temperature of dies, 45% for the solid fraction of QTi3.5- 3.5 graphite slurry, 50 MPa for the pressure and 2 min for the pressing time, the relationship between the preheat temperature of steel plate and interfacial mechanical property of bonding plate was studied. The results show that when the preheat temperature of steel plate is lower titan 618 ℃ , the interfacial shear strength of bonding plate increases with the increasing of the preheat temperature of steel plate. When the preheat temperature of steel plate is higher than 618 ℃ , the interfacial shear strength decreases with the increasing of the preheat temperature of steel plate. When the preheat temperature of steel plate is 618 ℃ , the highest interfacial shear strength of bonding plate of 127.8 MPa can be got.
文摘MEMS gyroscopes are widely used in the underwater vehicles owing to their excellent performance and affordable costs.However,the temperature sensitivity of the sensor seriously affects measurement accuracy.Therefore,it is significantly to accurately identify the temperature compensation model in this paper,the calibration parameters were first extracted by using the fast calibration algorithm based on the Persistent Excitation Signal Criterion,and then,MEMS gyro temperature compensation model was established by utilizing the thin plate spline interpolation method,and the corresponding identification results were compared with the results from the polynomial fitting method.The effectiveness of the proposed algorithm has been validated through the comparative experiment.
