The geometries of the molecules of eight organic additives were optimized and the net charge,E HOMO andE LUMO were obtained using AM method, respectively. The result shows that there is the correlation between the lev...The geometries of the molecules of eight organic additives were optimized and the net charge,E HOMO andE LUMO were obtained using AM method, respectively. The result shows that there is the correlation between the leveling property and the frontier orbital energy levels of these additives, and the adsorption models and leveling mechanics were discussed. The rule between the frontier orbital energy levels and the leveling property is verified by the experiments.展开更多
The synthetic fuzzy assessing method is usually applied to sensory evaluation. The method has simple and reliable virtue, and it is consistent with objective evaluation results. Using this method, system status of pla...The synthetic fuzzy assessing method is usually applied to sensory evaluation. The method has simple and reliable virtue, and it is consistent with objective evaluation results. Using this method, system status of plating solution evaporator is evaluated, and the result is applied to compensate a fuzzy controller. Experimental results have shown the correctness and the validity of the proposed approach.展开更多
A new analytical study on stresses around a post-tensioned anchor in rocks with two perpendicular joint sets is presented. The assumptions of orthotropic elastic rock with plane strain conditions are made in derivatio...A new analytical study on stresses around a post-tensioned anchor in rocks with two perpendicular joint sets is presented. The assumptions of orthotropic elastic rock with plane strain conditions are made in derivation of the formulations. A tri-linear bond-slip constitutive law is used for modeling the tendon-grout interface behavior and debonding of this interface. The bearing plate width is also considered in the analysis. The obtained solutions are in the integral forms and numerical techniques that have been used for evaluation. In the illustrative example given, the major principal stress is compressive in the anchor free zone and compressive stress concentrations of 815 k Pa and 727 k Pa(for the anchor load of 300 k N) are observed under the bearing plate and the bond length proximal end, respectively. However, large values of tensile stresses with the maximum of-434 k Pa are formed at the bond length distal end. The results obtained using the proposed solution are compared very those of numerical method(FEM).展开更多
This paper discusses the elastic equilibrium problems of anisotropic skew thin plate of variable thickness simply supported on all four sides in nonlinear theories, and uses the Navier method to seek an approach to th...This paper discusses the elastic equilibrium problems of anisotropic skew thin plate of variable thickness simply supported on all four sides in nonlinear theories, and uses the Navier method to seek an approach to the problem, and to illustrate the solution with the examples. In conclusion, the mention is made of the scope of application and the convergency of the solution.展开更多
In this paper, Von Karman's set of nonlinear equations for rectangular plates with large deflection is divided into several sets of linear equations by perturbation method, the dimensionless center deflection bein...In this paper, Von Karman's set of nonlinear equations for rectangular plates with large deflection is divided into several sets of linear equations by perturbation method, the dimensionless center deflection being taken as a perturbation parameter. These sets of linear equations are solved by the spline finite-point (SFP) method and by the spline finite element (SFE) method. The solutions for rectangular plates having any length-to-width ratios under a uniformly distributed load and with various boundary conditions are presented, and the analytical formulas for displacements and deflections are given in the paper. The computer programs are worked out by ourselves. Comparison of the results with those in other papers indicates that the results of this paper are satisfactorily better.展开更多
In this paper ,the bending problem of the non-homogeneous cylindrical orthotropiccircular plate is described.A general solution for the bending of circular plate underuniformly distributed transverse load is solved.an...In this paper ,the bending problem of the non-homogeneous cylindrical orthotropiccircular plate is described.A general solution for the bending of circular plate underuniformly distributed transverse load is solved.and the exact solution of such circularplate with clamped edges is obtained.展开更多
In this paper,reciprocal theorem method(RTM) is generalized to solve theof bending of thick rectangular plates based on Reissner’s theory.First,the paper gives the basic solution of the bending of thick rectangular p...In this paper,reciprocal theorem method(RTM) is generalized to solve theof bending of thick rectangular plates based on Reissner’s theory.First,the paper gives the basic solution of the bending of thick rectangular platesand then the exact analytical solution of the bending of thick rectangular plate withthree clamped edges and one free edge under umiformly distributed load is found byRTM, finally, we analyze numerical results of the sohution.展开更多
An analysis is performed to study the heat transfer characteristics of steady two-dimensional boundary layer flow past a moving permeable flat plate in a nanofluid. The effects of uniform suction and injection on the ...An analysis is performed to study the heat transfer characteristics of steady two-dimensional boundary layer flow past a moving permeable flat plate in a nanofluid. The effects of uniform suction and injection on the flow field and heat transfer characteristics are numerically studied by using an implicit finite difference method. It is found that dual solutions exist when the plate and the free stream move in the opposite directions. The results indicate that suction delays the boundary layer separation, while injection accelerates it.展开更多
基金The National Natural Science Foundation of China(59331030)
文摘The geometries of the molecules of eight organic additives were optimized and the net charge,E HOMO andE LUMO were obtained using AM method, respectively. The result shows that there is the correlation between the leveling property and the frontier orbital energy levels of these additives, and the adsorption models and leveling mechanics were discussed. The rule between the frontier orbital energy levels and the leveling property is verified by the experiments.
文摘The synthetic fuzzy assessing method is usually applied to sensory evaluation. The method has simple and reliable virtue, and it is consistent with objective evaluation results. Using this method, system status of plating solution evaporator is evaluated, and the result is applied to compensate a fuzzy controller. Experimental results have shown the correctness and the validity of the proposed approach.
文摘A new analytical study on stresses around a post-tensioned anchor in rocks with two perpendicular joint sets is presented. The assumptions of orthotropic elastic rock with plane strain conditions are made in derivation of the formulations. A tri-linear bond-slip constitutive law is used for modeling the tendon-grout interface behavior and debonding of this interface. The bearing plate width is also considered in the analysis. The obtained solutions are in the integral forms and numerical techniques that have been used for evaluation. In the illustrative example given, the major principal stress is compressive in the anchor free zone and compressive stress concentrations of 815 k Pa and 727 k Pa(for the anchor load of 300 k N) are observed under the bearing plate and the bond length proximal end, respectively. However, large values of tensile stresses with the maximum of-434 k Pa are formed at the bond length distal end. The results obtained using the proposed solution are compared very those of numerical method(FEM).
文摘This paper discusses the elastic equilibrium problems of anisotropic skew thin plate of variable thickness simply supported on all four sides in nonlinear theories, and uses the Navier method to seek an approach to the problem, and to illustrate the solution with the examples. In conclusion, the mention is made of the scope of application and the convergency of the solution.
文摘In this paper, Von Karman's set of nonlinear equations for rectangular plates with large deflection is divided into several sets of linear equations by perturbation method, the dimensionless center deflection being taken as a perturbation parameter. These sets of linear equations are solved by the spline finite-point (SFP) method and by the spline finite element (SFE) method. The solutions for rectangular plates having any length-to-width ratios under a uniformly distributed load and with various boundary conditions are presented, and the analytical formulas for displacements and deflections are given in the paper. The computer programs are worked out by ourselves. Comparison of the results with those in other papers indicates that the results of this paper are satisfactorily better.
文摘In this paper ,the bending problem of the non-homogeneous cylindrical orthotropiccircular plate is described.A general solution for the bending of circular plate underuniformly distributed transverse load is solved.and the exact solution of such circularplate with clamped edges is obtained.
文摘In this paper,reciprocal theorem method(RTM) is generalized to solve theof bending of thick rectangular plates based on Reissner’s theory.First,the paper gives the basic solution of the bending of thick rectangular platesand then the exact analytical solution of the bending of thick rectangular plate withthree clamped edges and one free edge under umiformly distributed load is found byRTM, finally, we analyze numerical results of the sohution.
基金supported by a research grant from the Universiti Kebangsaan Malaysia (Project Code: UKM-GGPM-NBT-080-2010)
文摘An analysis is performed to study the heat transfer characteristics of steady two-dimensional boundary layer flow past a moving permeable flat plate in a nanofluid. The effects of uniform suction and injection on the flow field and heat transfer characteristics are numerically studied by using an implicit finite difference method. It is found that dual solutions exist when the plate and the free stream move in the opposite directions. The results indicate that suction delays the boundary layer separation, while injection accelerates it.
