Multi-band polarization switch based on magnetic fluid filled dual-core photonic crystal fiber

The research of high-performance polarization controllers is of great significance for expanding the application field of polarization optics. Here, a polarization switch is demonstrated by using a dual-core photonic crystal fiber(DCPCF)with four symmetrical air holes, placed above and below each core, filled with magnetic fluid(MF). The switch, which utilizes a magnetic field to change the coupling length ratio of the x and y polarization modes, enables dynamic tuning of the polarization state and extinction ratio. Numerical results show that when the working length is 36.638 mm, the magneto–optical polarization switch can operate in four communication bands, i.e., 1509 nm to 1520 nm, 1544 nm to1556 nm, 1578 nm to 1591 nm, and 1611 nm to 1624 nm. Moreover, the extinction ratio(ER) is greater than 20 d B in the fiber length range of 38.5 mm to 38.7 mm, indicating that the device has a good fault tolerance for the interception of the fiber length.

Faster vortex core switching with lower current density using three-nanocontact spin-polarized currents in a confined structure

We perform micromagnetic simulations on the switching of magnetic vortex core by using spin-polarized currents through a three-nanocontact geometry. Our simulation results show that the current combination with an appropriate current flow direction destroys the symmetry of the total effective energy of the system so that the vortex core can be easier to excite,resulting in less critical current density and a faster switching process. Besides its fundamental significance, our findings provide an additional route to incorporating magnetic vortex phenomena into data storage devices.

Power-induced polarization switching and bistability characteristics in 1550-nm VCSELs subjected to orthogonal optical injection

The polarization switching（PS） and polarization bistability（PB） characteristics of a 1550-nm vertical-cavity surfaceemitting laser（VCSEL） subjected to orthogonal optical injection are systematically investigated.The simulated results show that the PS and polarization-resolved nonlinear dynamical states of the VCSEL are critically dependent on the changing paths of the injected power.The polarization dynamics for different scanning directions of the injected power is presented to explain the polarization evolution during the formation of PS.In the case of forward scanning injected power,with the increase of frequency detuning level between the VCSEL and the injected light,the injected power required for PS gradually increases for negative frequency detuning but exhibits fluctuations for positive frequency detuning.In the case of reversely scanning injected power,the injected power required for PS displays fluctuant changes within the whole frequency detuning range.Specifically,PS may disappear under certain negative frequency detuning and large bias current.Furthermore,the hysteresis width as a function of the frequency detuning is calculated,and the regions for the appearance and disappearance of PB have been determined in the parameter space of the bias current and frequency detuning.

Broad-Band All-Optical Wavelength Conversion of Differential Phase-Shift Keyed Signal Using an SOA-Based Nonlinear Polarization Switch

Broad-band all-optical wavelength conversion of differential phase-shift keyed （DPSK） signal is experimentally demonstrated. This scheme is composed of a one-bit delay interferometer demodulation stage followed by a semiconductor optical amplifier （SOA） based nonlinear polarization switch. A wavelength converter for the 10 G b/s DPSK signal is presented, which has a wide wavelength range of more than 30 nm. The converted signals experience small power penalties less than 1.4 dB compared with the original signal, at a bit error rate of 10-9. Additionally, the optical spectra, the measured waveforms and the open eye diagrams of the converted signals show a high quality wavelength conversion performance.

Polarization switching in a quasi-isotropic microchip Nd:YAG laser induced by optical feedback

This paper demonstrates the influence of external optical feedback on the polarization state of longitudinal modes in quasi-isotropic microchip Nd：YAG lasers. Under optical feedback, the polarization state of longitudinal modes in quasi-isotropic lasers relies strongly on the intracavity anisotropy loss and mode competition. When the intracavity anisotropy loss is small, external optical feedback can cause polarization switching and strong mode competition between two orthogonal linearly polarized eigenstates of one laser longitudinal mode, which leads to the distortion of laser intensity modulation waveform. The polarization switching is independent of the initial external cavity length. By increasing the intracavity anisotropy loss, one polarization eigenstate can be suppressed and the laser works in single-polarization state. A theoretical analysis based on the compound cavity model is presented, which is in good agreement with the experimental results. The results offer guidance to the development of laser feedback interferometers.

A Quantitative LC-MS/MS Study of the Partitioning, Transport, and Fate of Pesticide Residues on Soil

Titration of pesticides onto sorption sites can determine sorption capacities on soils. Previous studies have tracked the sorption capacities and detailed kinetics of the uptake of atrazine and its decomposition byproduct hydroxyatrazine on different soils, including measurements made using LC-MS/MS. These studies have now been extended to explore sorption-desorption equilibria for a mixture of pesticides from soil using LC-MS/MS. Desorption of sorbed pesticide residues has environmental regulatory implications for pesticide levels in runoff, or for longer term sequestration, partitioning, and transport. The uptake of pesticides by the soil at equilibrium was measured for a number of different concentrations, and sorption capacities were estimated. Pesticide-soil interaction studies were conducted by exposing standard stock solutions of pesticide mixtures to a characterized Nova Scotia soil. The mixture contained atrazine and dicamba. Initial aqueous mixture concentrations ranging from 5 × 10-9 to 10-5 M or greater were exposed to 25 mg aliquots of soil and allowed to reach equilibrium. The total uptake of each pesticide was measured indirectly, by measuring the concentration remaining in solution using an IONICS 3Q 120 triple quadrupole mass spectrometer. These sorption capacities have been supplemented by studies examining equilibrium recovery rates from soil aliquots with different initial uptakes. This gives insight into the fraction of easily recoverable (reversibly sorbed) pesticides on the soil. Proper quantification of equilibrium constants and kinetic rate coefficients using high performance LC-MS/MS facilitates the construction of accurate, predictive models. Predictive kinetic models can successfully mimic the experimental results for solution concentration, labile sorption, and intra-particle diffusion, and could be used to guide regulatory practices.

Reconfigurable dynamic all-optical chaotic logic operations in an optically injected VCSEL

In a chaotic system of vertical cavity surface emitting laser （VCSEL） with external optical-injection, we propose a novel implementation scheme for reconfigurable dynamic all-optical chaotic logic operations （AOCLOs）. Under different key parameters, such as the bias current, the injection strength and the frequency detuning of the injected light field and the VCSEL, we also explore the evolutions of the polarization-bistability with the amplitude of the injected light field when the output of VCSEL is chaotic wave. According to the dynamic evolutions, we find out the optimal value of the frequency detuning that is considered as a control logic signal, and further implement different AOCLOs, such as AND, NAND, OR, NOR, XOR, and XNOR, by controlling the logic operation of the control logic signal between two logic inputs. Moreover, the ability to reconstruct these logic operations is demonstrated under relatively low noise strength of the spontaneous emission.

Nonlinear and Rate-Dependent Hysteretic Responses of Active Hybrid Composites

Nonlinear electro-mechanical behaviors of piezoelectric materials and viscoelastic nature of polymers result in the overall nonlinear and hysteretic responses of active polymeric composites. This study presents a hybrid-unit-cell model for obtaining the effective nonlinear and rate-dependent hysteretic electro-mechanical responses of hybrid piezocomposites. The studied hybrid piezocomposites consist of unidirectional piezoelectric fibers embedded in a polymeric matrix, which is reinforced with piezoelectric particles. The hybrid-unit-cell model is derived based on a unit-cell model of fiber-reinforced composites consisting of fiber and matrix subcells, in which the matrix subcells are comprised of a unit-cell model of particle-reinforced composites. Nonlinear electro-mechanical responses are considered for the piezoelectric constituents while a viscoelastic solid constitutive model is used for the polymer constituent. The hybrid-unit cell model is used to examine the effects of different responses of the constituents, microstructural arrangements, and loading histories on the overall nonlinear and hysteretic electro-mechanical responses of the hybrid piezocomposites, which are useful in designing active polymeric composites.

O-band reconfigurable silicon polarization rotator

Silicon waveguides typically exhibit optical anisotropy,which leads to polarization correlation and single-polarization operations.This consequently creates a demand for polarization-control devices.This paper introduces a CMOS-compatible O-band reconfigurable TE/TM polarization rotator comprising two symmetrical polarization rotator-splitters and phase shifters.This configuration enables dynamic conversion of any linear polarization to its quadratic equivalent.Experimental results indicate that the reconfigurable polarization rotator exhibits an insertion loss of less than 1.5 dB.Furthermore,the bandwidth for a polarization extinction ratio beyond 15 dB exceeds 60 nm.

On ferroelectric domain polarization switching mechanism subject to an external electric field by simulations with the phase-field method

The ferroelectric domain formation(FDF) and polarization switching(FDPS) subjected to an external electric field are simulated using the phase-field(PF) method,and the FDPS mechanism under different external electric fields is discussed.The results show that the FDF is a process of nucleation and growth in ferroelectric without applying any external stress.Four kinds of parallelogram shaped ferroelectric domains are formed at the steady state,in which the 180° anti-phase domains regularly align along the 45° direction and the 90° anti-phase domains regularly distribute like a stepladder.Steady electric fields can rotate domain polarization by 90° and 180°,and force the orientation-favorite domains and the average polarization to grow into larger ones.The greater the steady electric field,the larger the average polarization at the steady state.In ferroelectrics subject to an alternating electric field,domain polarization switches to cause a hysteresis loop and an associated butterfly loop with the alternating electric field.The coercive field and remnant field are enhanced with the increase of the electric field frequency or strength,or with the decrease of temperature.

Spin filtering magnetic modulation and spin-polarization switching in hybrid ferromagnet/semiconductor structures

Electron spin-polarization modulation with a ferromagnetic strip of in-plane magnetization is analyzed in a hybrid ferromagnet/semiconductor filter device.The dependencies of electron spin-polarization on the strip’s magnetization strength,width and position have been systematically investigated.A novel magnetic control spin-polarization switch is proposed by inserting a ferromagnetic metal(FM)strip eccentric in relation to off the center of the spin filter,which produces the first energy level spin-polarization reversal.It is believed to be of significant importance for the realization of semiconductor spintronics multiple-value logic devices.

Near-infrared fundus camera based on polarization switch in stray light elimination

This letter shows that the human eye fundus tissue has higher reflectivity at the near-infrared （NIR） wavelength, and that some aberrations exist at the pre-optical system from cornea to vitreous. We design a NIR fundus camera with inner focusing, which can be applied to the -10 D to 10 D range of vision and has the advantage of ensuring the stability of image when is focused. Considered as Liou＇s eye aberration model, we correct the integrated aberration to ensure a 100 lp/mm resolution when we complete the assembly and calibration of the fundus camera. Kohler illumination is also applied to obtain uniform fundus illumination. Moreover, we put forward a novel method for stray light elimination based on polarization switch, which inhibits ghost image formation near the focal plane when the illumination beam is reflected by the eyepiece surface. The result shows that this method is effective in ensuring an illumination uniformity of 80%, with the advantage of simple structure and easy assembly.

Mode hopping and polarization switching of mutually coupled vertical-cavity surface-emitting lasers

We perform a theoretical study on the polarization-resolved compound lasing mode （CLM） of two mutually coupled vertical-cavity surface-emitting lasers （VCSELs）. Different solutions of CLMs are derived though stability analysis of the spin-flip model. The dynamical evolvements of CLMs with the existence of polarization degrees of freedom are also charactered. The most stable CLM with the smallest carrier density tend to be excited, since the gain needed for this mode to emit is the lowest. In the given system, varying values of injection rate or birefringence, etc., will change the generation of the preferred CLMs in the two polarization directions, and thus influence the polarization switching （PS） characteristics. Thus, hoppings between CLMs are also companied by PSs. Through mapping of average power in the parameter space, the influences of coupling rate and anisotropy parameters （linear dichroism and linear birefringence） on PS and hopping between CLMs are discussed.

P-Type Chemical Doping-Induced High Bipolar Electrical Conductivities in a Thermoelectric Donor–Acceptor Copolymer

Typically,conducting polymers transfer either electrons or holes.It is rare to see high bipolar(p-and n-type)electrical conductivities within a single bulk doped organic polymer without the assistant of gate voltage.Herein,we report that FeCl3-doped solutionprocessable D–A copolymer poly(2,5-bis(2-octyldo decyl)-3,6-di(thiophen-2-yl)diketopyrrolo[3,4-c]pyrrole-1,4-dione-alt-thieno[3,2-b]thiophen)(DPPTTT)could exhibit a high p-type electrical conductivity of 130.6 S/cm and a good n-type electrical conductivity of 14.2 S/cm by engineering the doping level.

All-Optical Flip-Flop Based on Coupled SOA-PSW

The semiconductor optical amplifier （SOA） has obvious advantages in all-optical signal processing, because of the simple structure, strong non-linearity, and easy integration. A variety of all-optical signal processing functions, such as all-optical wavelength conversion, all-optical logic gates and all-optical sampling, can be completed by SOA. So the SOA has been widespread concerned in the field of all-optical signal processing. Recently, the polarization rotation effect of SOA is receiving considerable interest, and many researchers have launched numerous research work utilizing this effect. In this paper, a new all-optical flip-flop structure using polarization switch （PSW） based on polarization rotation effect of SOA is presented.