The regulated gaseous emissions from 2 China-V compressed natural gas(CNG)buses and 2 China-V diesel buses were investigated using a portable emissions measurement system(PEMS)under real road driving conditions.Compar...The regulated gaseous emissions from 2 China-V compressed natural gas(CNG)buses and 2 China-V diesel buses were investigated using a portable emissions measurement system(PEMS)under real road driving conditions.Compared to diesel buses,CNG buses emit less NOx pollutants,but more HC and CO pollutants based on the test results obtained in this paper.In order to evaluate the pollutant emission status of CNG buses in Beijing,an instantaneous emission model as a function of vehicle speed and vehicle specific power(VSP)was developed and validated based on emission data taken from one CNG bus.The input of the instantaneous emission model consists of driving cycle,vehicle parameters,road conditions,ambient conditions and accessory use,all of which were used to calculate the instantaneous vehicle specific power(VSP).For the core model,a group of pollutant emission maps represented as functions of vehicle speed and VSP were used to calculate the second by second emission rates.Finally,the instantaneous emission rates,emission factors and fuel consumption over the selected driving cycle could be obtained as the model outputs.The predicted results for the emissions and fuel consumption of the CNG bus were very close to the tested emission data.The prediction errors for emission factors and fuel consumption varied in the range of-1.6 2%to-5.8%.展开更多
Biodiesel has generated increased interest recently as an alternative to petroleum-derived diesel. Due to its high oxygen content, biodiesel typically burns more completely than petroleum diesel, and thus has lower em...Biodiesel has generated increased interest recently as an alternative to petroleum-derived diesel. Due to its high oxygen content, biodiesel typically burns more completely than petroleum diesel, and thus has lower emissions of hydrocarbons (HC), carbon monoxide (CO), and particulate matter (PM). However, biodiesel may increase or decrease nitrogen oxide (NOx) and carbon dioxide (CO2) emissions, depending on biodiesel feedstock, engine type, and test cycle. The purpose of this study was to compare emissions from 20% blends of biodiesel made from 4 feedstocks (soybean oil, canola oil, waste cooking oil, and animal fat) with emissions from ultra low sulfur diesel (ULSD). Emissions of NOx and CO2 were made under real-world driving conditions using a Horiba On-Board Measurement System OBS-1300 on a highway route and arterial route;emissions of NOx, CO2, HC, CO, and PM were measured in a controlled setting using a chassis dynamometer with Urban Dynamometer Drive Schedule. Dynamometer test results showed statistically significant lower emissions of HC, CO, and PM from all B20 blends compared to ULSD. For CO2, both on-road testing (arterial, highway, and idling) and dynamometer testing showed no statistically significant difference in emissions among the B20 blends and ULSD. For NOx, dynamometer testing showed only B20 from soybean oil to have statistically significant higher emissions. This is generally consistent with the on-road testing, which showed no statistically significant difference in NOx emissions between ULSD and the B20 blends.展开更多
在中国城市客车行驶工况条件下,运用车载排放测试技术(portable em ission measurement sys-tem,简称PEMS)研究了某重型混合动力客车在怠速运转时采取停机和不停机两种不同控制策略下的实际排放因子和燃油消耗率.试验研究结果表明,停机...在中国城市客车行驶工况条件下,运用车载排放测试技术(portable em ission measurement sys-tem,简称PEMS)研究了某重型混合动力客车在怠速运转时采取停机和不停机两种不同控制策略下的实际排放因子和燃油消耗率.试验研究结果表明,停机模式比不停机模式可提高该车燃油经济性4.6%,但CO排放因子却增加了53.6%;怠速不停机时,HC+NOx排放增加20.6%.同时说明对于混合动力车辆的油耗和排放,特别是排放的评价,应当采取基于整车的评价方法.展开更多
Non-road equipment is one of the key contributing sources to air pollution.Thus,an accurate development of emission inventory from non-road equipment is imperative for air quality management,especially for equipment w...Non-road equipment is one of the key contributing sources to air pollution.Thus,an accurate development of emission inventory from non-road equipment is imperative for air quality management,especially for equipment with a large population such as diesel-fueled forklifts.The objective of this paper is to characterize duty-cycle based emissions from diesel-fueled forklifts using a portable emission measurement system(PEMS).Three dutycycles were defined in this study,including idling,moving,and working(active duty operation)and used to characterize in-use emissions for diesel-fueled forklifts.A total of twelve diesel-fueled forklifts were selected for real-world emission measurements.Results showed that fuel-based emission factors appear to have smaller variability compared to time-based ones.For example,the time-based emission factors for CO,HC,NO,and PM 2.5 for forklifts were estimated to be 16.6-43.9,5.3-15.1,26.2-49.9,5.5-11.1 g/hr with the fuel-based emission factors being 12.1-20.3,4.1-8.3,19.1-32.4,3.5-6.5 g/kg-fuel,respectively.NO emissions appear to be the biggest concern for emissions control.Furthermore,most of the emissions factors estimated from this study are significantly different from those in both National Guideline for Emission Inventory Development for Non-Road Equipment in China and welldeveloped emission factor models such as NONROAD by US EPA.This implies that localized,preferably fuel-based emission factors should be adjusted based on real-world emission measurements in order to develop a representative emission inventory for non-road equipment.展开更多
A total of 14 in-use diesel buses were selected to conduct emission measurement using a portable emissions measurement system （PEMS） in Beijing. Their instantaneous gaseous emission rates, particular matter （PM） e...A total of 14 in-use diesel buses were selected to conduct emission measurement using a portable emissions measurement system （PEMS） in Beijing. Their instantaneous gaseous emission rates, particular matter （PM） emission rates and driving parameters were obtained. The influences of speed, acceleration and vehicle specific power （VSP） on emissions were analyzed. Based on the relationships between these driving parameters and emissions, 24 driving bins defined by speed, ac- celeration and VSP were constructed with cluster analysis to group emission rates for Euro Ⅲ and IV buses, respectively. Then the emissions reductions from Euro Ⅲ to Euro Ⅳ diesel buses were ana- lyzed. Lastly, on-road hot-stabilized emission rate model for diesel buses in Beijing was developed. Through the comparison of the model simulation emission rates with the measured emission rates, the modeled emission results were in good agreement with the measured emission results. In most of the cases, the differences were less than 12 %.展开更多
基金Supported by the National Key Research and Development Plan(2016YFC0208005)the National Natural Science Foundation of China(51576016)
文摘The regulated gaseous emissions from 2 China-V compressed natural gas(CNG)buses and 2 China-V diesel buses were investigated using a portable emissions measurement system(PEMS)under real road driving conditions.Compared to diesel buses,CNG buses emit less NOx pollutants,but more HC and CO pollutants based on the test results obtained in this paper.In order to evaluate the pollutant emission status of CNG buses in Beijing,an instantaneous emission model as a function of vehicle speed and vehicle specific power(VSP)was developed and validated based on emission data taken from one CNG bus.The input of the instantaneous emission model consists of driving cycle,vehicle parameters,road conditions,ambient conditions and accessory use,all of which were used to calculate the instantaneous vehicle specific power(VSP).For the core model,a group of pollutant emission maps represented as functions of vehicle speed and VSP were used to calculate the second by second emission rates.Finally,the instantaneous emission rates,emission factors and fuel consumption over the selected driving cycle could be obtained as the model outputs.The predicted results for the emissions and fuel consumption of the CNG bus were very close to the tested emission data.The prediction errors for emission factors and fuel consumption varied in the range of-1.6 2%to-5.8%.
文摘Biodiesel has generated increased interest recently as an alternative to petroleum-derived diesel. Due to its high oxygen content, biodiesel typically burns more completely than petroleum diesel, and thus has lower emissions of hydrocarbons (HC), carbon monoxide (CO), and particulate matter (PM). However, biodiesel may increase or decrease nitrogen oxide (NOx) and carbon dioxide (CO2) emissions, depending on biodiesel feedstock, engine type, and test cycle. The purpose of this study was to compare emissions from 20% blends of biodiesel made from 4 feedstocks (soybean oil, canola oil, waste cooking oil, and animal fat) with emissions from ultra low sulfur diesel (ULSD). Emissions of NOx and CO2 were made under real-world driving conditions using a Horiba On-Board Measurement System OBS-1300 on a highway route and arterial route;emissions of NOx, CO2, HC, CO, and PM were measured in a controlled setting using a chassis dynamometer with Urban Dynamometer Drive Schedule. Dynamometer test results showed statistically significant lower emissions of HC, CO, and PM from all B20 blends compared to ULSD. For CO2, both on-road testing (arterial, highway, and idling) and dynamometer testing showed no statistically significant difference in emissions among the B20 blends and ULSD. For NOx, dynamometer testing showed only B20 from soybean oil to have statistically significant higher emissions. This is generally consistent with the on-road testing, which showed no statistically significant difference in NOx emissions between ULSD and the B20 blends.
文摘在中国城市客车行驶工况条件下,运用车载排放测试技术(portable em ission measurement sys-tem,简称PEMS)研究了某重型混合动力客车在怠速运转时采取停机和不停机两种不同控制策略下的实际排放因子和燃油消耗率.试验研究结果表明,停机模式比不停机模式可提高该车燃油经济性4.6%,但CO排放因子却增加了53.6%;怠速不停机时,HC+NOx排放增加20.6%.同时说明对于混合动力车辆的油耗和排放,特别是排放的评价,应当采取基于整车的评价方法.
文摘针对非道路车辆尾气排放测试中常采用的一种便携式车载尾气排放测试系统(Portable Emissions Measurement System,PEMS)不能实时显示试验状态以及进度,造成试验冗余或不足等问题,设计了一种PEMS试验远程监测系统。该系统由车载端与远程端两部分组成,在基于SAE J1939通信协议下,车载端以C8051F120单片机为主控单元(Main Control Unit,MCU),实现了发动机电控单元(Electronic Control Unit,ECU)数据的解析、CAN总线上数据报文的接收与发送;远程端由C++Builder软件开发平台设计了一款人机交互界面,实现了发动机状态参数的实时显示、有效工作事件的筛选、试验累积功的计算以及试验进度显示等功能;同时车载端与远程端之间以无线方式进行通信。试验结果表明,采用本系统所得到的试验累积功的综合误差在±1.25%之内,证明所设计的系统不仅功能丰富而且具有较高的实时性、可靠性与稳定性,提高了PEMS试验的效率,具有较好的现实意义。
文摘Non-road equipment is one of the key contributing sources to air pollution.Thus,an accurate development of emission inventory from non-road equipment is imperative for air quality management,especially for equipment with a large population such as diesel-fueled forklifts.The objective of this paper is to characterize duty-cycle based emissions from diesel-fueled forklifts using a portable emission measurement system(PEMS).Three dutycycles were defined in this study,including idling,moving,and working(active duty operation)and used to characterize in-use emissions for diesel-fueled forklifts.A total of twelve diesel-fueled forklifts were selected for real-world emission measurements.Results showed that fuel-based emission factors appear to have smaller variability compared to time-based ones.For example,the time-based emission factors for CO,HC,NO,and PM 2.5 for forklifts were estimated to be 16.6-43.9,5.3-15.1,26.2-49.9,5.5-11.1 g/hr with the fuel-based emission factors being 12.1-20.3,4.1-8.3,19.1-32.4,3.5-6.5 g/kg-fuel,respectively.NO emissions appear to be the biggest concern for emissions control.Furthermore,most of the emissions factors estimated from this study are significantly different from those in both National Guideline for Emission Inventory Development for Non-Road Equipment in China and welldeveloped emission factor models such as NONROAD by US EPA.This implies that localized,preferably fuel-based emission factors should be adjusted based on real-world emission measurements in order to develop a representative emission inventory for non-road equipment.
基金Supported by State Key Laboratory of Engines(SKLE,200906)the National Natural Science Foundation of China(40805053)
文摘A total of 14 in-use diesel buses were selected to conduct emission measurement using a portable emissions measurement system （PEMS） in Beijing. Their instantaneous gaseous emission rates, particular matter （PM） emission rates and driving parameters were obtained. The influences of speed, acceleration and vehicle specific power （VSP） on emissions were analyzed. Based on the relationships between these driving parameters and emissions, 24 driving bins defined by speed, ac- celeration and VSP were constructed with cluster analysis to group emission rates for Euro Ⅲ and IV buses, respectively. Then the emissions reductions from Euro Ⅲ to Euro Ⅳ diesel buses were ana- lyzed. Lastly, on-road hot-stabilized emission rate model for diesel buses in Beijing was developed. Through the comparison of the model simulation emission rates with the measured emission rates, the modeled emission results were in good agreement with the measured emission results. In most of the cases, the differences were less than 12 %.
