Density,refractive index and liquid–liquid equilibrium data of polyethylene glycol 3000 + potassium formate + water at different pH values

New liquid-liquid equilibrium data for polyethylene glycol （PEG） 3000 ＋ CHO2K ＋ H20 systems were measured at 298.15 K and pH values of 7.95, 8.40 and 9.98. It was found that an increase in pH caused the binodal curve to be displaced downward and the two-phase region to expand. Accordingly, the binodal curve was adjusted to the Pirdashti equation and the tie-line compositions were correlated using the Othmer-Tobias, Bancroft and Hand equations. The study measured the refractive index and densities of several homogeneous binary and ternary solutions. The solutions were used for calibration within a range of 0% to 30% of the mass of the PEG and potassium formate. The density and refractive index data show a linear variation with the mass fraction of the polymer and the salt. The effect of pH on the binodal, tie-line lengths （TLL） and slope of the tie-line （STL） in the systems was exam- ined. It was found that an increase in pH increased the TLL and decreased the STL It was observed that the density of the aqueous two-phase system was influenced by the TLL The difference in density between phases （△p） increased as the TLL and pH increased. It was found that the TLL and Ap showed a linear relationship. The effective excluded volume （EEV） of the PEG was obtained and it was found that EEV also increased as the pH increased.

A Novel Fracturing Fluid with High-Temperature Resistance for Ultra-Deep Reservoirs

Ultra-deep reservoirs play an important role at present in fossil energy exploitation.Due to the related high temperature,high pressure,and high formation fracture pressure,however,methods for oil well stimulation do not produce satisfactory results when conventional fracturing fluids with a low pumping rate are used.In response to the above problem,a fracturing fluid with a density of 1.2~1.4 g/cm^(3)was developed by using Potassium formatted,hydroxypropyl guanidine gum and zirconium crosslinking agents.The fracturing fluid was tested and its ability to maintain a viscosity of 100 mPa.s over more than 60 min was verified under a shear rate of 1701/s and at a temperature of 175℃.This fluid has good sand-carrying performances,a low viscosity after breaking the rubber,and the residue content is less than 200 mg/L.Compared with ordinary reconstruction fluid,it can increase the density by 30%~40%and reduce the wellhead pressure of 8000 m level reconstruction wells.Moreover,the new fracturing fluid can significantly mitigate safety risks.

Effects of heterofunctional alkali-metal formate doping on perovskite solar cell performance

Various internal and external defects present in the perovskite film are one of the main factors that causelow efficiency and stability, and in order to realize high-performance perovskite solar cells, it is necessaryto develop a method to effectively suppress them. In this study, a heterofunctional dopants strategy wasattempted to integrate the effect of alkali metal cations (Rbþ and Kþ) and formate anion (HCOO) throughdoping engineering with alkali-metal formates, i.e., rubidium formate (RbHCOO) and potassium formate(KHCOO). Inclusive physical and photoelectric analysis revealed that doping with a small amount ofalkali-metal formate leads to crystal growth and reduction of grain boundaries, and further passivates orinhibits bulk and surface defects. As a result, the photogenerated charge recombination was reduced andthe charge carrier transport was improved, leading to improved PSC performance. RbHCOO-dopedinverted planar PSCs achieved a PCE of up to 20.41% with long-term stability. Our findings provide away for producing high-quality perovskite films with low defect densities that are essential for realizinghigh-performance PSCs.