A set of device is designed based on PC to realize the functions of traditional potentiostats in the phase ana1ysis of galvanochemistry. In the device, A/D and D/A conversion is used to measure the electrode potential...A set of device is designed based on PC to realize the functions of traditional potentiostats in the phase ana1ysis of galvanochemistry. In the device, A/D and D/A conversion is used to measure the electrode potential and convert the voltage for outPut; specific program runs in the PC to regulate and control the system. The effect of the proportion factor Kp on the control variation is researched through certain experiment. Two experiments, the control of electrolysis in constant poteniial and the determination of polarization curves, are designed to test and evaluate the effectiveness of the device. The experimemel results show that the variation between the actualanode potential and the target potential could be controlled to below 1 mV if Kp is set to an appropriate value.展开更多
A low component count, microcontroller-based potentiostat circuit was developed through the use of operational amplifiers arranged in different feedback configurations. This was developed to alleviate the cost burden ...A low component count, microcontroller-based potentiostat circuit was developed through the use of operational amplifiers arranged in different feedback configurations. This was developed to alleviate the cost burden of equipment procurement in low-cost and budget applications. Simplicity was achieved in the design by the use of the microcontroller’s native functionalities and a low-cost R/2R resistor ladder digital-to-analogue converter. The potentiostat was used to investigate the Ni2+/Ni(s) redox couple in a 3-electrode cell with a silver/silver chloride reference electrode and graphite counter and working electrodes. Linear sweep voltammograms were ob-tained at scan rates of 10, 20, 30 and 40 mV/s. The analysis of the peak current versus (scan rate)1/2 plot indicated that the Ni2+/Ni(s) reduction, though conforming to the Randles-Sevcik equation, was a non-reversible redox reaction.展开更多
A novel electrochemical method for the rapid detection of organophosphorus pesticide residues was realized on a dual-channel screen-printed electrode （DSPE） that was integrated with a portable smartphone-controlled ...A novel electrochemical method for the rapid detection of organophosphorus pesticide residues was realized on a dual-channel screen-printed electrode （DSPE） that was integrated with a portable smartphone-controlled potentiostat. The two carbon working channels of DSPE were first modified by electrodepositing of Prussian blue. The channels were then modified with acetylcholinesterase （ACHE） via Nation. The inhibition ratio of AChE was detected by comparing the electrical current of acetylthiocholine （ATCh） that was catalyzed by the enzyme electrodes with （channel 1） and without （channel 2） organophosphorus pesticide. Inhibition ratios were related with the negative logarithm of the organophosphorus pesticide （trichlorfon, oxamyl, and isocarbophos） concentrations at optimum experimental conditions （pH 6.9 of electrolyte, 0.2V working potential, 2.5μL AChE modification amount, and 15 min inhibition time）. The linear equations were 1%=32.301gC＋ 253.3 （R=0.9750） for isocarbophos, I% = 35.991gC＋ 270.1 （R = 0.9668） for chlorpyrifos, and 1% = 33.701gC＋ 250.5 （R = 0.9606） for trichlorfon. The detection limits were calculated as 10-7 g/mL. Given that the inhibition ratios were only related with pesticide concentration and not with pesticide species, the proposed electrodes and electrometer can rapidly detect universal organophosphorus pesticides and assess pesticide pollution.展开更多
Electrochemical methods have been widely used in the chemical and pharmaceutical industries, which require accurate concentration measurements, chemical reaction detections and analyses. The electrochemical potentiost...Electrochemical methods have been widely used in the chemical and pharmaceutical industries, which require accurate concentration measurements, chemical reaction detections and analyses. The electrochemical potentiostat, the core element in electrochemical instruments, have been discussed as a hot topic addressing the difficulty of applying high-precision constant voltage and picoampere current measurements. Meanwhile, reliable potentiostats are in demand for complicated industrial environments with noises as well as requirements of remotemonitors. This paper describes a potentiostat for industrial glucose measurement that is not only accurate but also fault tolerant to guarantee high reliability in industrial environments. The instrument uses standard industrial communication protocols, proflbus, and a 4-20 mA current loop, for remote control and monitoring. Experimental results show that this design has 0.01% accuracy with 1 mV resolution for voltage applications and 0.01% accuracy with 1 pA resolution for current measurements. The design is also shown to be highly reliable in noisy environments.展开更多
The coordination polymer poly(nickel-ethylenetetrathiolate)(poly(Ni-ett)), formed by nickel(II) and 1,1,2,2-ethenetetrathiolate(ett), is the most promising N-type organic thermoelectric material ever reported; it is s...The coordination polymer poly(nickel-ethylenetetrathiolate)(poly(Ni-ett)), formed by nickel(II) and 1,1,2,2-ethenetetrathiolate(ett), is the most promising N-type organic thermoelectric material ever reported; it is synthesized via potentiostatic deposition,and the effect of different applied potentials on the optimal performance of the polymers is investigated. The optimal thermoelectric property of poly(Ni-ett) synthesized at 0.6 V is remarkably greater than that of the polymers synthesized at 1 and 1.6 V, exhibiting a maximum power factor of up to 131.6 μW/mK^2 at 360 K. Furthermore, the structure-property correlation of poly(Ni-ett) is also extensively investigated. X-ray diffraction(XRD) and X-ray photoelectron spectroscopy(XPS) analyses revealed that the larger size of crystalline domains and the higher oxidation state of poly(Ni-ett) synthesized at 0.6 V possibly results in the higher bulk mobility and carrier concentration in the polymer chains, respectively, accounting for the enhanced power factor.展开更多
在353K的乙酰胺-尿素-N aB r熔体中,P t、Cu电极上,Co(Ⅱ)+2e→Co(0)是一步完全不可逆反应,测得0.060m o l.L-1CoC l2-乙酰胺-尿素-N aB r中,Co(Ⅱ)在P t上,传递系数α=0.28,扩散系数D0=4.68×10-5cm2.-s 1,Cu上α=0.28,D0=4.06...在353K的乙酰胺-尿素-N aB r熔体中,P t、Cu电极上,Co(Ⅱ)+2e→Co(0)是一步完全不可逆反应,测得0.060m o l.L-1CoC l2-乙酰胺-尿素-N aB r中,Co(Ⅱ)在P t上,传递系数α=0.28,扩散系数D0=4.68×10-5cm2.-s 1,Cu上α=0.28,D0=4.06×1-0 7cm2.-s 1。G d(Ⅲ)不能单独还原为G d(0),但可以被Co(Ⅱ)诱导共沉积。由恒电位电解法得到非晶态的G d-Co合金,G d的含量随阴极电位的负移,G d(Ⅲ)/N i(Ⅱ)摩尔比增大以及电解时间延长而增大。展开更多
文摘A set of device is designed based on PC to realize the functions of traditional potentiostats in the phase ana1ysis of galvanochemistry. In the device, A/D and D/A conversion is used to measure the electrode potential and convert the voltage for outPut; specific program runs in the PC to regulate and control the system. The effect of the proportion factor Kp on the control variation is researched through certain experiment. Two experiments, the control of electrolysis in constant poteniial and the determination of polarization curves, are designed to test and evaluate the effectiveness of the device. The experimemel results show that the variation between the actualanode potential and the target potential could be controlled to below 1 mV if Kp is set to an appropriate value.
文摘A low component count, microcontroller-based potentiostat circuit was developed through the use of operational amplifiers arranged in different feedback configurations. This was developed to alleviate the cost burden of equipment procurement in low-cost and budget applications. Simplicity was achieved in the design by the use of the microcontroller’s native functionalities and a low-cost R/2R resistor ladder digital-to-analogue converter. The potentiostat was used to investigate the Ni2+/Ni(s) redox couple in a 3-electrode cell with a silver/silver chloride reference electrode and graphite counter and working electrodes. Linear sweep voltammograms were ob-tained at scan rates of 10, 20, 30 and 40 mV/s. The analysis of the peak current versus (scan rate)1/2 plot indicated that the Ni2+/Ni(s) reduction, though conforming to the Randles-Sevcik equation, was a non-reversible redox reaction.
基金financially supported by the Natural Science Foundation of Zhejiang Province(No.LQ17B050002)Analysis and Measurement Foundation of Zhejiang Province(No.2015C37068)
文摘A novel electrochemical method for the rapid detection of organophosphorus pesticide residues was realized on a dual-channel screen-printed electrode （DSPE） that was integrated with a portable smartphone-controlled potentiostat. The two carbon working channels of DSPE were first modified by electrodepositing of Prussian blue. The channels were then modified with acetylcholinesterase （ACHE） via Nation. The inhibition ratio of AChE was detected by comparing the electrical current of acetylthiocholine （ATCh） that was catalyzed by the enzyme electrodes with （channel 1） and without （channel 2） organophosphorus pesticide. Inhibition ratios were related with the negative logarithm of the organophosphorus pesticide （trichlorfon, oxamyl, and isocarbophos） concentrations at optimum experimental conditions （pH 6.9 of electrolyte, 0.2V working potential, 2.5μL AChE modification amount, and 15 min inhibition time）. The linear equations were 1%=32.301gC＋ 253.3 （R=0.9750） for isocarbophos, I% = 35.991gC＋ 270.1 （R = 0.9668） for chlorpyrifos, and 1% = 33.701gC＋ 250.5 （R = 0.9606） for trichlorfon. The detection limits were calculated as 10-7 g/mL. Given that the inhibition ratios were only related with pesticide concentration and not with pesticide species, the proposed electrodes and electrometer can rapidly detect universal organophosphorus pesticides and assess pesticide pollution.
文摘Electrochemical methods have been widely used in the chemical and pharmaceutical industries, which require accurate concentration measurements, chemical reaction detections and analyses. The electrochemical potentiostat, the core element in electrochemical instruments, have been discussed as a hot topic addressing the difficulty of applying high-precision constant voltage and picoampere current measurements. Meanwhile, reliable potentiostats are in demand for complicated industrial environments with noises as well as requirements of remotemonitors. This paper describes a potentiostat for industrial glucose measurement that is not only accurate but also fault tolerant to guarantee high reliability in industrial environments. The instrument uses standard industrial communication protocols, proflbus, and a 4-20 mA current loop, for remote control and monitoring. Experimental results show that this design has 0.01% accuracy with 1 mV resolution for voltage applications and 0.01% accuracy with 1 pA resolution for current measurements. The design is also shown to be highly reliable in noisy environments.
基金supported by the National Basic Research Program of China (2013CB632506)the Strategic Priority Research Program of the Chinese Academy of Sciences (XDB12000000)+1 种基金Key Project of National Natural Science Foundation of China (51336009)National Natural Science Foundation of China (21290191, 21333011)
文摘The coordination polymer poly(nickel-ethylenetetrathiolate)(poly(Ni-ett)), formed by nickel(II) and 1,1,2,2-ethenetetrathiolate(ett), is the most promising N-type organic thermoelectric material ever reported; it is synthesized via potentiostatic deposition,and the effect of different applied potentials on the optimal performance of the polymers is investigated. The optimal thermoelectric property of poly(Ni-ett) synthesized at 0.6 V is remarkably greater than that of the polymers synthesized at 1 and 1.6 V, exhibiting a maximum power factor of up to 131.6 μW/mK^2 at 360 K. Furthermore, the structure-property correlation of poly(Ni-ett) is also extensively investigated. X-ray diffraction(XRD) and X-ray photoelectron spectroscopy(XPS) analyses revealed that the larger size of crystalline domains and the higher oxidation state of poly(Ni-ett) synthesized at 0.6 V possibly results in the higher bulk mobility and carrier concentration in the polymer chains, respectively, accounting for the enhanced power factor.
