Prospect of Clean Coal Technologies to be Used in Fujian Province Power Industry

This paper is based on the existing status and development prediction of Fujian power industry, and describes that the structure of energy sources for generating power which will mainly use coal, will not be changed in the 2010s and 2020s in Fujian Province. In order to meet the requirements of high efficiency and envirofimental protection, the usage of clean coal technologies for power generating will be an inevitable option and the technologies will occupy the important position in Fujian power industry. This paper puts forward the staged targets and measures of developing and utilizing clean coal technologies, suggests that all government depotments related should give support and guarantee in policies and conditions, and welcome technical and economic cooperation at home and abroad, which is good for co-development of both parties.

Investigation of ellipticity and pump power in a passively mode-locked fiber laser using the nonlinear polarization rotation technique

An elliptical initial polarization state is essential for generating mode-locked pulses using the nonlinear polarization rotation technique. In this work, the relationship between the ellipticity ranges capable of maintaining mode-locked operation against different pump power levels is investigated. An increasing pump power, in conjunction with minor adjustments to the polarization controller＇s quarter waveplate, results in a wider ellipticity range that can accommodate mode-locked operation. Other parameters such as noise, pulsewidth, and average output power are also observed to vary as the ellipticity changes.

Experimental demonstration of underwater optical wireless power transfer using a laser diode

We experimentally demonstrate an underwater optical wireless power transfer （OWPT） using a laser diode （LD） as a power transmitter. We investigate the characteristics of a solar cell and a photodiode （PD） as a power receiver. We optimize the LD, the PD, and the solar cell to achieve the maximum transfer efficiency. The maxi- mum transfer efficiency of the back-to-back OWPT is measured as 4.3% with the PD receiver. Subsequently, we demonstrate the OWPT in tap and sea water. Our result shows an attenuation of 3 dB/m in sea water.

Low pump power co-fiber remotely pumped EDFA used in DWDM systems with ultra-long fiber span

In this paper, aiming at practical dense wavelength division multiplexing （DWDM） system with ultralong fiber span, a simple co-fiber remotely pumped erbium-doped fiber amplifier （RP-EDFA） scheme is proposed to extend span distance with simple configuration and low pump power. Equivalent noise figure of -6 dB is achieved under 300-mW pump power. Using the experiment results, numerical simulation of ultra-long span systems shows that for a 40 × 11.6-Gb/s transmission system, the RP-EDFA scheme can support transmission of 1760 km with a fiber span of 160 km. These results demonstrate the potential of the PR-EDFA scheme in ultra-long span transmission.

A useful method for determination of optimal fiber input power in spontaneous Brillouin-scattering-based sensing system

A method for the optimal fiber input power determination is presented by employing the variation characteristics of signal to noise ratio(SNR) in spontaneous Brillouin-scattering-based sensing system. And a heterodyne detection system is constructed for measuring the Brillouin scattering spectra with different fiber input powers. The Brillouin spectrum width and system SNR can be simultaneously measured from these spectra, and the optimal fiber input power can be obtained from such information. In the experiment, for 48.8-km-long standard single-mode fiber(SSMF), the optimal fiber input power values are all approximately 0 dBm obtained by the maximum SNR position for different local oscillator power values and average times.