Pre-activation based stereoselective glycosylations: Stereochemical control by additives and solvent

Stereochemical control is an important issue in carbohydrate synthesis.Glycosyl donors with participating acyl protective groups on 2-O have been shown to give 1,2-trans glycosides reliably under the pre-activation based reaction condition.In this work,the effects of additives and reaction solvents on stereoselectivity were examined using donors without participating protective groups on 2-O.While several triflate salt additives did not have major effects,the amount of AgOTf was found to significantly impact the reaction outcome.Excess AgOTf led to lower stereochemical control presumably due to its coordination with the glycosyl triflate intermediate and a more SN1 like reaction pathway.In contrast,the stereoselectivity could be directed by reaction solvents,with diethyl ether favoring the formation of glycosides and dichloromethane leading to β isomers.The trend of stereochemical dependence on reaction solvent was applicable to a variety of building blocks including the selective formation of β-mannosides.

Comparison of the effects of pre-activators on morphology and corrosion resistance of phosphate conversion coating on magnesium alloy

In this study, Mg–6.0Zn–3.0Sn–0.5Mn(ZTM630) magnesium alloy was pre-activated by colloidal Ti, oxalic acid, and phosphoric acid,and a phosphate conversion coating(PCC) was prepared on the alloy surface. The morphology and corrosion resistance of the prepared PCCs were investigated. Surface morphology studies showed that the phosphate crystals that formed the coating were the smallest for the sample pre-activated by phosphoric acid. The coating on the colloidal Ti and the phosphoric acid samples had the largest and the smallest thickness and surface roughness, respectively. The reason for the discrepancy was analyzed by comparing the surface morphologies of alloy samples immediately after the pre-activation treatment and various phosphating treatments. X-ray diffraction analysis revealed that all three PCCs contained the same compounds. The corrosion resistance time from the copper sulfate drop test and the electrochemical data from the potentiodynamic polarization curves showed that the coating pre-activated by phosphoric acid had the best corrosion resistance. Finally, the 1500 h neutral salt spray corrosion test confirmed that the phosphating treated magnesium alloy, which was pre-activated by phosphoric acid,exhibited excellent corrosion resistance and behavior.

Modulation of lattice oxygen boosts the electrochemical activity and stability of Co-free Li-rich cathodes

Co-free Li-rich layered oxide cathodes have drawn much attention owing to their low cost and high energy density.Nevertheless,anion oxidation of oxygen leads to oxygen peroxidation during the first charging process,which leads to co-migration of transition metal ions and oxygen vacancies,causing structural instability.In this work,we propose a pre-activation strategy driven by chemical impregnation to modulate the chemical state of surface lattice oxygen,thus regulating the structural and electrochemical properties of the cathodes.In-situ X-ray diffraction confirms that materials based on activated oxygen configuration have higher structural stability.More importantly,this novel efficient strategy endows the cathodes having a lower surface charge transfer barrier and higher Li+transfer kinetics characteristic and ameliorates its inherent issues.The optimized cathode exhibits excellent electrochemical performance:after 300 cycles,high capacity(from 238 m Ah g^(-1)to 193 m Ah g^(-1)at 1 C)and low voltage attenuation(168 mV)are obtained.Overall,this modulated surface lattice oxygen strategy improves the electrochemical activity and structural stability,providing an innovative idea to obtain high-capacity Co-free Li-rich cathodes for next-generation Li-ion batteries.