Numerical Study on Aerodynamic Performance of CK Drone Aircraft Air Inlet in Maneuvering Flight

In view of the engineering background that CK drone aircraft needs modification and upgrading to improve its maneuvering performance,numerical research and analysis of air inlet aerodynamic performance are carried out.Firstly,based on the introduction of the theoretical knowledge involved in aircraft maneuvering flight,parameters such as aircraft attitude and engine mass flow etc.required for the aerodynamic performance calculation of CK drone aircraft air inlet are determined.By analyzing the test data of WP6 engine inlet distortion simulation board,the typical indexes are extracted as the basis for evaluating the air inlet performance of CK drone aircraft.Then,the aerodynamic characteristics of the inlet of CK drone aircraft under different maneuvering conditions are numerically studied,and the total pressure recovery coefficient and pressure distortion index of the outlet section are obtained.Several conclusions and suggestions are formed after the study.When CK drone aircraft flies at positive angle of attack,the inlet has good aerodynamic characteristics,which can meet the requirements of engine intake during high maneuverable flight.In the flight of negative angle of attack,the total pressure loss and pressure distortion at the outlet section of air inlet increase sharply,which cannot guarantee the stable working of the engine.On the premise that the aircraft attitude is satisfied,CK drone aircraft can use three engine thrust states of"Rated","Modified rated"and"Maximum"for high maneuverable flight.

Interaction between Struts and Swirl Flow in Gas Turbine Exhaust Diffusers

The increasing use of gas turbines in combined cycle power plants together with the high amount of kinetic energy in modem gas turbine exhaust flows focuses attention on the design of gas turbine diffusers as the connecting part between the Brayton/Joule and the Rankine parts of the combined cycle. A scale model of a typical gas turbine exhaust diffuser is investigated experimentally. The test rig consists of a radial type, variable swirl generator which provides the exhaust flow corresponding to different gas turbine operating conditions. Static pressure measurements are carried out along the outer diffuser walls and along the hub of the annular part and along the centerline of the conical diffuser. Velocity distributions at several axial positions in the annular and conical diffuser have been measured using a Laser Doppler Velocimeter （LDV）. Pressure recovery coefficients and velocity profiles are depicted as a function of diffuser length for several combinations of swirl strength, tip flow and strut geometries. The diffuser without struts achieved a higher pressure recovery than the diffuser with struts at all swirl angle settings. The diffuser with cylindrical struts achieved a higher pressure recovery than the diffuser with profiled struts at all swirl angle seO.ings. Inlet flows with swirl angles over 18° affected the pressure recovery negatively for all strut configurations.