Combustion characteristics of semicokes derived from pyrolysis of low rank bituminous coal

Various semicokes were obtained from medium-low temperature pyrolysis of Dongrong long flame coal.The proximate analysis,calorific value and Hardgrove grindability index(HGI) of semicokes were determined,and the ignition temperature,burnout temperature,ignition index,burnout index,burnout ratio,combustion characteristic index of semicokes were measured and analyzed using thermogravimetry analysis(TGA).The effects of pyrolysis temperature,heating rate,and pyrolysis time on yield,composition and calorific value of long flame coal derived semicokes were investigated,especially the influence of pyrolysis temperature on combustion characteristics and grindability of the semicokes was studied combined with X-ray diffraction(XRD) analysis of semicokes.The results show that the volatile content,ash content and calorific value of semicokes pyrolyzed at all process parameters studied meet the technical specifications of the pulverized coal-fired furnaces(PCFF) referring to China Standards GB/T 7562-1998.The pyrolysis temperature is the most influential factor among pyrolysis process parameters.As pyrolysis temperature increases,the yield,ignition index,combustion reactivity and burnout index of semicokes show a decreasing tend,but the ash content increases.In the range of 400 and 450 °C,the grindability of semicokes is rational,especially the grindability of semicokes pyrolyzed at 450 °C is suitable.Except for the decrease of volatile content and increase of ash content,the decrease of combustion performance of semicokes pyrolyzed at higher temperature should be attributed to the improvement of the degree of structural ordering and the increase of aromaticity and average crystallite size of char.It is concluded that the semicokes pyrolyzed at the temperature of 450 °C is the proper fuel for PCFF.

Flame Retardant Finishing of Poly(ethylene terephthalate) Fabric with a Carbon Source Containing DOPO Derivative

9, 10-dihydro-9-oxa-10-phosphaphenanthrene-10-oxide( DOPO)-based flame retardant( DOPO-DOPC) which contains carbon source was used to improve the flame retardancy of poly( ethylene terephthalate)( PET) fabrics. The prepared DOPODOPC dispersion was applied onto PET fabrics via two kinds of processes,thermosol process and exhaustion process,and in the later using it alone or together with disperse dyes. The flame retardancy of PET fabrics was determined by limiting oxygen index( LOI) and vertical burning test. The results showed that DOPODOPC could obviously improve the flame retardancy of PET fabrics.The PET fabric treated by 60 g/L DOPO-DOPC dispersion via exhaustion process achieved an LOI value of 32. 3%,for example.The flame retardancy and dyeing performances showed that DOPODOPC dispersion could be used together with a part of disperse dyes in one bath. The thermal stability of DOPO-DOPC and the treated PET fabrics were investigated by thermogravimetric analysis( TGA). And the flame retardant mechanism of DOPO-DOPC treated PET fabrics was further investigated by pyrolysis-gas chromatography/mass spectrometry( Py-GC/MS), Fourier transform infrared spectroscopy( FTIR) and scanning electron microscopy( SEM).

Chemical looping combustion: A new low-dioxin energy conversion technology

Dioxin production is a worldwide concern because of its persistence and carcinogenic,teratogenic, and mutagenic effects. The pyrolysis-chemical looping combustion process of disposing solid waste is an alternative to traditional solid waste incineration developed to reduce the dioxin production. Based on the equilibrium composition of the Deacon reaction,pyrolysis gas oxidized by seven common oxygen carriers, namely, Cu O, Ni O, Ca SO4, Co O,Fe2O3, Mn3O4, and Fe Ti O3, is studied and compared with the pyrolysis gas directly combusted by air. The result shows that the activity of the Deacon reaction for oxygen carriers is lower than that for air. For four typical oxygen carriers（Cu O, Ni O, Fe2O3, and Fe Ti O3）, the influences of temperature, pressure, gas composition, and tar on the Deacon reaction are discussed in detail. According to these simulation results, the dioxin production in China, Europe, the United States, and Japan is predicted for solid waste disposal by the pyrolysis-chemical looping combustion process. Thermodynamic analysis results in this paper show that chemical looping combustion can reduce dioxin production in the disposal of solid waste.