Microstructure evolution and mechanical properties of spark plasma sintered W-Ni-Mn alloy

Tungsten heavy alloys(90W-6Ni-4Mn)were prepared through spark plasma sintering(SPS)using micron-sized W,Ni,and Mn powders without ball milling as raw materials.The effects of sintering temperature on the microstructure and mechanicalproperties of the90W-6Ni-4Mn alloys were investigated.SPS technology was used to prepare90W-6Ni-4Mn alloys withrelatively high density and excellent comprehensive performance at1150-1250°C for3min.The90W-6Ni-4Mn alloys consistedof the W phase and theγ-(Ni,Mn,and W)binding phase,and the average grain size was less than10μm.The Rockwell hardness andbending strength of alloys first increased and then decreased with increasing sintering temperature.The best comprehensiveperformance was obtained at1200°C,its hardness and bending strength were HRA68.7and1162.72MPa,respectively.

Grain Growth Behavior of 5Cr21Mn9Ni4N Steel Micro-Alloyed by Rare Earth

Grain growth behavior of 5Cr21Mn9Ni4NRE steel was experimentally studied at various solid solution treatment temperatures and holding for different times. The experimental results show that the 5Cr21Mn9Ni4NRE steel has the feature of sharp austenite grain coarsening after solid solution treatment at the temperature above 1150 ℃. RE added in the steel has the benefit to restrain grain growth and increase grain growth activation energy.

Effect of specimen gauge reduction on uniaxial tension properties of reinforcing steel

The Standard Test Methods for Tension Testing of Metallic Materials (ASTM E8) mandates a specimen gauge reduction for obtaining the tensile properties of reinforcing steel bars. The standard outlines the specimen preparation requirements and methods to ensure that test results well represent the material properties. On the other hand, some codes differ regarding the approach to specimen preparation. They do not apply gauging, for both deformed and plain steel bars. Thus, the effect of specimen gauge reduction on the tensile properties of reinforcing steel bars was evaluated, and the interconnection of properties to the layer hardness was analysed. The experiment governed a range of deformed hot-rolled bar sizes, tested in tension using precision instruments. The Rockwell hardness test was implemented layerwise on the specimen’s cross section, and the hardness number (HRC) was measured as a function of the layer distance to the centre. A finite element model was constructed to study the stress concentrations induced by a constant indentation, simulating the HRCs, and to numerically construct the stress–strain relationship of ungauged steel bars based on the core properties and the section HRC relationship. Scanning electron microscopy readings were performed to visually and chemically justify the results. It was shown that the specimen gauge reduction significantly influenced the resulting stress–strain behaviour of the material, and the yield and ultimate strengths were reduced. It was also demonstrated that the hardness response is proportional to the distance to the specimen’s axes. The corresponding yield and ultimate strengths thus increased accordingly, from the inner to the outer layers of the bar. Testing a gauged specimen will therefore result in lower strength than that of an ungauged steel bar.