Influences of Soluble Salts on Adsorption Properties of Polycarboxylate Superplasticizers

Polycarboxylate（PC） superplasticizers with different chemical structures were synthesized through free radical co-polymerization reaction.A total organic carbon analyzer was used to investigate adsorption behaviors of PCs,and to evaluate influences of soluble salts on absorption properties of PCs.It is found that adsorption ratios of PCs on cement particles decrease greatly with the addition of Na2SO4;the adsorption ratio of ethers PC with Hydroxyethyl methacrylate（HEMA） group first increases then decreases with the addition of NaCl;the adsorption ratio of esters PC with short side chains first decreases then increases,while the adsorption ratio of ethers PC with HEMA group decreases with the addition of CaCl2;the adsorption ratio of esters PC with short side chains decreases with the addition of Ca（NO3）2;AlCl3 causes the decrease of the adsorption ratio of ethers PC with HEMA group.

A Prediction of the Excess Partial Molar Free Energies of MgCl_2 in the KCI-MgCl_2-LiCl Molten Salt System Containing MgCl_2 below 0.5 from Thermodynamic Properties of Binary Systems

The thermodynamical properties of MgCl_2 in KCI-MgCl_2-LiCl molten electrolytes containing MgCl_2 below 0.5 (mole fraction, the same below) have been determined from the interchange energies of two binary systems KCI-MgCl_2 and LiCI-MgCl_2, by means of a model on the assumptions that the electrolytes in the solution are treated as independent particles instead of their ion forms and the interchange energy between the component pair KCI-LiCl is ignored when compared with those of component pairs KCl-MgCl_2 and MgCl_2-LiCl. The interchange energies, wKCl-MgCl_2 and wMgcCl_2-Licl, are obtained as-70000 and -13800 J.mol-1, from the corresponding binary solutions, respectively.

Preparation and properties of Al-Mn alloy coatings in NaCl-KCl-AlCl_3-CeCl_3 molten salts

Al-Mn alloy coatings were electrodeposited on an iron substrate from AlCl3-NaCl-KCl molten salts with anhydrous MnCl2 enhanced by the addition of CeCl3. The microstructure and properties of the Al-Mn alloy coatings were investigated, and scanning electron microscopy, X-ray diffraction, and polarization curves were used to determine the composition, surface morphology, phase structure, and corrosion resistance of the obtained deposits. The results showed that the surface coatings were smooth, and that the crystallites were dense and uniform when 0.22 wt.% CeCl3 was added to the molten salt. An amorphous mixture of Al and Al6Mn was obtained. CeCl3 enhanced the corrosion resistance and increased the hardness of the single amorphous phase alloys. The pitting potential of the coating was approximately -1.1239 V, and its hardness was 390 kgf/mm2.