Nanosized titania sensing films were prepared by sol-gel process and the microstructure was characterized. Influence of various factors on the morphologies of the films were studied in details.In order to obtain films...Nanosized titania sensing films were prepared by sol-gel process and the microstructure was characterized. Influence of various factors on the morphologies of the films were studied in details.In order to obtain films with high surface area,Y^(3+),Ce^(3+) and Fe^(3+) were doped in the titania sol.Also titania sol was dispersed in a polymeric solution to get nanosized and porous films.Scanning electron microscope (SEM),atom force microscope (AFM),and x-ray diffraction (XRD) were used to characterize the titania films.SEM,AFM figures indicated that the grain size decreased from about 150 nm to 20 nm when the concentration of additions changed from 0 at% to 55 at% and the film was porous with the grain size less than 30 nm when the titania sol was dispersed in a polymeric solution even when the calcination temperature increased up to 850℃.展开更多
Tin oxide （SnO2） is one of the most promising transparent conducting oxide materials, which is widely used in thin film gas sensors. We investigate the dependence of the deposition time on structural, morphologicaJ ...Tin oxide （SnO2） is one of the most promising transparent conducting oxide materials, which is widely used in thin film gas sensors. We investigate the dependence of the deposition time on structural, morphologicaJ and hydrogen gas sensing properties of SnO2 thin films synthesized by dc magnetron sputtering. The deposited samples are characterized by XRD, SEM, AFM, surface area measurements and surface profiler. Also the H2 gas sensing properties of SnO2 deposited samples are performed against a wide range of operating temperature. The XRD analysis demonstrates that the degree of crystallinity of the deposited SnO2 films strongly depends on the deposition time. SEM and AFM analyses reveal that the size of nanoparticles or agglomerates, and both average and rms surface roughness is enhanced with the increasing deposition time. Also gas sensors based on these SnO2 nanolayers show an acceptable response to hydrogen at various operating temperatures.展开更多
Chemically synthesized ZnS thin film is found to be a good x-ray radiation sensor. We report the effect of annealing on the x-ray radiation detection sensitivity of a ZnS thin film synthesized by a chemical bath depos...Chemically synthesized ZnS thin film is found to be a good x-ray radiation sensor. We report the effect of annealing on the x-ray radiation detection sensitivity of a ZnS thin film synthesized by a chemical bath deposition technique. The chemically synthesized ZnS films are annealed at 333, 363 and 393K for 1 h. Structural analyses show that the lattice defects in the films decrease with annealing. Further, the band gap is also found to decrease from 3.38 to 3.21 eV after annealing at 393K. Current-voltage characteristics of the films are studied under dark and x-ray irradiation conditions. Due to the decrease of lattice defects and band gap, the conductivity under dark conditions is found to increase from 2.06 × 10^-6 to 1.69 × 10^-5 S/em, while that under x-ray irradiation increases from 4.13 × 10^-5 to 5.28 ×10^-5 S/cm. On the other hand, the x-ray radiation detection sensitivity of the films is found to decrease with annealing. This decrease of detection sensitivity is attributed to the decrease of the band gap as well as some structural and surface morphological changes occurring after annealing.展开更多
A type of compact solution concentration sensor based on a microfiber with a nanoscale-structured film is proposed and demonstrated experimentally. Additional loss at different solution concentrations is calculated by...A type of compact solution concentration sensor based on a microfiber with a nanoscale-structured film is proposed and demonstrated experimentally. Additional loss at different solution concentrations is calculated by means of the three-dimensional finite-difference time-domain （3D-FDTD） method. The microfiber is fabricated by using the flame-heated scanning technique. Nanoscale-structured film is coated on the microfiber surface, which is assembled as a sensing unit. The sensitivity of this kind of sensor increases with the decreasing diameters of the microfiber. When the diameter of the microfiber is 2 #m, a minimum concentration sensitivity of 1% （under 450s measuring time） is demonstrated in the experiment. Higher sensitivity can be attained when the solution concentration is higher. The sensing properties of this microfiber with the nanoscale-structured film may provide opportunities for new applications in optical sensing devices.展开更多
ZnO thin films prepared by using quantitative filter paper as a template and Zn（CH3CO2）2.2H2O ethanol precursor solution were characterized by scanning electron microscopy （SEM） and X-ray diffraction （XRD）. The ...ZnO thin films prepared by using quantitative filter paper as a template and Zn（CH3CO2）2.2H2O ethanol precursor solution were characterized by scanning electron microscopy （SEM） and X-ray diffraction （XRD）. The effects of sample calcination temperature, precursor concentration and filter paper types were studied, and the growth process was investigated by infra-red （IR） spectroscopy and thermogravimettic analysis/differential thermal analysis （TGA/DTA）. The results show that samples soaked in a 1.5 mol/L Zn（CH3 CO2）2.2H2O ethanol solution and calcined at 600 ℃ yield ZnO films of uniform particle size, approximately 30, 40 and 50 nm. for fast-, medium- and slow-speed filter papers, respectively. The formaldehyde gas sensing properties of the ZnO nanoparticles were tested, showing that the material prepared from fast-speed filter paper has a higher response to 120-205 ppm formaldehyde at 400 ℃ than that prepared from medium- or slow-sneed paper, which depends on the narticle size.展开更多
基金This work was financially supported by national nature science foundation of China under grant No. 50302001； Beihang nova program and project of Lanzhou institute of physics.
文摘Nanosized titania sensing films were prepared by sol-gel process and the microstructure was characterized. Influence of various factors on the morphologies of the films were studied in details.In order to obtain films with high surface area,Y^(3+),Ce^(3+) and Fe^(3+) were doped in the titania sol.Also titania sol was dispersed in a polymeric solution to get nanosized and porous films.Scanning electron microscope (SEM),atom force microscope (AFM),and x-ray diffraction (XRD) were used to characterize the titania films.SEM,AFM figures indicated that the grain size decreased from about 150 nm to 20 nm when the concentration of additions changed from 0 at% to 55 at% and the film was porous with the grain size less than 30 nm when the titania sol was dispersed in a polymeric solution even when the calcination temperature increased up to 850℃.
基金Supported by the Bandar Abbas Branch of the Islamic Azad University
文摘Tin oxide （SnO2） is one of the most promising transparent conducting oxide materials, which is widely used in thin film gas sensors. We investigate the dependence of the deposition time on structural, morphologicaJ and hydrogen gas sensing properties of SnO2 thin films synthesized by dc magnetron sputtering. The deposited samples are characterized by XRD, SEM, AFM, surface area measurements and surface profiler. Also the H2 gas sensing properties of SnO2 deposited samples are performed against a wide range of operating temperature. The XRD analysis demonstrates that the degree of crystallinity of the deposited SnO2 films strongly depends on the deposition time. SEM and AFM analyses reveal that the size of nanoparticles or agglomerates, and both average and rms surface roughness is enhanced with the increasing deposition time. Also gas sensors based on these SnO2 nanolayers show an acceptable response to hydrogen at various operating temperatures.
文摘Chemically synthesized ZnS thin film is found to be a good x-ray radiation sensor. We report the effect of annealing on the x-ray radiation detection sensitivity of a ZnS thin film synthesized by a chemical bath deposition technique. The chemically synthesized ZnS films are annealed at 333, 363 and 393K for 1 h. Structural analyses show that the lattice defects in the films decrease with annealing. Further, the band gap is also found to decrease from 3.38 to 3.21 eV after annealing at 393K. Current-voltage characteristics of the films are studied under dark and x-ray irradiation conditions. Due to the decrease of lattice defects and band gap, the conductivity under dark conditions is found to increase from 2.06 × 10^-6 to 1.69 × 10^-5 S/em, while that under x-ray irradiation increases from 4.13 × 10^-5 to 5.28 ×10^-5 S/cm. On the other hand, the x-ray radiation detection sensitivity of the films is found to decrease with annealing. This decrease of detection sensitivity is attributed to the decrease of the band gap as well as some structural and surface morphological changes occurring after annealing.
文摘A type of compact solution concentration sensor based on a microfiber with a nanoscale-structured film is proposed and demonstrated experimentally. Additional loss at different solution concentrations is calculated by means of the three-dimensional finite-difference time-domain （3D-FDTD） method. The microfiber is fabricated by using the flame-heated scanning technique. Nanoscale-structured film is coated on the microfiber surface, which is assembled as a sensing unit. The sensitivity of this kind of sensor increases with the decreasing diameters of the microfiber. When the diameter of the microfiber is 2 #m, a minimum concentration sensitivity of 1% （under 450s measuring time） is demonstrated in the experiment. Higher sensitivity can be attained when the solution concentration is higher. The sensing properties of this microfiber with the nanoscale-structured film may provide opportunities for new applications in optical sensing devices.
基金National 863 Program (No. 2007AA061401) for financial support
文摘ZnO thin films prepared by using quantitative filter paper as a template and Zn（CH3CO2）2.2H2O ethanol precursor solution were characterized by scanning electron microscopy （SEM） and X-ray diffraction （XRD）. The effects of sample calcination temperature, precursor concentration and filter paper types were studied, and the growth process was investigated by infra-red （IR） spectroscopy and thermogravimettic analysis/differential thermal analysis （TGA/DTA）. The results show that samples soaked in a 1.5 mol/L Zn（CH3 CO2）2.2H2O ethanol solution and calcined at 600 ℃ yield ZnO films of uniform particle size, approximately 30, 40 and 50 nm. for fast-, medium- and slow-speed filter papers, respectively. The formaldehyde gas sensing properties of the ZnO nanoparticles were tested, showing that the material prepared from fast-speed filter paper has a higher response to 120-205 ppm formaldehyde at 400 ℃ than that prepared from medium- or slow-sneed paper, which depends on the narticle size.
