Changes in PM2.5 sensitivity to NOx and NH3 emissions due to a large decrease in SO2 emissions from 2013 to 2018

The authors evaluated and compared the behavior of PM2.5 with respect to NOx and NH3 emission changes in high(the year 2013)and low(the year 2018)SO2 emission cases.Two groups of simulations were conducted based on anthropogenic emissions from China in 2013 and 2018,respectively.In each group of simulations,a respective 25%reduction in NOx and NH3 emissions were assumed.A sensitivity factor(β)was defined as the relative change in PM2.5 concentration due to 1%change in NOx or NH3 emissions.In the high SO2 emissions case,PM2.5 was more sensitive to NH3(0.31)emissions change than NOx(0.21).Due to the significant decrease in SO2 emissions from the high to low SO2 emissions case,the sensitivity of PM2.5 to NOx increased to 0.33,while its sensitivity to NH3 decreased to 0.22.The result implies that now and in the future,PM2.5 is/will be less sensitive to NH3 emissions change,while NOx emissions control is more effective in reducing the surface PM2.5 concentration.Seasonally,in the low SO2 emissions case,the sensitivities of PM2.5 to NOx and NH3 in winter were higher than those in summer,indicating that to dealwith severewinter hazemore attention should be paid to the emissions control of inorganic PM2.5 precursors,especially NOx.

Study on preparation and gas sensing property of water-soluble polyaniline/SmBaCuMO_(5+δ)(M=Fe, Co, Ni) for NH_3

Water-soluble polyaniline （PANI）, prepared by chemical-oxide and SmBaCuMO5＋δ（M=Fe, Co, Ni）（SBCM） powders, pre-pared by sol-gel method were analyzed through Fourier transform infrared spectroscopy （FT-IR） spectra, X-ray diffraction （XRD）, transmission electron microscopy （TEM） and energy dispersive spectroscopy （EDS） respectively, so as to investigate the gas sensi-tivities of PANI/SmBaCuFeO5＋δ（SBCF） and its sensitivity to NH3 under room temperature. The results showed that all of SBCM powders were of double-perovskite structure and PANI was successfully obtained. Under the same condition, the gas sensor based on PANI/SmBaCuFeO5＋δ（SBCF） material exhibited higher resistance sensitivity, better selectivity and shorter response-recovery time than others. The resistance sensitivities to NH3 increased with the increasing of atom radius of M in PANI/SBCM.