Fault Current Identification of DC Traction Feeder Based on Optimized VMD and Sample Entropy

A current identification method based on optimized variational mode decomposition(VMD)and sample entropy(SampEn)is proposed in order to solve the problem that the main protection of the urban rail transit DC feeder cannot distinguish between train charging current and remote short circuit current.This method uses the principle of energy difference to optimize the optimal mode decomposition number k of VMD;the optimal VMD for DC feeder current is decomposed into the intrinsic modal function(IMF)of different frequency bands.The sample entropy algorithm is used to perform feature extraction of each IMF,and then the eigenvalues of the intrinsic modal function of each frequency band of the current signal can be obtained.The recognition feature vector is input into the support vector machine model based on Bayesian hyperparameter optimization for training.After a large number of experimental data are verified,it is found that the optimal VMD_SampEn algorithm to identify the train charging current and remote short circuit current is more accurate than other algorithms.Thus,the algorithm based on optimized VMD_SampEn has certain engineering application value in the fault current identification of the DC traction feeder.

Influence of optical interference and carrier lifetime on the short circuit current density of organic bulk heterojunction solar cells

Based on simple analytical equations, short circuit current density （Jsc） of the organic bulk heterojunction solar cells has been calculated. It is found that the optical interference effect plays a very important role in the determination of Jsc; and obvious oscillatory behaviour of Jsc was observed as a function of thickness. At the same time, the influence of the carrier lifetime on Jsc also cannot be neglected. When the carrier lifetime is relatively short, Jsc only increases at the initial stage and then decreases rapidly with the increase of active layer thickness. However, for a relatively long carrier lifetime, the exciton dissociation probability must be considered, and Jsc behaves wave-like with the increase of active layer thickness. The validity of this model is confirmed by the experimental results.

Solutions to Consider in Current Transformer Selection for APR1400 Nuclear Power Plant Medium Voltage Switchgears

This paper discusses a preferable solution to mitigate the CT （current transformer） saturation problem, and at same time, reduce the accuracy errors when considering the selection of CTs for installation on the medium voltage switchgear of a nuclear power plant. This consideration is important for both measurement and protection functions of the digital protective relays. This is a study to ascertain the best options for a suitable solution to prevent CT saturation in relations to its protective capabilities during short circuit fault without compromising the CT accuracy class during normal operation of the system, while ensuring its conformity to the design requirement is within limit. The advantages of current transformers have proven not only to be reliable and safe, but also are of easy handling, reduction of the cost and components on the MV （medium voltage） switchgear. The purpose of this research is to identify best approach to resolve the existing problems in the current protection system. With the view of LPCT （low power current transformer） which has been newly constructed by few manufacturers to provide good protection and a wide range of measuring function without errors, some other solutions will be considered in this research.

Increased paracellular permeability of tumor-adjacent areas in 1,2-dimethylhydrazine-induced colon carcinogenesis in rats

Objective: The morphology and functions of the proximal and distal large intestine are not the same. The incidence of colorectal cancer in these regions is also different, as tumors more often appear in the descending colon than in the ascending colon.Inflammatory bowel disease and colorectal cancer can increase transepithelial permeability, which is a sign of reduced intestinal barrier function. However, there is not enough evidence to establish a connection between the difference in colorectal cancer incidence in the proximal and distal colon and intestinal permeability or the effects of carcinogenesis on the barrier properties in various areas of the colon. The aim of the study was to assess the permeability of different segments of the large intestine according to a developed mapping methodology in healthy rats and rats with 1,2-dimethylhydrazine(DMH)-induced colon adenocarcinoma.Methods: The short circuit current, the transepithelial electrical resistance and the paracellular permeability to fluorescein of large intestine wall of male Wistar rats were examined in the Ussing chambers. The optical density of the solution from the serosa side to assess the concentration of the diffused fluorescein from mucosa to serosa was analyzed by spectrophotometry. The morphometric and histological studies were performed by optical microscopy.Results: Rats with DMH-induced colon adenocarcinomas showed elevated transepithelial electrical resistance in the areas of neoplasm development. In contrast, there was no change in the electrophysiological properties of tumor adjacent areas, however,the paracellular permeability of these areas to fluorescein was increased compared to the control rats and was characterized by sharply reduced barrier function.Conclusions: The barrier properties of the colon vary depending on tumor location. The tumors were less permeable than the intact intestinal wall and probably have a negative influence on tumor-adjacent tissues by disrupting their barrier function.

Ultra-Stable and Durable Piezoelectric Nanogenerator with All-Weather Service Capability Based on N Doped 4H-SiC Nanohole Arrays

Ultra-stable piezoelectric nanogenerator(PENG)driven by environmental actuation sources with all-weather service capability is highly desirable.Here,the PENG based on N doped 4H-SiC nanohole arrays(NHAs)is proposed to harvest ambient energy under low/high temperature and relative humidity(RH)conditions.Finite element method simulation of N doped 4H-SiC NHAs in compression mode is developed to evaluate the relationship between nanohole diameter and piezoelectric performance.The density of short circuit current of the assembled PENG reaches 313 nA cm^(-2),which is 1.57 times the output of PENG based on N doped 4H-SiC nanowire arrays.The enhancement can be attributed to the existence of nanohole sidewalls in NHAs.All-weather service capability of the PENG is verified after being treated at-80/80℃and 0%/100%RH for 50 days.The PENG is promising to be widely used in practice worldwide to harvest biomechanical energy and mechanical energy.

Activation of G551D-CFTR by Bicyclooctane Compounds Is cAMP-dependent and Exhibits Low Sensitivity to Thiazolidinone CFTR Inhibitor CFTRinh-172

The G551D-CFTR mutation causing cystic fibrosis(CF) results from a missense mutation at codon 551(G551D) in the gene encoding of the cystic fibrosis transmembrane conductance regulator(CFTR). The G551D mutation in CFTR results in a reduced functional channel but G551D-CFTR is appropriately inserted in the apical membrane. In previous studies we discovered a class of high-affinity bicyclooctane(BCO) G551D-CFTR activators(G551D_ BCOs) with K_d down to 1 μmol/L. In this study, we analyzed the pharmacological activation of G551D-CFTR by the G551D_ BCOs by means of short circuit current analysis and cell-based fluorescence quenching assay. The G551D_ BCOs-induced G551D-CFTR activation is cAMP-dependent and is less sensitive to thiazolidinone CFTR inhibitor CFTRinh-172. These data suggest that (1) the phosphorylation of G551D-CFTR by protein kinase A is required for the activation by G551D_ BCOs; (2) G551D_ BCOs and CFTRinh-172 may act at the same site on the G551D-CFTR molecule.

Interruption Characteristics of High-speed Switches in 500 kV Fault Current Limiter with High Coupled Split Reactance

A 500 kV high-voltage AC fault current limiter(FCL)based on a high coupled split reactor(HCSR)is pro-posed by the National key R&D project team.Low impedance under normal conditions and high impedance under short-circuit conditions are accomplished by the cooperation of HCSR and high-speed switches.High-speed switches play an important role in current limiting processes,thus interruption characteristics of the high-speed switch in the 500 kV FCL are studied in this paper.The simulation model of the FCL and the external equivalent power grid are established.The short-circuit current and recovery voltage characteristics of the high-speed switch in FCL are simulated.The results show that maximum DC component of the short-circuit current of the high-speed switch reaches 91%,the maximum peak value is 118 kA,and the longest arcing time is 14.8 ms.There is a discontinuity in the curve of the short-circuit current peak and arcing time as a function of the short-circuit occurrence time;the peak recovery voltage of a single break of the high-speed switch has a maximum value of 87.5 kV under a three-phase ungrounded short-circuit condition,and the rate of rise of recovery voltage is o.22 kV/s.The recovery voltage peak shows a period change with the short-circuit occurrence time,and the period is 10 ms.The effects of the shunt capacitor value and short-circuit ground resistance on the recovery voltage of high-speed switching are also studied.The research can be used for reference by R&D personnel and testersof500kVFCLs.Index Terms-Fault current limiter(FCL),high coupled split reactor(HCSR),high-speed switch,interruption characteristics,short circuit current.

Transmission network expansion planning with embedded constraints of short circuit currents and N-1 security

An approach of transmission network expan-sion planning with embedded constraints of short circuit currents and N-1 security is proposed in this paper.The problem brought on by the strong nonlinearity property of short circuit currents is solved with a linearization method based on the DC power flow.The model can be converted to a mixed-integer linear programming problem,realizing the optimization of planning model that considers the constraints of linearized short circuit currents and N-1 security.To compensate the error caused by the assump-tions of DC power flow,the compensation factor is pro-posed.With this factor,an iterative algorithm that can compensate the linearization error is then presented.The case study based on the IEEE 118-bus system shows that the proposed model and approach can be utilized to:opti-mize the construction strategy of transmission lines;ensure the N-1 security of the network;and effectively limit the short circuit currents of the system.

Coordinated optimization for controlling short circuit current and multi-infeed DC interaction

Due to increased penetration of renewable energies,DC links and other emerging technologies,power system operation and planning have to cope with various uncertainties and risks.In order to solve the problems of exceeding short circuit current and multi-infeed DC interaction,a coordinated optimization method is presented in this paper.Firstly,a branch selection strategy is proposed by analyzing the sensitivity relationship between current limiting measures and the impedance matrix.Secondly,the impact of network structure changes on the multi-infeed DC system is derived.Then the coordinated optimization model is established,which considers the cost and effect of current limiting measures,the tightness of network structure and the voltage support capability of AC system to multiple DCs.Finally,the non-dominated sorting genetic algorithm II combining with the branch selection strategy,is used to find the Pareto optimal schemes.Case studies on a planning power system demonstrated the feasibility and speediness of this method.

Research and implementation of 100 A pulsed current source pulse edge compression

In order to increase the usefulness of pulsed current source in engineering practice, research and study was carried out on how to increase the pulse current amplitude, reduce the rise /fall time of output pulse and MOSFET switching losses, etc. Through the analysis of the pulsed current source works theory and the mathematical derivation of the circuit model, the deduction and calculation of the pulse edge compression control methods, and improve the overall circuit structure and optimize the manufacturing process according to the theory. The following indicators was realized： the output pulse current amplitude can be up to 100 A, the shortest pulse rise / fall time was 18.8 ns and 16.1 ns respectively when the maximum amplitude output, the pulse width could be narrowest to 40 ns, repetition frequency could achieve 10 Hz to 10 k Hz, MOSFET switching losses decreased by 30.9 %. This pulsed current source can be used, not only as the power supply for the ordinary high speed narrow pulse width laser diode, but also as an ideal drive power for the high energy, narrow width pulse laser diode.

New method to determine optimum impedance of fault current limiters for symmetrical and/or asymmetrical faults in power systems

To select the type and value of the impedance of fault current limiters（FCLs） for power network designers, we introduce a new method to calculate the optimum value of FCL impedance depending on its position in the network. Due to the complexity of its impedance, the costs of both real and imaginary parts of FCL impedance are considered. The optimization of FCL impedance is based on a goal function that maximizes the reduction of the fault current while minimizing the costs. While the position of FCL in the network has an effect on the calculation of the optimum impedance value, the method for selecting FCL location is not the focus of this study. The proposed method for optimizing FCL impedance can be used for every network that has symmetrical and/or asymmetrical faults. We use a 14-bus IEEE network as an example to explain the process. The optimum FCL impedance used in this network is calculated by considering the vast range of costs for both real and imaginary parts of FCL impedance.

Design and synthesis of low band gap non-fullerene acceptors for organic solar cells with impressively high J_(sc) over 21 m A cm^(-2)

Three low bandgap non-fullerene acceptors based on thieno[3,2-b]thiophene fused core with different ending groups, named TTIC-M, TTIC, TTIC-F were designed and synthesized. Using a wide bandgap polymer PBDB-T as donor to form a complementary absorption in the range of 300–900 nm, high efficencies of 9.97%, 10.87% and 9.51% were achieved for TTIC-M, TTIC and TTFC-F based photovoltaic devices with impressively high short circuit current over21 mA cm^-2.

Analysis of the double-layer a-Si：H emitter with different doping concentrations for α-Si：H/c-Si heterojunction solar cells

Double-layer emitters with different doping concentrations （DLE） have been designed and prepared for amorphous silicon/crystalline silicon （ct-Si：H/c-Si） hetero- junction solar cells. Compared with the traditional single layer emitter, both the experiment and the simulation （AFORS-HET, http：//www.paper.edu.cn/html/releasepaper/2014/04/282/） prove that the double-layer emitter increases the short circuit current of the cells significantly. Based on the quantum efficiency （QE） results and the current-voltage-temperature analysis, the mechanism for the experimental results above has been investigated. The possible reasons for the increased current include the enhancement of the QE in the short wavelength range, the increase of the tunneling probability of the current transport and the decrease of the activation energy of the emitter layers.

Research on performance of hybrid organic dyes-sensitized solar cell

The hybrid sensitizer rhodamine B and coumarin or eosin and coumarin is used to sensitize nanocrystalline porous films. Absorption of the nanoerystalline photovoltaic cell （NPC） is improved in visible light. The performance of these cells is more effective than that of cells sensitized only by sensitizer rhodamine B or eosin. In the simulative solar light, cell sensitized by hybrid sensitizer rhodamine B and coumarin can get open circuit voltage （VOC） of 550 mV and short circuit current （ISC） of 0.1375 mA/cm^2.