An mmWave Dual-Band Integrated Substrate Gap Waveguide Single Cavity Filter with Frequency Selectivity

A novel dual-band ISGW cavity filter with enhanced frequency selectivity is proposed in this paper by utilizing a multi-mode coupling topology.Its cavity is designed to control the number of modes,and then the ports are determined by analyzing the coupling relationship between these selected modes.By synthesizing the coupling matrix of the filter,a nonresonating node(NRN)structure is introduced to flexibly tune the frequency of modes,which gets a dualband and quad-band filtering response from a tri-band filter no the NRN.Furthermore,a frequency selective surface(FSS)has been newly designed as the upper surface of the cavity,which significantly improves the bad out-of-band suppression and frequency selectivity that often exists in most traditional cavity filter designs and measurements.The results show that its two center frequencies are f01=27.50 GHz and f02=32.92GHz,respectively.Compared with the dual-band filter that there is no the FSS metasurface,the out-of-band suppression level is improved from measured 5 dB to18 dB,and its finite transmission zero(FTZ)numbers is increased from measured 1 to 4 between the two designed bands.Compared with the tri-band and quadband filter,its passband bandwidth is expanded from measured 1.17%,1.14%,and 1.13% or 1.31%,1.50%,0.56%,and 0.57% to 1.71% and 1.87%.In addition,the filter has compact,small,and lightweight characteristics.

Wavelength-Tunable Single Frequency Ytterbium-Doped Fiber Laser with Loop Mirror Filter

By using a loop mirror filter, a novel wavelength-tunable single-frequency ytterbium-doped fiber laser is developed to select single longitudinal modes in a linear cavity. The output wavelength could be tuned 2.4 nm intervals range from 1063.3 to 1065.Tnrn with the temperature change of the fiber Bragg grating. The maximum output power could reach 32 m W while the pump power increases to 120 m W. The corresponding optical-to-optical conversion efficiency is 26.7% and the slope efficiency is 33.9%, respectively. The output power fluctuation is below 2%, and its highest signal-to-noise ratio is 60 dB.

Capacitive Coupled Wide-Notch Stepped Impedance Narrow-Band Bandpass Filter for WiMax Application

The development of wireless communication standards necessitates optimal filter design for the selection of appropriate bands of frequencies.In this work,a compact in size pair of parallel coupled symmetric stepped impedancebased resonator is designed with supporting to the WiMAX communication standards.The coupled resonator is tuned to allow the frequency band between 3.4 GHz and 3.8 GHz,which is centered at 3.6 GHz.A parasitic effect of capacitively coupled feed structure is used for exciting the two symmetrical stepped impedance resonators.The bandwidth and selectivity of the filter are enhanced with the change of characteristic impedances and controlling the coupling gap between resonators.This design offers single narrow sharp passband selectivity as well as multiple stopband harmonic suppression arising as a result of multiple transmission zeros.The designed filter operates with a fractional bandwidth(FBW)of 11.47%.The proposed single narrowband bandpass filter provides better suppression in either side of the tuned frequency(3.6 GHz)without degrading the passband performance.Also,this novel filter offers an insertion loss of about−0.08 dB and a return loss of greater than−30 dB in passband.This approach is useful for eliminating unwanted spurious harmonics responses that enter the desired response.The suggested bandpass filter has been simulated using Advanced Design System(ADS)tool,and the measurement has been made using a network analyzer,and the results are reported.

Ultra-wide tuning single channel filter based on one-dimensional photonic crystal with an air cavity

By inserting an air cavity into a one-dimensional photonic crystal of LiF/GaSb, a tunable filter covering the whole visible range is proposed. Following consideration of the dispersion of the materials, through modulating the thickness of the air cavity, we demonstrate that a single resonant peak can shift from 416.1 to 667.3 nm in the band gap at normal incidence by means of the transfer matrix method. The research also shows that the transmittance of the channel can be maximized when the number of periodic Li F/Ga Sb layers on one side of the air defect layer is equal to that of the other side. When adding a period to both sides respectively, the full width at half maximum of the defect mode is reduced by one order of magnitude. This structure will provide a promising approach to fabricate practical tunable filters in the visible region with ultra-wide tuning range.

Robust switched fractional controller for performance improvement of single phase active power filter under unbalanced conditions

A novel controller is proposed to regulate the DC-link voltage of a single phase active power filter （SPAPF）. The proposed switched fractional controller （SFC） consists of a conventional PI controller, a fractional order PI （FO-PI） controller and a decision maker that switches between them. Commonly, the conventional PI controller is used in regulation loops due to its advantages in steady-state but it is limited in transient state. On the other hand, the FO-PI controller overcomes these draw- backs but it causes dramatic degradation in control performances in steady-state because of the fractional calculus theory and the approximation method used to implement this kind of controller. Thus, the purpose of this paper is to switch to the PI controller in steady-state to obtain the best power quality and to switch to the FO-PI controller when external disturbances are detected to guarantee a fast transient state. To investigate the efficiency and accuracy of the SFC considering all robustness tests, an experimental setup has been established. The results of the SFC fulfill the requirements, confirm its high performances in steady and transient states and demon- strate its feasibility and effectiveness. The experiment results have satisfied the limit specified by the IEEE harmonic standard 519.

Improved single image dehazing using dark channel prior

An improved single image dehazing method based on dark channel prior and wavelet transform is proposed. This proposed method employs wavelet transform and guided filter instead of the soft matting procedure to estimate and refine the depth map of haze images. Moreover, a contrast enhancement method based on just noticeable difference(JND) and quadratic function is adopted to enhance the contrast for the dehazed image, since the scene radiance is usually not as bright as the atmospheric light,and the dehazed image looks dim. The experimental results show that the proposed approach can effectively enhance the haze image and is well suitable for implementing on the surveillance and obstacle detection systems.