Influence of Superplasticizers on Early Age Drying Shrinkage of Cement Paste with the Same Consistency

The influence of superplasticizer（SP） on the early age drying shrinkage of cement paste with the same consistency was investigated. To conduct the test, which lasted for 72 hours, three paste mixtures were used for comparison. The 72 hours early age drying shrinkage staring from the initial setting time was measured by a clock gauge. The pore size distribution was measured by Mercury Intrusion Method. The surface tension of capillary simulation liquid and mass loss of paste were also measured. The experimental results showed that the addition of SP increased the early drying shrinkage greatly. The ratios of water evaporation and the total free water in mixtures added with SPs showed great differences. SPs fined the capillary pores of paste, and the volume of pore with diameter within 50 nm was well consistent with shrinkage rate. The addition of SPs did not raise the capillary liquid surface tension. It showed that with the volume of pore with diameter within 50 nm and the ratio of water evaporation and the total free water a tolerable shrinkage result of paste added with SP could be predicted, and the elastic modulus could have an influence on the early shrinkage. These results have never been proposed before.

Effect of drying environment on engineering properties of an expansive soil and its microstructure

This paper investigates the effect of drying environment, i.e. temperature and relative humidity, on the engineering properties and microscopic pore size distribution of an expansive soil. The shrinkage tests under different drying temperatures and relative humidity are carried out in a constant climate chamber. Then, the undisturbed samples, prepared in different drying environment, are used for the triaxial tests and mercury intrusion tests. It is found that the drying environment has noticeable influence on the engineering properties of expansive soils and it can be characterized by the drying rate. The linear shrinkage and strength increase with the decrease of the drying rate. The non-uniform deformation tends to happen in the high drying rate, which subsequently furthers the development of cracks. In addition, during the drying process, the variation of pores mainly focuses on the inter-aggregate pores and inter-particle pores. The lower drying rate leads to larger variation of pore size distribution.

iRGD-reinforced, photo-transformable nanoclusters toward cooperative enhancement of intratumoral penetration and antitumor efficacy

Insufficient intratumoral penetration greatly hurdles the anticancer performance of nanomedicine. To realize highly efficient tumor penetration in a precisely and spatiotemporally controlled manner, far-red light-responsive nanoclusters (NCs) capable of size shrinkage and charge conversion were developed and co-administered with iRGD to synergistically improve the intratumoral penetration and the anticancer efficacy. The NCs were constructed using the singlet oxygen-sensitive (SOS) polyethylene glycolpolyurethane-polyethylene glycol (PEG-(1O2)PU-PEG) triblock copolymer to encapsulate the doxorubicin (DOX)-loaded, chlorin e6 (Ce6)-conjugated polyamindoamine (PAMAM) dendrimer (DCD) via the double-emulsion method. Co-administration of iRGD notably increased the permeability of NCs within tumor vasculature and tumor tissues. In addition, upon far-red light irradiation (660 nm) of tumors at low optical density (10 mW/cm2), the generated 1O2 could disintegrate the NCs and release the DCD with positive surface charge and ultra-small size (~ 5 nm), which synergized with iRGD to enable deep intratumoral penetration. Consequently, the local 1O2 at lethal concentrations along with the released DOX efficiently and cooperatively eradicated tumor cells. This study provides a convenient approach to spatiotemporally promote the intratumoral penetration of nanomedicine and mediate programmed anticancer therapy.