The desulfurization experiment of an Al2O3-CaO base pre-molten refining slag containing SrO was carried out. Experimental samples were made from industrial materials. In order to predict the slag's desulfurization...The desulfurization experiment of an Al2O3-CaO base pre-molten refining slag containing SrO was carried out. Experimental samples were made from industrial materials. In order to predict the slag's desulfurization ability, sulphur capacity was calculated by means of optical basicity, and there is consistency between calculated results and experimental data. A mathematical model between components and sulphur partition ratio was established with the experimental data. Based on the regression equation, the effects of single and interactive components on sulphur partition ratio were discussed. The results show that the sulphur capacity and distribution ratio decrease with the increment of Al2O3/CaO. SrO and MgO can increase the sulphur partition ratio. The best content of SrO in the slag should not be more than 10%, and the MgO content should be about 8%. The effect of CaF2 on sulphur partition ratio is not obvious, therefore the addition should be limited for environmental protection.展开更多
The influence of air-cooled blast furnace slag aggregates as replacement of natural aggregates on the water absorption of concrete and mortar was studied, and the mechanism was analyzed. The interface between aggregat...The influence of air-cooled blast furnace slag aggregates as replacement of natural aggregates on the water absorption of concrete and mortar was studied, and the mechanism was analyzed. The interface between aggregate and matrix in concrete was analyzed by using a micro-hardness tester, a laser confocal microscope and a scanning electron microscope with backscattered electron image mode. The pore structure of mortar matrixes under different curing conditions was investigated by mercury intrusion porosimetry. The results showed that when natural aggregates were replaced with air-cooled blast furnace slag aggregates in mortar or concrete, the content of the capillary pore in the mortar matrix was reduced and the interfacial structure between aggregate and matrix was improved, resulting in the lower water absorption of mortar or concrete. Compared to the concrete made with crushed limestone and natural river sand, the initial absorption coefficient, the secondary absorption coefficient and the water absorption capacity through the surface for 7 d of the concrete made from crushed air-cooled blast furnace slag and air-cooled blast furnace slag sand were reduced by 48.9%, 52.8%, and 46.5%, respectively.展开更多
The interaction between the slag containing titanium oxides(TiO2of 2.0 %-20.0%)and a MgO-C based refractory was investigated by immersion test.The relationship between TiO2 content in slag and corrosion rate of the re...The interaction between the slag containing titanium oxides(TiO2of 2.0 %-20.0%)and a MgO-C based refractory was investigated by immersion test.The relationship between TiO2 content in slag and corrosion rate of the refractory was studied.The microstructure and compositions of the corroded refractory were analyzed by SEM and X-ray diffraction.The corrosion mechanism of MgO-C based refractory in the slag containing titanium was proposed,and the effects of TiO2 content,slag basicity(ωCaO/ωSiO2)and temperature in molten bath on the corrosion rate of the refractory were obtained.展开更多
Using differential thermal analysis, X-ray phase analysis, electron microscopy, and optical microscopy, the nucleation of crystals in glass obtained by blending metallurgical slag with silicon dioxide has been studied...Using differential thermal analysis, X-ray phase analysis, electron microscopy, and optical microscopy, the nucleation of crystals in glass obtained by blending metallurgical slag with silicon dioxide has been studied. The type of crystallization (homogeneous or heterogeneous, volume or surface) is revealed for each of nine compositions of synthesized glass. It is shown that the first crystalline phase in a volume crystallizing glass is perovskite (CaO·TiO2);in this phase a nucleation of the main phase occurs: melilite (solid solution of gehlenite 2CaO·Al2O3·SiO2 in akermanite 2CaO·MgO·2SiO2). The fundamental characteristics of homogeneous (for a catalizing phase, perovskite) and heterogeneous (for a catalyzed phase, melilite) of crystallization are determined: the steady state nucleation rate Ist, time of unsteady state nucleation τ, crystal growth rate U, and activation energy of frictional flow. The temperature dependences of Ist, τ, and U are obtained. The kinetics of the crystallization of glass is studied and the rates of the surface crystal growth are determined in the glass of nine compositions. The influence of grinding the particles of the original glass on the sequence of deposition of the crystalline phases was studied. Practical recommendations are presented for the use of blast-furnace slag as a raw material for the synthesis of glass and their further utilization.展开更多
文摘The desulfurization experiment of an Al2O3-CaO base pre-molten refining slag containing SrO was carried out. Experimental samples were made from industrial materials. In order to predict the slag's desulfurization ability, sulphur capacity was calculated by means of optical basicity, and there is consistency between calculated results and experimental data. A mathematical model between components and sulphur partition ratio was established with the experimental data. Based on the regression equation, the effects of single and interactive components on sulphur partition ratio were discussed. The results show that the sulphur capacity and distribution ratio decrease with the increment of Al2O3/CaO. SrO and MgO can increase the sulphur partition ratio. The best content of SrO in the slag should not be more than 10%, and the MgO content should be about 8%. The effect of CaF2 on sulphur partition ratio is not obvious, therefore the addition should be limited for environmental protection.
基金Funded by the National Natural Science Foundation of China(Nos.51778003 and 51308004)the Project of Anhui Provincial Education Department for Sending Visiting Scholars to Research Abroad(No.gxfx ZD2016134)+1 种基金the Anhui Province Higher Education Revitalization Program Talent Project([2014]No.11)the National Key Research and Development Plan(No.2017YFB0310001)
文摘The influence of air-cooled blast furnace slag aggregates as replacement of natural aggregates on the water absorption of concrete and mortar was studied, and the mechanism was analyzed. The interface between aggregate and matrix in concrete was analyzed by using a micro-hardness tester, a laser confocal microscope and a scanning electron microscope with backscattered electron image mode. The pore structure of mortar matrixes under different curing conditions was investigated by mercury intrusion porosimetry. The results showed that when natural aggregates were replaced with air-cooled blast furnace slag aggregates in mortar or concrete, the content of the capillary pore in the mortar matrix was reduced and the interfacial structure between aggregate and matrix was improved, resulting in the lower water absorption of mortar or concrete. Compared to the concrete made with crushed limestone and natural river sand, the initial absorption coefficient, the secondary absorption coefficient and the water absorption capacity through the surface for 7 d of the concrete made from crushed air-cooled blast furnace slag and air-cooled blast furnace slag sand were reduced by 48.9%, 52.8%, and 46.5%, respectively.
文摘The interaction between the slag containing titanium oxides(TiO2of 2.0 %-20.0%)and a MgO-C based refractory was investigated by immersion test.The relationship between TiO2 content in slag and corrosion rate of the refractory was studied.The microstructure and compositions of the corroded refractory were analyzed by SEM and X-ray diffraction.The corrosion mechanism of MgO-C based refractory in the slag containing titanium was proposed,and the effects of TiO2 content,slag basicity(ωCaO/ωSiO2)and temperature in molten bath on the corrosion rate of the refractory were obtained.
文摘Using differential thermal analysis, X-ray phase analysis, electron microscopy, and optical microscopy, the nucleation of crystals in glass obtained by blending metallurgical slag with silicon dioxide has been studied. The type of crystallization (homogeneous or heterogeneous, volume or surface) is revealed for each of nine compositions of synthesized glass. It is shown that the first crystalline phase in a volume crystallizing glass is perovskite (CaO·TiO2);in this phase a nucleation of the main phase occurs: melilite (solid solution of gehlenite 2CaO·Al2O3·SiO2 in akermanite 2CaO·MgO·2SiO2). The fundamental characteristics of homogeneous (for a catalizing phase, perovskite) and heterogeneous (for a catalyzed phase, melilite) of crystallization are determined: the steady state nucleation rate Ist, time of unsteady state nucleation τ, crystal growth rate U, and activation energy of frictional flow. The temperature dependences of Ist, τ, and U are obtained. The kinetics of the crystallization of glass is studied and the rates of the surface crystal growth are determined in the glass of nine compositions. The influence of grinding the particles of the original glass on the sequence of deposition of the crystalline phases was studied. Practical recommendations are presented for the use of blast-furnace slag as a raw material for the synthesis of glass and their further utilization.
