Shear Bond Strength of Different Types of Cement Used for Bonding Band and Loop Space Maintainer

Purpose: The present study aimed to evaluate the effects of thermal aging on the shear bond strength of three different types of cement used to retain band and loop space maintainers cemented on extracted human permanent molar teeth. Methods: A total of 66 newly extracted permanent molars were used in this study. Eighteen teeth were used as a control and did not undergo thermal aging (six per group). All sample teeth were randomly divided into three groups: KetacCem, RelyX Luting Plus, and RelyX Unicem 2. After bonding procedures, all experimental groups undergo thermal aging. The shear bond strength of all samples was conducted using the Ultratester machine. Findings were statistically analyzed using the ANOVA and Turkey’s post hoc tests. Results: Among the examined groups, Ketac Cem presented with the highest recorded shear bond (11.4 MPa), while RelyX Luting Plus showed the lowest (3.2 MPa). The control groups recorded the highest shear bond strength compared to all examined groups;Ketac Cem showed the highest shear bond strength (12.8 Mpa), and RelyX Luting Plus had the least recorded reading (5.4 Mpa). Conclusion: Within the limitation of the present study, there was a statistically significant difference between the examined groups;Ketac Cem showed a higher shear bond cement than RelyX luting Plus and RelyX Unicem.

Effects of unit size on current density and illuminance of micro-LED-array

A 300 μm×300 μm light emitting diode(LED) chip is divided into nine 80 μm×80 μm units with 30 μm spacing between adjacent ones. After arraying, the total saturation light output power and the maximum injection current are enhanced by 5.19 times and nearly 7 times, respectively. In addition, the test results demonstrate that the illuminance uniformity on the receiving surface reaches the optimum when the spacing between the arrays is equal to the maximum flat condition. The larger the number of arrays, the greater the area with uniform illuminance on the receiving surface.

A microwave photonic filter based on multi-wavelength fiber laser and infinite impulse response

A microwave photonic filter(MPF) based on multi-wavelength fiber laser and infinite impulse response(IIR) is proposed. The filter uses a multi-wavelength fiber laser as the light source, two sections of polarization maintaining fiber(PMF) and three polarization controllers(PCs) as the laser frequency selection device. By adjusting the PC to change the effective length of the PMF, the laser can obtain three wavelength spacings, which are 0.44 nm, 0.78 nm and 1.08 nm, respectively. And the corresponding free spectral ranges(FSRs) are 8.46 GHz, 4.66 GHz and 3.44 GHz, respectively. Thus changing the wavelength spacing of the laser can make the FSR variable. An IIR filter is introduced based on a finite impulse response(FIR) filter. Then the 3-d B bandwidth of the MPF is reduced, and the main side-lobe suppression ratio(MSSR) is increased. By adjusting the gain of the radio frequency(RF) signal amplifier, the frequency response of the filter can be enhanced.