It is believed that gel spun polyethylene(PE)fibers have a somewhat extended chain crystalstructure,because of the disentangling of the chains which takes place in semi-dilute solutionand the ultra high draw ratio use...It is believed that gel spun polyethylene(PE)fibers have a somewhat extended chain crystalstructure,because of the disentangling of the chains which takes place in semi-dilute solutionand the ultra high draw ratio used.Ten years ago,PE shish-kebabs grown from dilute solutionwere proved to have extended chain backbone which causes the raising of its melting point.These crystals were found to have a triclinic crystal phase,This study shows a different result forgel spun ultra high drawn PE fiber.The unit cell remains orthorhombic even if the draw ratioreaches 50;as the draw ratio increases,the length in a and b axes are shortened while that in c ax-is changes quite insignificantly.When the draw ratio is over 10,two endothermic melting peakscan be seen in the DSC curves with corresponding peak temperature of 136.7-145.3℃.The lat-ter peak is attributed to the amount of extended chain crystal.展开更多
In this paper, fibrillation properties of solvent - spun cellulose fiber and some influencing factors are analyzed based on the experiment results. It is pointed out that special textile styles and aesthetic appearanc...In this paper, fibrillation properties of solvent - spun cellulose fiber and some influencing factors are analyzed based on the experiment results. It is pointed out that special textile styles and aesthetic appearance could be obtained by controlling the fibrillation.展开更多
The surface of dry-jet wet spun carbon fibers(CFs)is relatively smooth compared with those of wet spun CFs,which results in weak interfacial interactions between the fiber and the polymer resin.A surface functionaliza...The surface of dry-jet wet spun carbon fibers(CFs)is relatively smooth compared with those of wet spun CFs,which results in weak interfacial interactions between the fiber and the polymer resin.A surface functionalization treatment is particularly important to unleash the full potential of the superior mechanical properties of dry-jet wet spun CFs.In this study,the effects of electrochemical oxidation treatment time and current density on the surface structures and the mechanical properties of dry-jet wet spun CFs were investigated.The interlaminar shear strength of the CFs improves significantly from 69 to 84 MPa after 120 s of treatment.Further structural analysis reveals that the improvements are due to the addition of oxygen-containing functional groups and the optimization of the morphology on the surface of the CFs.展开更多
Ultra-high strength and modulus polyethylene fibers can be produced from UHMW-PE(ul-tra-high molecular weight polyethylene) by gel spinning and ultra-high drawing method.The spe-cial supermolecular structure of″shish...Ultra-high strength and modulus polyethylene fibers can be produced from UHMW-PE(ul-tra-high molecular weight polyethylene) by gel spinning and ultra-high drawing method.The spe-cial supermolecular structure of″shish-kebabs″ is the intrinsic course for the fiber having highperformance.In this paper,the formation mechanism of the characteristic structure of PE fibershas been investigated by means of SEM,DSC,WAXD,SAXS and TEM,The experimental resultsshow that the extended-chain structure of PE fibers is formed originally from the bridged mole-cules in amorphous region and increased gradually during further drawing porcess.The″shish-kebab″ structure is formed by the combination of extended-chalnS and originalfolded-chains.展开更多
This paper presents a comparison study of two models for predicting the strength of rotor spun cotton yarns from fiber properties. The adaptive neuro-fuzzy system inference （ANFIS） and Multiple Linear Regression mod...This paper presents a comparison study of two models for predicting the strength of rotor spun cotton yarns from fiber properties. The adaptive neuro-fuzzy system inference （ANFIS） and Multiple Linear Regression models are used to predict the rotor spun yarn strength. Fiber properties and yam count are used as inputs to train the two models and the count-strength-product （CSP） was the targel. The predictive performances of the two models are estimated and compared. We found that the ANFIS has a better predictive power in comparison with linear multiple regression model. The impact of each fiber property is also illustrated.展开更多
Consolidation of thermoplastic unidirectional(UD)lami-nate with friction spun core yarns was investigated,espe-cially the characterization of filament bundles in consoli-dation was analyzed.The results showed that the...Consolidation of thermoplastic unidirectional(UD)lami-nate with friction spun core yarns was investigated,espe-cially the characterization of filament bundles in consoli-dation was analyzed.The results showed that the bundleeffect was affected considerably by processing conditions(applied pressure and processing time).The boundaryof the bundles was disappeared under suitable processingconditions and finally an even fiber/resin distributioncould be attained.In consolidation,filament bundlesgetting close each other and resin flowing into the bundl-es occurred simultaneously,and eventually the bundleswere fully impregnated by the resin.Fiber packing den-sity in UD-laminate was the same as that of frictionspun core yarn(55%-65% in volume)and was not af-fected significantly by processing conditions under thecurrent experimental conditions.展开更多
基金This project is supported by National Science Foundation of China
文摘It is believed that gel spun polyethylene(PE)fibers have a somewhat extended chain crystalstructure,because of the disentangling of the chains which takes place in semi-dilute solutionand the ultra high draw ratio used.Ten years ago,PE shish-kebabs grown from dilute solutionwere proved to have extended chain backbone which causes the raising of its melting point.These crystals were found to have a triclinic crystal phase,This study shows a different result forgel spun ultra high drawn PE fiber.The unit cell remains orthorhombic even if the draw ratioreaches 50;as the draw ratio increases,the length in a and b axes are shortened while that in c ax-is changes quite insignificantly.When the draw ratio is over 10,two endothermic melting peakscan be seen in the DSC curves with corresponding peak temperature of 136.7-145.3℃.The lat-ter peak is attributed to the amount of extended chain crystal.
文摘In this paper, fibrillation properties of solvent - spun cellulose fiber and some influencing factors are analyzed based on the experiment results. It is pointed out that special textile styles and aesthetic appearance could be obtained by controlling the fibrillation.
基金Jiangsu Province for the Transformation of Scientific and Technological Achievements(BA2019043)Jiangsu Provincial Key Research and Development Program(BE2021014-2)。
文摘The surface of dry-jet wet spun carbon fibers(CFs)is relatively smooth compared with those of wet spun CFs,which results in weak interfacial interactions between the fiber and the polymer resin.A surface functionalization treatment is particularly important to unleash the full potential of the superior mechanical properties of dry-jet wet spun CFs.In this study,the effects of electrochemical oxidation treatment time and current density on the surface structures and the mechanical properties of dry-jet wet spun CFs were investigated.The interlaminar shear strength of the CFs improves significantly from 69 to 84 MPa after 120 s of treatment.Further structural analysis reveals that the improvements are due to the addition of oxygen-containing functional groups and the optimization of the morphology on the surface of the CFs.
文摘Ultra-high strength and modulus polyethylene fibers can be produced from UHMW-PE(ul-tra-high molecular weight polyethylene) by gel spinning and ultra-high drawing method.The spe-cial supermolecular structure of″shish-kebabs″ is the intrinsic course for the fiber having highperformance.In this paper,the formation mechanism of the characteristic structure of PE fibershas been investigated by means of SEM,DSC,WAXD,SAXS and TEM,The experimental resultsshow that the extended-chain structure of PE fibers is formed originally from the bridged mole-cules in amorphous region and increased gradually during further drawing porcess.The″shish-kebab″ structure is formed by the combination of extended-chalnS and originalfolded-chains.
文摘This paper presents a comparison study of two models for predicting the strength of rotor spun cotton yarns from fiber properties. The adaptive neuro-fuzzy system inference （ANFIS） and Multiple Linear Regression models are used to predict the rotor spun yarn strength. Fiber properties and yam count are used as inputs to train the two models and the count-strength-product （CSP） was the targel. The predictive performances of the two models are estimated and compared. We found that the ANFIS has a better predictive power in comparison with linear multiple regression model. The impact of each fiber property is also illustrated.
文摘Consolidation of thermoplastic unidirectional(UD)lami-nate with friction spun core yarns was investigated,espe-cially the characterization of filament bundles in consoli-dation was analyzed.The results showed that the bundleeffect was affected considerably by processing conditions(applied pressure and processing time).The boundaryof the bundles was disappeared under suitable processingconditions and finally an even fiber/resin distributioncould be attained.In consolidation,filament bundlesgetting close each other and resin flowing into the bundl-es occurred simultaneously,and eventually the bundleswere fully impregnated by the resin.Fiber packing den-sity in UD-laminate was the same as that of frictionspun core yarn(55%-65% in volume)and was not af-fected significantly by processing conditions under thecurrent experimental conditions.
