Mixed d/f Complexes Zn(H2L)Ln(NO3)3(Ln=Sm,Tb and Dy)：Crystal Structure,Fluorescence and Thermal Stability

A series of isostructural d/f molecular compounds Zn（H2L）Ln（NO3）3·CH3OH（Ln = Dy（1）, Tb（2） and Sm（3）） were synthesized by the introduction of a designed multifunctional ligand N,N？,N？？,N？？？-tetra（2-hydroxy-3-methoxy-5-methylbenzyl）-1,4,7,10-tetraazacyclododecan（H4L = C（44）H（60）N4O8）. In the isostructural molecules, each crystallographically independent Zn2＋ and Ln3＋ centers are connected by two phenolic oxygen atoms. For the six-coordinate Zn-（2＋） ion, the coordination geometry can be viewed as a regular bicapped square pyramid. While for the ten-coordinate Ln-（3＋） ion, if each O,O？-chelated nitrate ligand is seen as a single coordination site, the coordination geometry can be viewed as a distorted pentagonal bipyramid. The fluorescent spectra show that compounds 2 and 3 exhibited characteristic sharp emissions of Tb-（3＋） and Sm-（3＋）, respectively, while compound 1 was found to be a single-component white-light-emitting complex in the solid state. Thermal stabilities of the three compounds were investigated by using thermal gravimetric analysis. In addition, the thermal decomposition of compound 1 was confirmed by temperature-dependent powder X-ray diffraction technique.

Flexible white top-emitting organic light-emitting diode with a MoO_x roughness improvement layer

In this paper, an MoOx film is deposited on a polyethylene terephthalate （PET） substrate as a buffer layer to improve the surface roughness of the flexible PET substrate. With an optimized MoOx thickness of 100 nm, the surface roughness of the PET substrate can be reduced to a very small value of 0.273 nm （much less than 0.585 nm of the pure PET）. Flexible white top-emitting organic light-emitting diodes （TEOLEDs） with red and blue dual phosphorescent emitting layers are constructed based on a low-reflectivity Sm/Ag semi-transparent cathode. The flexible white emission exhibits the best luminance and current injection characteristics with the 100-nm-thick MoOx buffer layer and this result indicates that a smooth substrate is beneficial to the enhancement of device electrical and electroluminescence performances. However, the white TEOLED with a 50-nm-thick MoOx buffer layer exhibits a maximum current efficiency of 4.64 cd/A and a power efficiency of 1.9 lm/W, slightly higher than those with a 100-nm MoOx buffer layer, which is mainly due to an obvious intensity enhancement but limited current increases in 50-nm MoOx-based white TEOLED. The change amplitudes of the Commission International de l’Eclairage （CIE） chromaticity coordinates are less than （0.016, 0.005） for all devices in a wide luminance range over 100 cd/m2, indicating an excellent color stability in our white flexible TEOLEDs. Additionally, the flexible white TEOLED with an MoOx buffer layer shows excellent flexibility to withstand more than 500 bending times under a curvature radius of approximately 9 mm. Research demonstrates that it is mainly attributed to the high surface energy of the MoOx buffer layer, which is conducible to the improvement of the surface adhesion to the PET substrate and the Ag anode.