Steam Oxidation Resistance of Nitride Bonded Silicon Carbide Refractories for Waste Incinerators at Elevated Temperatures

Steam oxidation resistance of Si3N4 and Si2N2O as well as SiAlON bonded SiC refractories at 900℃was tested according to ASTM-C863.Phase composition and microstructure before and after oxidation were analyzed by XRD and SEM.The results show that Si3N4 and Si2N2O bonded SiC refractory presents better steam oxidation resistance than SiAlON bonded SiC.For Si3N4 and Si2N2O bonded SiC,the oxidation speed is higher with more pronounced volume expansion in the early 100 h;afterwards,the volume expansion slows down gradually and starts to level off after 300 h.It is considered that the high silica glass phase formed during the oxidation covers Si3N4 and Si2N2O,and SiC as a protective layer and fills the open pores.But for SiAlON bonded SiC,the volume expands gradually and constantly with the increasing oxidation duration even after 500 h,due to the continuous formation of mullite transformed from oxidation products and Al2O3 in SiAlON.

Low CO content hydrogen production from oxidative steam reforming of ethanol over CuO-CeO_2 catalysts at low-temperature

CuO-CeO2 catalysts were prepared by a urea precipitation method for the oxidative steam reforming of ethanol at low-temperature.The catalytic performance was evaluated and the catalysts were characterized by inductively coupled plasma atomic emission spectroscopy,X-ray diffraction,temperature-programmed reduction,field emission scanning electron microscopy and thermo-gravimetric analysis.Over CuOCeO2 catalysts,H2 with low CO content was produced in the whole tested temperature range of 250–450 C.The non-noble metal catalyst 20CuCe showed higher H2production rate than 1%Rh/CeO2 catalyst at 300–400 C and the advantage was more obvious after 20 h testing at400 C.These results further confirmed that CuO-CeO2 catalysts may be suitable candidates for low temperature hydrogen production from ethanol.

An Aluminide Surface Layer Containing Lower-Al on Ferritic-Martensitic Steel Formed by Lower-Temperature Aluminization

An aluminide（AlFe and α-（FeAl）） surface layer containing lower-Al was formed on ferritic-martensitic steel P92 by means of surface mechanical attrition treatment（SMAT） combined with a duplex aluminization process at lower temperatures,i.e.a packed aluminization followed by a diffusion annealing treatment below its tempering temperature.Indentation tests indicated that the lower-Al surface layer formed on the SMAT sample is more resistant to cracking and has better adhesion to the substrate in comparison with the Al 5Fe 2 layer formed on the as-received sample after the duplex aluminization process.Isothermal steam oxidation measurements showed that the oxidation resistance is increased significantly by the lower-Al surface layer due to the formation of a protective（Fe,Cr）Al 2O 4 layer.The rate constant of oxidation was estimated to decrease from-0.849 mg^2 cm^-4h^-1 of the as-received material to^0.011 mg^2 cm^-4 h^-1 of the AlFe layer at 700 ℃.

Renewable hydrogen production from butanol:a review

Hydrogen production from butanol is a promising alternative when it is obtained from bio-butanol or bio-oil due to the higher hydrogen content compared to other oxygenates such as methanol,ethanol or propanol.Catalysts and operating conditions play a crucial role in hydrogen production.Ni and Rh are metals mainly used for butanol steam reforming,oxidative steam reforming and partial oxidation.Additives such as Cu can improve catalytic activity in many folds.Moreover,support-metal interaction and catalyst preparation technique also play a decisive role in the stability and hydrogen production capacity of catalyst.Steam reforming technique as an option is more frequently researched due to higher hydrogen production capability in comparison to other thermochemical techniques despite its endothermic nature.The use of the oxidative steam reforming and partial oxidation has the advantages of requiring less energy and longer stability of catalysts.However,the hydrogen yield is less.This article brings together and examines the latest research on hydrogen production from butanol via steam reforming,oxidative steam reforming and partial oxidation reactions.In addition,the review examines a few thermodynamic studies based on sorption-enhanced steam reforming and dry reforming where there is potential for hydrogen extraction.