Review on Thermocline Storage Effectiveness for Concentrating Solar Power Plant

In this paper, a literature review on thermocline storage performance for Concentrating Solar Power (CSP) plant storage systems has been conducted. The efficiency of materials to store heat depends on the storage process like sensible heat storage, latent heat storage and thermochemical one and also on their properties. This study has been focused on sensible heat storage materials especially thermocline storage system (DMT) using eco-materials which has a high potentiality (35%) to reduce CSP cost. There is a possibility to use natural rocks, industry waste and to develop also materials for a thermocline storage within a bed called packed bed using one tank. The thermal storage materials should have some optimum parameters (particle diameter less than 2 cm and good thermo-physical properties) to achieve better thermal storage performance (thermal cycle efficiency, extraction factor). However, the size and the shape of natural rocks are uncontrollable (big diameter) and can drive to thermocline degradation, catastrophic thermal ratcheting and poor thermal stratification due to the variability of the storage system porosity and the stress on the storage tank wall. Also a better thermal storage efficiency is achievable at low velocity and with good thermo-physical properties of the HTF. The ratio H/D, the height, the porosity, the shape and the position of the tank should be optimized to increase the storage efficiency.

Effects of cosolvents on CO_(2) displacement of shale oil and carbon storage

Molecular dynamics method was used to establish composite wall/inorganic nanopores of three pore sizes, three shale oil systems, five CO_(2)-cosolvent systems, and pure CO_(2) system. The process of CO_(2)-cosolvent displacement of crude oil in shale nanopores and carbon storage was simulated and the influencing factors of displacement and storage were analyzed. It is shown that the attraction of the quartz wall to shale oil increases with the degree of hydroxylation. The higher the degree of quartz hydroxylation, the more difficult it is to extract the polar components of shale oil. Nanopore size also has a great impact on shale oil displacement efficiency. The larger the pore size, the higher the shale oil displacement efficiency. The closer the cosolvent molecules are to the polarity of the shale oil, the higher the mutual solubility of CO_(2) and shale oil. The more the non-polar components of shale oil, the lower the mutual solubility of CO_(2) and shale oil with highly polar cosolvent. Ethyl acetate is more effective in stripping relatively high polar shale oil, while dimethyl ether is more effective in stripping relatively low polar shale oil. Kerogen is highly adsorptive, especially to CO_(2). The CO_(2) inside the kerogen is not easy to diffuse and leak, thus allowing for a stable carbon storage. The highest CO_(2) storage rate is observed when dimethyl ether is used as a cosolvent, and the best storage stability is observed when ethyl acetate is used as a cosolvent.

Effects of Storage and Cooking on the lodine Content in lodized Salt and Study on Monitoring lodine Content in Iodized Salt

In order to ensure that the intake of iodine from iodized salt is adequate, the effects of cooking, storage and iedination on iodine content in iodized salt have been studied. For moni toring the analytical Performance, a qoality control exawhnation was also undertaken. The loss of iodine was greater when salt was stored in plastic bag than in glass bottle. The loss was greater in fortified salt stored at 37℃ and under 76% humidity than in that at 20 ~ 25℃ and under lower humidity. The retention of iodine varied with the kind of has and also was influenced by the water content of cooked food. In general, the retention of iodine during cooking varied considerably (from 36. 6% to 86. 1 % ). The iodine concentration in salts varied greater from 3.0 to 100.3 mg/kg in salt for markets, and from 0 to 90.0 mg/kg in salts for households. 48. 3 % of samples from markets were found to be in compliance with national standards (30 ~ 50 mg/kg), and 72.0% of samples from households were in compliance with national standartl (20 ~ 50 mg/kg). Analytical data collected from 8 of the cooperative laheratories foran analytical reference material showed a 95% codridence interval of the population mean for both precision and accuracy, falling within X± 2SD and passing quality control exdrination

Total Ionization Dose Effects on Charge Storage Capability of Al2O3/HfO2/Al2O3-Based Charge Trapping Memory Cell

Because of the discrete charge storage mechanism, charge trapping memory（CTM） technique is a good candidate for aerospace and military missions. The total ionization dose（TID） effects on CTM cells with Al2O3/HfO2/Al2O3（AHA） high-k gate stack structure under in-situ 10 keV x-rays are studied. The C-V characteristics at different radiation doses demonstrate that charge stored in the device continues to be leaked away during the irradiation,thereby inducing the shift of flat band voltage（V（fb））. The dc memory window shows insignificant changes, suggesting the existence of good P/E ability. Furthermore, the physical mechanisms of TID induced radiation damages in AHA-based CTM are analyzed.

Effect of Glutathione and Storage Time on Rheological Properties of Per-proofed Frozen Dough

The effect of reduced glutathione (GSH) on fresh and pre-proofed frozen dough rheological properties were investigated using dynamic stress rheometry and small scale extensibility with the addition of three levels (80×10-6, 160× 10-6 and 240×10-6 GSH) and six storage times (0 and 1 day, 2, 4, 6 and 8 weeks). Three relaxation times (1, 13 and 26min) after loading the dough in the rheometer were used to determine storage (G’) and loss (G”) moduli. Correlations for G’ (r=0.678 and 0.622 at 0.05, and 10Hz, respectively) and G” (r=0.699, and 0.690 at 0.05, and 10Hz, respectively) were observed with the area under the extension curve at 26 min relaxation time. The addition of GSH to fresh dough reduced G’ (16.4% to 55.9%) and G” (13.7% to 52.2%). Freezing and frozen storage caused increase in G’ and G”. The addition of GSH reduced dough strength indicated by the reduction in maximum resistance to extension (Rmax) and the ratio of maximum resistance to extensibility (Rmax/E). The reduction in Rmax across all relaxation times ranged from 16.2% to 59.4%. An increase in dough extension (E) was observed with 240×10-6 GSH at all frozen storage and rest period times. Addition of GSH caused an increase of liquid phase (30.6% to 35.3%) in fresh dough and frozen dough (10.3% to 20.7%) after one day frozen storage. Negative correlations of water content in the solid phase with dough extensibility and area under the extensibility curve were found (r=-0.594 and-0.563, respectively, p<0.001). This suggests a loss of dough extensibility and strength as the water holding capacity of the dough components changes during frozen storage.

Simulation of pore space production law and capacity expansion mechanism of underground gas storage

One-dimensional gas injection storage building and one-cycle injection-production modeling experiment,and two-dimensional flat core storage building and multi-cycle injection-production modeling experiment were carried out using one-dimensional long core and large two-dimensional flat physical models to find out the effects of reservoir physical properties and injection-production balance time on reservoir pore utilization efficiency,effective reservoir capacity formation and capacity-reaching cycle.The results show that reservoir physical properties and formation water saturation are the main factors affecting the construction and operation of gas-reservoir type underground gas storage.During the construction and operation of gas-reservoir type gas storage,the reservoir space can be divided into three types of working zones:high efficiency,low efficiency and ineffective ones.The higher the reservoir permeability,the higher the pore utilization efficiency is,the smaller the ineffective working zone is,or there is no ineffective working zone;the smaller the loss of injected gas is,and the higher the utilization rate of pores is.The better the reservoir physical properties,the larger the reservoir space and the larger the final gas storage capacity is.The higher the water saturation of the reservoir,the more the gas loss during gas storage capacity building and operation is.Optimizing injection-production regime to discharge water and reduce water saturation is an effective way to reduce gas loss in gas storage.In the process of multiple cycles of injection and production,there is a reasonable injection-production balance time,further extending the injection-production balance period after reaching the reasonable time has little contribution to the expansion of gas storage capacity.

Microscale comprehensive evaluation of continental shale oil recoverability

This paper targets the shale oil reservoirs of middle to high maturity in four major basins of China,including the Permian Lucaogou Formation of the Jimsar Sag in the Junggar Basin,the Chang 73 Member of the Triassic Yanchang Formation in the Longdong area of the Ordos Basin,the Kong 2 Member of the Paleogene Kongdian Formation in Cangdong Sag of the Bohai Bay Basin,and the Qing 1 Member of the Cretaceous Qingshankou Formation in Changling Sag of the Songliao Basin.The key parameters of the shale oil reservoirs in the four basins,such as reservoirs effectiveness,oil content,crude oil movability,and fracability,have been revealed under identical experimental conditions using the same evaluation technical system,on the basis of technique development and integrated application of multi-scale spatial distribution depiction,effective connectivity calculation,movable oil assessment based on the charging effect,and simulation of fracture propagation during reservoir stimulation.This research overcomes insufficient resolutions of conventional analysis approaches and difficulties in quantitative evaluation,develops the evaluation method for resource recoverability of different types of shale oil,and gains insights into different types of shale oil via comparison.The results of experiments and comparative analysis show that there are significant differences in the endowment of continental shale oil resources in the four major basins in China.Among them,the Lucaogou Formation in the Junggar Basin has more effective shale reservoirs,the Chang 73 sub-member of the Ordos Basin has a comparatively good proportion of movable oil and the Kong 2 Member of the Bohai Bay Basin has the best fracability.These results can provide references and basis for choosing development plans and engineering techniques.

3D Gravity Inversion with Correlation Image in Space Domain and Application to the Northern Sinai Peninsula

We present a 3D inversion method to recover density distribution from gravity data in space domain.Our method firstly employs 3D correlation image of the vertical gradient of gravity data as a starting model to generate a higher resolution image for inversion.The 3D density distribution is then obtained by inverting the correlation image of gravity data to fit the observed data based on classical inversion method of the steepest descent method.We also perform the effective equivalent storage and subdomain techniques in the starting model calculation,the forward modeling and the inversion procedures,which allow fast computation in space domain with reducing memory consumption but maintaining accuracy.The efficiency and stability of our method is demonstrated on two sets of synthetic data and one set of the Northern Sinai Peninsula gravity data.The inverted 3D density distributions show that high density bodies beneath Risan Aniza and low density bodies exist to the southeast of Risan Aniza at depths between 1~10 and 20 km,which may be originated from hot anomalies in the lower crust.The results show that our inversion method is useful for 3D quantitative interpretation.

Analytical models & type-curve matching techniques for reservoir characterization using wellbore storage dominated flow regime

The applicability of early time data in reservoir characterization is not always considered worthy.Early time data is usually controlled by wellbore storage effect.This effect may last for pseudo-radial flow or even boundary dominated flow.Eliminating this effect is an option for restoring real data.Using the data with this effect is another option that could be used successfully for reservoir characterization.This paper introduces new techniques for restoring disrupted data by wellbore storage at early time production.The proposed techniques are applicable for reservoirs depleted by horizontal wells and hydraulic fractures.Several analytical models describe early time data,controlled by wellbore storage effect,have been generated for both horizontal wells and horizontal wells intersecting multiple hydraulic fractures.The relationships of the peak points(humps)with the pressure,pressure derivative and production time have been mathematically formulated in this study for different wellbore storage coefficients.For horizontal wells,a complete set of type curves has been included for different wellbore lengths,skin factors and wellbore storage coefficients.Another complete set of type curves has been established for fractured formations based on the number of hydraulic fractures,spacing between fractures,and wellbore storage coefficient.The study has shown that early radial flow for short to moderate horizontal wells is the most affected by wellbore storage while for long horizontal wells;early linear flow is the most affected flow regime by wellbore storage effect.The study has also emphasized the applicability of early time data for characterizing the formations even though they could be controlled by wellbore storage effect.As a matter of fact,this paper has found out that wellbore storage dominated flow could have remarkable relationships with the other flow regimes might be developed during the entire production times.These relationships can be used to properly describe the formations and quantify some of their characteristics.

An Improved Behavioral Model for High-voltage and High-power IGBT Chips

High-voltage and high-power IGBT chips have a noticeable carrier storage effect,which is related to the load current.However,the research on the carrier storage effect of existing IGBT behavior models is insufficient.In this paper,An improved behavioral model for high-voltage and high-power insulated gate bipolar transistor(IGBT)chips is proposed,which could be used under different load conditions.The problems for applying the traditional behavioral model to more load conditions are discussed.Carrier behavior,in the wide base region,is analyzed,and the analytical expression of the carrierstorage-effect equivalent capacitance and the initial value of the tail current are provided to establish an improved IGBT behavioral model.A corresponding parameter extraction method is proposed.In order to verify the improved behavioral model,an experimental platform is built for resistive load and inductive load,and the results show that the accuracy of the improved behavioral model is much better than that of the traditional model.In addition,the errors of the improved model are within 12.5%under different current and load types.Considering that the maximum error of other models,which could be applied in a variety of load conditions,is more than 25%,the accuracy of the model proposed in this paper is excellent.