Characterization of cake layer structure on the microfiltration membrane permeability by iron pre-coagulation

A cake layer is formed by coagulation aggregates under certain transmembrane pressure in the coagulation-microfiltration （MF） process. The characteristics of humic acid aggregates coagulated by different iron-based coagulants, such as charge, size, fractal dimension and compressibility, have an effect on the cake layer structure. At the optimum iron dose of 0.6 to 0.8 mmol/L for ferric chloride （FC） and polymer ferric sulfate （PFS） pre-coagulation, at the point of charge neutralization for near zero zeta potential, the aggregate particles produced possess the greatest size and highest fractal dimension, which contributes to the cake layer being most loose with high porosity and low compressibility. Thus the membrane filterability is better. At a low or high iron dose of FC and PFS, a high negative or positive zeta potential with high charge repulsion results in so many small aggregate particles and low fractal dimension that the cake layer is compact with low porosity and high compressibility. Therefore the membrane fouling is accelerated and MF permeability becomes worse. The variation of cake layer structure as measured by scanning electric microscopy corresponds with the fact that the smaller the coagulation flocs size and fractal dimension are, the lower the porosity and the tighter the cake layer conformation. This also explains the MF membrane flux variation visually and accurately.

Process Design for Hybrid Sheet Metal Components

The global trends towards improving fuel efficiency and reducing CO;emissions are the key drivers for lightweight solutions. In sheet metal processing, this can be achieved by the use of materials with a supreme strength-toweight and stiffness-to-weight ratio. Besides monolithic materials such as high-strength or light metals, in particular metal–plastic composite sheets are able to provide outstanding mechanical properties. Thus, the adaption of conventional, wellestablished forming methods for the processing of hybrid sheet metals is a current challenge for the sheet metal working industry. In this work, the planning phase for a conventional sheet metal forming process is studied aiming at the forming of metal–plastic composite sheets. The single process steps like material characterization, FE analysis, tool design and development of robust process parameters are studied in detail and adapted to the specific properties of metal–plastic composites. In material characterization, the model of the hybrid laminate needs to represent not only the mechanical properties of the individual combined materials, but also needs to reflect the behaviour of the interface zone between them.Based on experience, there is a strong dependency on temperature as well as strain rate. While monolithic materials show a moderate anisotropic behaviour, loads on laminates in different directions generate different strain states and completely different failure modes. During the FE analysis, thermo-mechanic and thermo-dynamic effects influence the temperature distribution within tool and work pieces and subsequently the forming behaviour. During try out and production phase,those additional influencing factors are limiting the process window even more and therefore need to be considered for the design of a robust forming process. A roadmap for sheet metal forming adjusted to metal–plastic composites is presented in this paper.