期刊文献+
共找到5篇文章
< 1 >
每页显示 20 50 100
Structure and Magnetic Properties of the γ’-Fe4N Films on Cu Underlayers
1
作者 江凤仙 赵烨 +3 位作者 周国伟 张君 范九萍 许小红 《Chinese Physics Letters》 SCIE CAS CSCD 2015年第8期148-151,共4页
The γ'-Fe4N films on Cu underlayers are deposited on the glass and Si substrates by dc magnetron reactive sputtering. The effects of Cu underlayer on the structure, morphology and magnetic properties of the γ'-Fe4... The γ'-Fe4N films on Cu underlayers are deposited on the glass and Si substrates by dc magnetron reactive sputtering. The effects of Cu underlayer on the structure, morphology and magnetic properties of the γ'-Fe4N films are studied. The single-phase γ'-Fe4N films with Cu underlayers on the glass substrate are obtained, while the mixture of Fe and γ'-Fe4N is observed on the Si substrate. In comparison with the films without Cu underlayers, the grains of the films with Cu underlayers exhibit a non-uniform size distribution and give rise to a rougher surface. The magnetic measurements indicate that the γ'-Fe4N films show a good soft ferromagnetic behavior. The enhanced coercivity in the films with Cu underlayers is observed due to the deterioration of the crystallographic structure as well as the rougher surface. 展开更多
关键词 fe4N films on cu Underlayers cu structure and Magnetic Properties of the
下载PDF
Structure and Magnetic Properties of Fe_(76.5)Si_(13.5)B_9Cu_1 Alloy with Nanoscale Grain Size 被引量:1
2
作者 Fei ZHOU Kaiyuan HE Lizhi CHENG and Zuhan LAI(Dept. of Materials Science and Engineering, Northeastern University, Shenyang, 110006, China)( Dept. of Phys., Northeastern University) 《Journal of Materials Science & Technology》 SCIE EI CAS CSCD 1994年第6期430-434,共5页
The structure and magnetic properties of Fe76.5Si13.5B9Cu1 alloys with a nanocrystalline (NC) bcc Fe(Si) phase trom about 23 to 46 nm in diameter, which were first formed into amorphous ribbons and then annealed at va... The structure and magnetic properties of Fe76.5Si13.5B9Cu1 alloys with a nanocrystalline (NC) bcc Fe(Si) phase trom about 23 to 46 nm in diameter, which were first formed into amorphous ribbons and then annealed at various temperatures between 703 and 773 K, have been investigated. At annealing temperatures from 703 to 748 K, the single NC bcc(Si) phase is obtained in the crystallized alloys. The grain size and the Si-content in the NC bcc Fe(Si) phase for the alloys annealed at different temperatures are presented. The soft magnetic properties and the saturation magnetostriction for the alloys with the NC bcc Fe(Si) phase are also measured. The results show that, the saturation magnetizotion and the permeability are improved for the alloys with only the NC bcc Fe(Si) phase and become better with decreasing of the NC bcc phase size, and the saturation magnetostriction declines for the alloys with increasing Si-content in the NC bcc Fe(Si) phase. 展开更多
关键词 SI structure and Magnetic Properties of fe B9cu1 Alloy with Nanoscale grain Size cu
下载PDF
Fe含量和粒径对Fe/Cu颗粒膜结构和磁性的影响 被引量:5
3
作者 郑勇林 《物理实验》 2005年第1期17-21,共5页
采用共蒸发法制备不同组分的Fe/Cu颗粒膜,将样品分两组进行退火和不退火处理. 根据测量及分析,确定了不同成分的Fe/Cu颗粒膜的相组成和晶体结构;找出了 Fe/Cu颗粒膜矫顽力与粒径的关系,利用此关系由自发形核理论可知,提高功率,快速蒸镀... 采用共蒸发法制备不同组分的Fe/Cu颗粒膜,将样品分两组进行退火和不退火处理. 根据测量及分析,确定了不同成分的Fe/Cu颗粒膜的相组成和晶体结构;找出了 Fe/Cu颗粒膜矫顽力与粒径的关系,利用此关系由自发形核理论可知,提高功率,快速蒸镀薄膜,可得到细密颗粒的Fe/Cu颗粒膜,从而降低矫顽力,减少磁滞损耗. 展开更多
关键词 fe/cu颗粒膜 fe/cu颗粒膜结构 磁学性能
下载PDF
电磁搅拌对Cu-Ni-Fe-Al合金晶粒尺寸的影响
4
作者 李冬生 刘英 +3 位作者 张亚楠 柴登鹏 梁玉冬 刘丹 《中国铸造装备与技术》 CAS 2020年第4期87-92,共6页
采用真空熔炼铸造法,在Cu-Ni-Fe-Al耐蚀合金的凝固过程中,对其施加电磁搅拌,并考察搅拌电流、搅拌频率等参数对Cu-Ni-Fe-Al耐蚀合金晶粒尺寸的影响。结果表明:对于Cu-Ni-Fe-Al耐蚀合金,在其凝固过程中对其施加电磁搅拌,起到细化晶粒的作... 采用真空熔炼铸造法,在Cu-Ni-Fe-Al耐蚀合金的凝固过程中,对其施加电磁搅拌,并考察搅拌电流、搅拌频率等参数对Cu-Ni-Fe-Al耐蚀合金晶粒尺寸的影响。结果表明:对于Cu-Ni-Fe-Al耐蚀合金,在其凝固过程中对其施加电磁搅拌,起到细化晶粒的作用,明显改善合金凝固组织,使铸件得到细小的等轴晶结构。在电磁搅拌的影响因素中,电流强度相比于搅拌频率对晶粒的细化作用效果更为明显。 展开更多
关键词 cu-Ni-fe-Al合金 电磁搅拌 凝固组织 晶粒尺寸
下载PDF
Cu-Sn合金上引连铸凝固组织数值模拟 被引量:3
5
作者 杨庆宝 王兰浩 +3 位作者 曾浩 袁大伟 汪航 杨斌 《铸造技术》 CAS 2022年第2期123-130,共8页
分析了直径8 mm的Cu-0.3%Sn合金铸锭在上引连续铸造过程中的凝固行为。以微观-宏观耦合为基准,采用MiLE法和CA-FE法分别模拟了温度场变化及晶粒生长演变过程。系统地研究不同铸造温度(1150、1200、1250℃)及不同铸造速度(1、3、5 mm/s)... 分析了直径8 mm的Cu-0.3%Sn合金铸锭在上引连续铸造过程中的凝固行为。以微观-宏观耦合为基准,采用MiLE法和CA-FE法分别模拟了温度场变化及晶粒生长演变过程。系统地研究不同铸造温度(1150、1200、1250℃)及不同铸造速度(1、3、5 mm/s)对Cu-0.3Sn合金在上引连铸凝固过程中固/液界面形状、液穴深度及晶粒的影响规律。模拟结果与实验结果一致,并验证了仿真模拟的准确性。 展开更多
关键词 cu-Sn合金 凝固模拟 CA-fe 固/液界面 晶粒组织
下载PDF
上一页 1 下一页 到第
使用帮助 返回顶部