This paper proposes third order tunable bandwidth active Switched-Capacitor filter. The circuit consists of only op-amps and switched capacitors. The circuit is designed for circuit merit factor Q = 10. The proposed c...This paper proposes third order tunable bandwidth active Switched-Capacitor filter. The circuit consists of only op-amps and switched capacitors. The circuit is designed for circuit merit factor Q = 10. The proposed circuit implements three filter functions low pass, band pass and high pass simultaneously in single circuit. The filter circuit can be used for both narrow as well as for wide bandwidth. For various values of cut-off frequencies the behaviour of circuit is studied. The circuit works properly only for higher central frequencies, when f0 > 10 kHz.展开更多
This paper presents a novel method that is applied to realize the Linear Transformation(LT)Switched-Capacitor Filter(SCF).It adopts the Voltage Control Voltage Source(VCVS)equalized transfor-mation to revise the origi...This paper presents a novel method that is applied to realize the Linear Transformation(LT)Switched-Capacitor Filter(SCF).It adopts the Voltage Control Voltage Source(VCVS)equalized transfor-mation to revise the original LC ladder filter and induce it into 16 basic sections and then extend the princi-ple of the LT in order to fit active and 3 port networks and give out switched-capacitor circuits corre-sponding to the 16 basic sections,which can realize all four kinds of filters——LP,HP,BP,BS filters.De-signed examples are given here.An Nth order filter only requires N amplifiers and the circuit is insensitive toparasitic capacitances.The experimental results of a 3rd order elliptic LP and a 6th order elliptic BP are giv-en and agree with the theory.展开更多
In this paper the design and implementation of sixth-order lowpass elliptic switched-capacitor filter( SCF) for interface circuit of Micro-Electro-Mechanical System( MEMS) sensor are presented. This work aims to lower...In this paper the design and implementation of sixth-order lowpass elliptic switched-capacitor filter( SCF) for interface circuit of Micro-Electro-Mechanical System( MEMS) sensor are presented. This work aims to lower total harmonic distortion( THD) without deteriorating other performances. After system design in Simulink,the filter is realized in transistor level and finally fabricated in Central Semiconductor Manufacturing Corporation( CSMC) 0.5 μm metal-oxide-semiconductor( CMOS) technology. Typical measured results are: it operates with 25: 1 clock-to-corner frequency ratio and a 10 k Hz maximum corner frequency. The maximum passband ripple is about 0.49 d B and the minimum stopband rejection is 40 d B for the temperature from-20 ℃to 80 ℃. For the 250 k Hz clock frequency setting,given the 1 k Hz,- 8 d BVrms input signal,the measured worst case THD is-64 d B. The active area of the chip is 2.8 mm2 with 8 pads. The analog power dissipation is10 m W from a 5 V power supply.展开更多
In conformity with a fifth order RLC elliptic filter circuit prototype, it is easy to conceive the corresponding RC active filter circuit. Simple and feasible method presented here can be used to contrive...In conformity with a fifth order RLC elliptic filter circuit prototype, it is easy to conceive the corresponding RC active filter circuit. Simple and feasible method presented here can be used to contrive the equivalent switched capacitor filter circuit and switched current filter circuit. Consulting the technique data manual, we can expediently design a specific RLC filter. Therefore, it is of great convenience to design the switched current filter, which has the same performances. Such a kind of technology is useful in the domain of analogue sampled data signal processing.展开更多
Two novel switched-capacitor(SC)bandpass filters using a single operational am-plifier(op amp)are presented.Optimal designs for minimizing capacitor spread are also given.Gain-bandwidth product(GB)effects of op amps o...Two novel switched-capacitor(SC)bandpass filters using a single operational am-plifier(op amp)are presented.Optimal designs for minimizing capacitor spread are also given.Gain-bandwidth product(GB)effects of op amps on the proposed SC circuits are taken intoconsideration.Comparisons with the proposed circuits and the circuits given by the literatureshow that the new circuits require less chip area in monolithic integration and are less sensitiveto the GB effects.展开更多
In order to realize accurate bilinear transformation from s- to z-domain,a novelswitched-capacitor configuration is proposed in the light of principles of dual-rate sampling and chargeconservation,which has also been ...In order to realize accurate bilinear transformation from s- to z-domain,a novelswitched-capacitor configuration is proposed in the light of principles of dual-rate sampling and chargeconservation,which has also been used for building a 5th-order elliptic lowpass filter.The filter issimulated and measured in typical 0.34 μm/3.3 V Si CMOS process models,special full differentialoperational amplifiers and CMOS transfer gate switches,which achieves 80 MHz sampling rate,17.8MHz cutoff frequency,0.052 dB maximum passband ripple,42.1 dB minimum stopband attenuation and74 mW quiescent power dissipation.At the same time,the dual-rate sampling topology breaks thetraditional restrictions of filter introduced by unit-gain bandwidth and slew rate of operational amplifiersand also improves effectively their performances in high-frequency applications.It has been applied forthe design of an anti-alias filter in analog front-end of video decoder IC with 15 MHz signal frequencyyet.展开更多
文摘This paper proposes third order tunable bandwidth active Switched-Capacitor filter. The circuit consists of only op-amps and switched capacitors. The circuit is designed for circuit merit factor Q = 10. The proposed circuit implements three filter functions low pass, band pass and high pass simultaneously in single circuit. The filter circuit can be used for both narrow as well as for wide bandwidth. For various values of cut-off frequencies the behaviour of circuit is studied. The circuit works properly only for higher central frequencies, when f0 > 10 kHz.
文摘This paper presents a novel method that is applied to realize the Linear Transformation(LT)Switched-Capacitor Filter(SCF).It adopts the Voltage Control Voltage Source(VCVS)equalized transfor-mation to revise the original LC ladder filter and induce it into 16 basic sections and then extend the princi-ple of the LT in order to fit active and 3 port networks and give out switched-capacitor circuits corre-sponding to the 16 basic sections,which can realize all four kinds of filters——LP,HP,BP,BS filters.De-signed examples are given here.An Nth order filter only requires N amplifiers and the circuit is insensitive toparasitic capacitances.The experimental results of a 3rd order elliptic LP and a 6th order elliptic BP are giv-en and agree with the theory.
基金Sponsored by the Fundamental Research Funds for the Central Universities(Grant No.HIT.NSRIF.2013040)
文摘In this paper the design and implementation of sixth-order lowpass elliptic switched-capacitor filter( SCF) for interface circuit of Micro-Electro-Mechanical System( MEMS) sensor are presented. This work aims to lower total harmonic distortion( THD) without deteriorating other performances. After system design in Simulink,the filter is realized in transistor level and finally fabricated in Central Semiconductor Manufacturing Corporation( CSMC) 0.5 μm metal-oxide-semiconductor( CMOS) technology. Typical measured results are: it operates with 25: 1 clock-to-corner frequency ratio and a 10 k Hz maximum corner frequency. The maximum passband ripple is about 0.49 d B and the minimum stopband rejection is 40 d B for the temperature from-20 ℃to 80 ℃. For the 250 k Hz clock frequency setting,given the 1 k Hz,- 8 d BVrms input signal,the measured worst case THD is-64 d B. The active area of the chip is 2.8 mm2 with 8 pads. The analog power dissipation is10 m W from a 5 V power supply.
文摘In conformity with a fifth order RLC elliptic filter circuit prototype, it is easy to conceive the corresponding RC active filter circuit. Simple and feasible method presented here can be used to contrive the equivalent switched capacitor filter circuit and switched current filter circuit. Consulting the technique data manual, we can expediently design a specific RLC filter. Therefore, it is of great convenience to design the switched current filter, which has the same performances. Such a kind of technology is useful in the domain of analogue sampled data signal processing.
文摘Two novel switched-capacitor(SC)bandpass filters using a single operational am-plifier(op amp)are presented.Optimal designs for minimizing capacitor spread are also given.Gain-bandwidth product(GB)effects of op amps on the proposed SC circuits are taken intoconsideration.Comparisons with the proposed circuits and the circuits given by the literatureshow that the new circuits require less chip area in monolithic integration and are less sensitiveto the GB effects.
基金Supported by the National Nature Science Foundation(No. 60072004)and the University Postgraduate Station Foundation of China(No.2000061402)
文摘In order to realize accurate bilinear transformation from s- to z-domain,a novelswitched-capacitor configuration is proposed in the light of principles of dual-rate sampling and chargeconservation,which has also been used for building a 5th-order elliptic lowpass filter.The filter issimulated and measured in typical 0.34 μm/3.3 V Si CMOS process models,special full differentialoperational amplifiers and CMOS transfer gate switches,which achieves 80 MHz sampling rate,17.8MHz cutoff frequency,0.052 dB maximum passband ripple,42.1 dB minimum stopband attenuation and74 mW quiescent power dissipation.At the same time,the dual-rate sampling topology breaks thetraditional restrictions of filter introduced by unit-gain bandwidth and slew rate of operational amplifiersand also improves effectively their performances in high-frequency applications.It has been applied forthe design of an anti-alias filter in analog front-end of video decoder IC with 15 MHz signal frequencyyet.
