Photothermal Catalytic Selective Oxidation of Isobutane to Methacrylic Acid over Keggin-Type Heteropolyacid

Thermal and photothermal catalytic selec-tive oxidation of isobutane to methacrylic acid(MAA)are comparatively studied over a keggin-type Cs2.9Cu0.34V0.49PMo12O40 het-eropolyacid acid.An introduction of light was observed to enhance both the i-C4H10 conversion and the MAA selectivity,and consequently the MAA formate rate,particularly at low temperatures.Characterization re-sults show that oxidation of methacrolein(MAL)to MAA is the rate-limiting step while UV light illumination promotes the oxidation ofσ-bonded MAL with OH groups toσ-bonded MAA on the catalyst surface.These results demonstrate a synergistic effect of thermal cataly-sis and photocatalysis in selective oxidation of isobutane to MAA,which suggests photother-mal catalysis as a promising strategy to catalyze the selective oxidation of higher hydrocar-bons at relative mild reaction conditions.

Removal of formaldehyde over Mn_xCe_(1- x)O_2 catalysts: Thermal catalytic oxidation versus ozone catalytic oxidation

MnxCe1- xO2（x： 0.3–0.9） prepared by Pechini method was used as a catalyst for the thermal catalytic oxidation of formaldehyde（HCHO）. At x = 0.3 and 0.5, most of the manganese was incorporated in the fluorite structure of Ce O2 to form a solid solution. The catalytic activity was best at x = 0.5, at which the temperature of 100% removal rate is the lowest（270°C）. The temperature for 100% removal of HCHO oxidation is reduced by approximately 40°C by loading 5 wt.% Cu Oxinto Mn0.5Ce0.5O2. With ozone catalytic oxidation, HCHO（61 ppm） in gas stream was completely oxidized by adding 506 ppm O3 over Mn0.5Ce0.5O2 catalyst with a GHSV（gas hourly space velocity） of 10,000 hr-1at 25°C. The effect of the molar ratio of O3 to HCHO was also investigated. As O3/HCHO ratio was increased from 3 to 8, the removal efficiency of HCHO was increased from 83.3% to 100%. With O3/HCHO ratio of 8, the mineralization efficiency of HCHO to CO2 was 86.1%. At 25°C, the p-type oxide semiconductor（Mn0.5Ce0.5O2） exhibited an excellent ozone decomposition efficiency of 99.2%,which significantly exceeded that of n-type oxide semiconductors such as Ti O2, which had a low ozone decomposition efficiency（9.81%）. At a GHSV of 10,000 hr-1, [O3]/[HCHO] = 3 and temperature of 25°C, a high HCHO removal efficiency（≥ 81.2%） was maintained throughout the durability test of 80 hr, indicating the long-term stability of the catalyst for HCHO removal.

Catalytic Kinetic on the Thermal Decomposition of Ammonium Perchlorate with a New Energetic Complex Based on 3,5-Bis(3-pyridyl)-1H-1,2,4-triazole

A new energetic complex,[Co（3,3？-Hbpt）（Htm）]·H_2O（1,3,3？-Hbpt = 3,5-bis（3-pyridyl）-1H-1,2,4-triazole and H_3tm = trimesic acid）,has been synthesized by hydrothermal reactions and characterized by single-crystal X-ray diffraction,elementary analysis,IR spectroscopy,thermogravimetric analysis and X-ray powder diffraction. Single-crystal X-ray diffraction indicates that the complex belongs to triclinic system,space group P 1 with a = 10.0911（1）,b = 10.2573（1）,c = 10.6393（1） ？,α = 103.793（2）,β = 101.041（2）,γ = 107.918（3）o,V = 974.9（2） ？~3,Z = 2,D_c = 1.732 g·cm-3,μ = 0.941 mm^（-1）,M_r = 508.31,F（000） = 518,the final R = 0.0523 and wR = 0.0935 with I 〉 2σ（I）. In the title complex,Co（Ⅱ） ions are connected by Htm2-anions generating 1D ladder-like chains which are linked by 3,3？-Hbpt to form 1D cages. In addition,the thermal decomposition of ammonium perchlorate（AP） with complex 1 was explored by differential scanning calorimetry（DSC）. AP is completely decomposed in a shorter time in the presence of complex 1,and the decomposition heat of the mixture is 2.531 kJ·g^（-1）,significantly higher than that of pure AP. By Kissinger＇s method,the ratio of Ea/ln（A） is 11.05 for the mixture,which indicates that complex 1 shows good catalytic activity toward the AP decomposition.

Kinetics and mechanisms of the catalytic thermal cracking of asphaltenes adsorbed on supported nanoparticles

The production of heavy and extra-heavy oil is challenging because of the rheological properties that crude oil presents due to its high asphaltene content.The upgrading and recovery processes of these unconventional oils are typically water and energy intensive,which makes such processes costly and environmentally unfriendly.Nanoparticle catalysts could be used to enhance the upgrading and recovery of heavy oil under both in situ and ex situ conditions.In this study,the effect of the Ni-Pd nanocatalysts supported on fumed silica nanoparticles on post-adsorption catalytic thermal cracking of n-C_7 asphaltenes was investigated using a thermogravimetric analyzer coupled with FTIR.The performance of catalytic thermal cracking of n-C_7asphaltenes in the presence of NiO and PdO supported on fumed silica nanoparticles was better than on the fumed silica support alone.For a fixed amount of adsorbed n-C_7asphaltenes（0.2 mg/m～2）,bimetallic nanoparticles showed better catalytic behavior than monometallic nanoparticles,confirming their synergistic effects.The corrected OzawaFlynn-Wall equation（OFW） was used to estimate the effective activation energies of the catalytic process.The mechanism function,kinetic parameters,and transition state thermodynamic functions for the thermal cracking process of n-C_7 asphaltenes in the presence and absence of nanoparticles are investigated.

Catalytic thermal decomposition of ammonium perchlorate by a series of lanthanide EMOFs

Given their unique and excellent properties,metal-organic frameworks(MOFs)materials have been used in many scientific fields.EMOFs use energetic materials as ligands,which can provide part of the energy for the system while catalyzing ammonium perchlorate.The energetic material 1.1'-dihydroxyazotetrazole(H_(2)AzTO),as a high-energy nitrogen-rich material,was selected as a ligand.Five kinds of La^(3+),Ce^(3+),Pr^(3+),Nd^(3+),and Sm^(3+)lanthanide EMOFs were synthesized and obtained.Single crystal X-ray diffraction tests were conducted to obtain the crystal structures of EMOFs 1-5,which indicate that they have similar crystal structures.The thermal stabilities of EMOFs 1-5,which are obtained by differential scanning calorimetry(DSC)tests,are improved compa red with that of the ligand.The results of thermicdecomposition of ammonium perchlorate(AP)and AP mixtures with 10 wt%EMOFs 1-5 show that except for AP mixed with 10 wt%co mpound 2,the high-temperature decomposition peak tempe rature of AP mixed with other compounds is significantly advanced(up to 59.3-88.3 K),and the decomposition of AP is continuous and violent.EMOFs 3-5 have good application prospects for the catalytic thermicdecomposition of AP.

Enhanced growth of crystalline-amorphous core-shell silicon nanowires by catalytic thermal CVD using in situ generated tin catalyst

In this work,we prepared silicon nanowires(Si NWs) on both fluorine-doped SnO 2(FTO) coated glass substrate and common glass substrate by catalytic thermal chemical vapor deposition(CVD) using indium film as the catalyst.It is confirmed that indium can catalyze the growth of Si NWs.More importantly,we found that tin generated in situ from the reduction of SnO 2 by indium can act as catalyst,which greatly enhances the growth of Si NWs on FTO substrate.The obtained Si NWs have a uniform crystalline-amorphous core-shell structure that is formed via vapor-liquid-solid and vapor-solid growth of silicon sequentially.This work provides a strategy to prepare Si NWs in high yield by catalytic thermal CVD using the low melting point metal catalysts.

In situ Fourier Transform Infrared Spectroscopy Diagnostic for Characterization and Performance Test of Catalysts

The present work establishes a systematic approach based on the application of in-situ Fourier transform infrared spectroscopy （FTIR） for the investigation of the crystal structure, thermal stability, redox behavior （temperature-programmed reduction/temperatureprogrammed re-oxidation） as well as the catalytic properties of Co3O4 thin films. The syntheses of Co3O4 were achieved by chemical vapor deposition in the temperature range of 400-500℃. The structure analysis of the as-prepared material revealed the presence of two prominent IR bands peaking at 544 cm-1 （υ1） and 650 cm-1 （υ2） respectively, which originate from the stretching vibrations of the Co-O bond, characteristic of the Co3O4 spinel. The lattice stability limit of Co3O4 was estimated to be above 650℃. The redox properties of the spinel structure were determined by integrating the area under the emission bands υ1 and υ2 as a function of the temperature. Moreover, Co3O4 has been successfully tested as a catalyst towards complete oxidation of dimethyl ether below 340 ℃. The exhaust gas analysis during the catalytic process by in situ absorption FTIR revealed that only CO2 and H2O were detected as the final products in the catalytic reaction. The redox behavior suggests that the oxidation of dimethyl ether over Co3O4 follows a Mars-van Krevelen type mechanism. The comprehensive application of in situ FTIR provides a novel diagnostic tool in characterization and performance test of catalysts.

Review on catalytic roles of rare earth elements in ammonia synthesis:Development and perspective

Ammonia(NH3)is mainly produced via the Haber-Bosch process.It was discovered that the performance of a wide variety of catalysts in NH3 synthesis could be considerably enhanced by the addition of rare earth elements(REEs).As a result,catalysts promoted by REEs,especially the Ru-based ones have been extensively investigated.In this review,we summarize the progress of utilizing REEs for ammonia synthesis and outline the prospects of using them in the design and development of highly efficient and stable catalysts for ammonia synthesis.

Effects of support property on the catalytic performance of CeO_2-ZrO_2-CrO_x for 1,2-dichloroethane oxidation

HZSM-5, Al_2O_3, TiO_2 and SiO_2 supported CeO_2-ZrO_2-CrO_x catalysts were prepared by deposition-precipitation method and tested for deep catalytic oxidation of 1,2-dichloroethane（DCE）, as one of the common chlorinated organic pollutants. All the catalysts were characterized by means of N_2 adsorption-desorption, X-ray photoelectron spectroscopy（XPS）, ammonia-temperatureprogrammed desorption（NH_3-TPD） and hydrogen temperature-programmed reduction（H2-TPR）. The characterization results revealed that there was strongly synergistic effect between the oxidizability of CZCr species and the acidity of supports, which obviously promoted the catalytic activity for DCE degradation. 20% CZCr/HZSM-5 showed the highest activity and good durability during the long-term continuous test. The catalytic activity decreased in the order： 20%CZCr/HZSM-5〉CZCr〉20%CZCr/TiO_2〉20%CZCr/Al_2O_3〉20%CZCr/SiO_2.

Electro-catalytic degradation properties of Ti/SnO_2–Sb electrodes doped with different rare earths

Ti/SnO2–Sb electrode has a good effect on the removal of organic pollutants. But its short service life limits its large-scale application in industry. Electro-catalytic degradation performances and service life of the electrode can be significantly improved by doping rare earth（RE） ions into the oxide coating of Ti/SnO2–Sb electrode. Ti/SnO2–Sb electrodes doped with different RE elements（Ce, Dy, La, and Eu） were prepared by the thermal decomposition method at 550 ℃. Electro-catalytic degradation performances of electrodes doped with different RE elements were evaluated by linear sweep voltammetry（LSV） and Tafel curves. During the electrolysis,the conversion of p-nitrophenol was performed with these electrodes as anodes under galvanostatic control. The structures and morphologies of the surface coating of the electrodes were characterized by scanning electron microscope（SEM）. The results demonstrate that the electro-catalytic degradation performances of Ti/SnO2–Sb electrodes are improved to different levels by doping different RE ions. Improved Ti/SnO2–Sb electrodes by the introduction of different RE have higher oxygen evolution potential, better electro-catalysis ability, better coverage,and longer electrode life.