In this paper,a new radar target identification scheme is presented based on adaptivediscrimination waveform synthesis and a nearest neighbor neural network.It can directly use theimpulse response of the target to syn...In this paper,a new radar target identification scheme is presented based on adaptivediscrimination waveform synthesis and a nearest neighbor neural network.It can directly use theimpulse response of the target to synthesize discrimination waveform,so the poles extractionprocedure is not required.Particularly,it can successfully operate on the case that the poles ofthe target are weakly dependent on the aspect angle.展开更多
We investigate the XY control and manipulation of the superconducting qubit state using direct digital synthesis(DDS)for the microwave pulse signal generation.The decoherence time, gate fidelity, and other qubit prope...We investigate the XY control and manipulation of the superconducting qubit state using direct digital synthesis(DDS)for the microwave pulse signal generation.The decoherence time, gate fidelity, and other qubit properties are measured and carefully characterized, and compared with the results obtained by using the traditional mixing technique for the microwave pulse generation.In particular, the qubit performance in the state manipulation with respect to the sampling rate of DDS is studied.Our results demonstrate that the present technique provides a simple and effective method for the XY control and manipulation of the superconducting qubit state.Realistic applications of the technique for the possible future scalable superconducting quantum computation are discussed.展开更多
In order to improve the accuracy of cable fault position location at a low cost and make the testing results intuitive, a cable fault detector based on wave form reconstruction is designed. In this detector, the cable...In order to improve the accuracy of cable fault position location at a low cost and make the testing results intuitive, a cable fault detector based on wave form reconstruction is designed. In this detector, the cable fault position is located based on the time-domain pulse reflection （TDR） principle. A pulse waveform is injected in the tested cable, and a high-speed comparator with changeable reference voltages is used to binarize the test pulse waveform to a binary sequence on a certain voltage. Through scanning the reference voltage in a full voltage range, multi-sequences are acquired to reconstruct the pulse waveform transmission in the cable, and then the pulse attenuation feature, electrical open circuit fault, electrical short circuit fault, and the fault position of the cable are diagnosed. Experimental results show that the designed cable fault detector can determine the fault type and its position of the cable being tested, and the testing results are intuitive.展开更多
Multiple-input multiple-output(MIMO)systems which deploy one-bit DACs are at-tractive in many fields,such as wireless communications and radar.In this paper,the problem of transmit waveform design in MIMO radar system...Multiple-input multiple-output(MIMO)systems which deploy one-bit DACs are at-tractive in many fields,such as wireless communications and radar.In this paper,the problem of transmit waveform design in MIMO radar system with one-bit DACs is investigated.By appropri-ately designing the transmitted QPSK signal waveforms,the majority of radiated energy can be fo-cused into the mainlobe region(s)by minimizing the integrated sidelobe to mainlobe ratio(ISMR)of beampattern,such that the intensity of backscattered signals from targets can be enhanced.However,the resulting optimization problem which consists of constrained fractional quadratic problem(CFQP)is noconvex.To tackle this problem,a block-sparse semidefinite relaxation meth-od is first utilized to reformulate the CFQP into a reduced convex semidefinite programming(SDP).Further,a customized interior point algorithm(IPA)is developed to solve the small-scale SDP.Finally,the desirable one-bit transmit waveform sequence can be properly synthesized by us-ing Gaussian randomization method.Numerical simulation results demonstrate that the proposed method offer better performance than the state-of-the-art algorithms.展开更多
针对BS EN 55035:2017第4.2.7节宽带脉冲传导骚扰测试中的高斯白噪声特殊波形要求,提出了基于matlab 滤波器构造函数产生高斯白噪声台阶,通过信号源的多载波合成功能对高斯白噪声台阶进行幅度调制,合成要求的高斯白噪声波形的方法。使用...针对BS EN 55035:2017第4.2.7节宽带脉冲传导骚扰测试中的高斯白噪声特殊波形要求,提出了基于matlab 滤波器构造函数产生高斯白噪声台阶,通过信号源的多载波合成功能对高斯白噪声台阶进行幅度调制,合成要求的高斯白噪声波形的方法。使用ARB toolbox composer调整高斯白噪声波形参数,可得到标准要求的周期脉冲信号。实测对比验证表明,高斯白噪声波形的实现方法正确。展开更多
A memory compress algorithm for 12\|bit Arbitrary Waveform Generator (AWG) is presented and optimized. It can compress waveform memory for a sinusoid to 16×13bits with a Spurious Free Dynamic Range (SFDR) 90.7dBc...A memory compress algorithm for 12\|bit Arbitrary Waveform Generator (AWG) is presented and optimized. It can compress waveform memory for a sinusoid to 16×13bits with a Spurious Free Dynamic Range (SFDR) 90.7dBc (1/1890 of uncompressed memory at the same SFDR) and to 8×12bits with a SFDR 79dBc. Its hardware cost is six adders and two multipliers. Exploiting this memory compress technique makes it possible to build a high performance AWG on a chip.展开更多
文摘In this paper,a new radar target identification scheme is presented based on adaptivediscrimination waveform synthesis and a nearest neighbor neural network.It can directly use theimpulse response of the target to synthesize discrimination waveform,so the poles extractionprocedure is not required.Particularly,it can successfully operate on the case that the poles ofthe target are weakly dependent on the aspect angle.
基金Project was supported by the National Natural Science Foundation of China(Grant No.11890704)the National Key Research and Development Program of China(Grant No.2016YFA0301802)+1 种基金the National Basic Research Program of China(Grant Nos.2015CB921104 and 2016YFA0300601)the Key R&D Program of Guangdong Province,China(Grant No.2018B0303326001)
文摘We investigate the XY control and manipulation of the superconducting qubit state using direct digital synthesis(DDS)for the microwave pulse signal generation.The decoherence time, gate fidelity, and other qubit properties are measured and carefully characterized, and compared with the results obtained by using the traditional mixing technique for the microwave pulse generation.In particular, the qubit performance in the state manipulation with respect to the sampling rate of DDS is studied.Our results demonstrate that the present technique provides a simple and effective method for the XY control and manipulation of the superconducting qubit state.Realistic applications of the technique for the possible future scalable superconducting quantum computation are discussed.
基金The National Natural Science Foundation of China(No.61240032)the Natural Science Foundation of Jiangsu Province(No.BK2012560)+1 种基金the College Scientific and Technological Achievements Transformation Promotion Project of Jiangsu Province(No.JH-05)the Science and Technology Support Program of Jiangsu Province(No.BE2012740)
文摘In order to improve the accuracy of cable fault position location at a low cost and make the testing results intuitive, a cable fault detector based on wave form reconstruction is designed. In this detector, the cable fault position is located based on the time-domain pulse reflection （TDR） principle. A pulse waveform is injected in the tested cable, and a high-speed comparator with changeable reference voltages is used to binarize the test pulse waveform to a binary sequence on a certain voltage. Through scanning the reference voltage in a full voltage range, multi-sequences are acquired to reconstruct the pulse waveform transmission in the cable, and then the pulse attenuation feature, electrical open circuit fault, electrical short circuit fault, and the fault position of the cable are diagnosed. Experimental results show that the designed cable fault detector can determine the fault type and its position of the cable being tested, and the testing results are intuitive.
基金the National Natural Science Found-ation of China(No.62171292)the Guangdong Basic and Applied Basic Research Foundation(No.2020A1515010410)。
文摘Multiple-input multiple-output(MIMO)systems which deploy one-bit DACs are at-tractive in many fields,such as wireless communications and radar.In this paper,the problem of transmit waveform design in MIMO radar system with one-bit DACs is investigated.By appropri-ately designing the transmitted QPSK signal waveforms,the majority of radiated energy can be fo-cused into the mainlobe region(s)by minimizing the integrated sidelobe to mainlobe ratio(ISMR)of beampattern,such that the intensity of backscattered signals from targets can be enhanced.However,the resulting optimization problem which consists of constrained fractional quadratic problem(CFQP)is noconvex.To tackle this problem,a block-sparse semidefinite relaxation meth-od is first utilized to reformulate the CFQP into a reduced convex semidefinite programming(SDP).Further,a customized interior point algorithm(IPA)is developed to solve the small-scale SDP.Finally,the desirable one-bit transmit waveform sequence can be properly synthesized by us-ing Gaussian randomization method.Numerical simulation results demonstrate that the proposed method offer better performance than the state-of-the-art algorithms.
文摘A memory compress algorithm for 12\|bit Arbitrary Waveform Generator (AWG) is presented and optimized. It can compress waveform memory for a sinusoid to 16×13bits with a Spurious Free Dynamic Range (SFDR) 90.7dBc (1/1890 of uncompressed memory at the same SFDR) and to 8×12bits with a SFDR 79dBc. Its hardware cost is six adders and two multipliers. Exploiting this memory compress technique makes it possible to build a high performance AWG on a chip.
